A facility produces lime (CaO) from limestone (CaCO3) using heat. Assume the procedure generates particulate emissions at a rate of 3g/kg of lime produced. Will the facility need to control the emissions of PM? If so, what efficiency is required?

Q: How many grams of chromic sulfide will be formed from 0.718 grams of chromic oxide according to the ...

A:

Q: Steam is condensed at 100°C and the water is cooled to 0 °C and frozen to ice. What is the molar ent...

A: The molar entropy change for the water is to be calculated.

Q: SH

A: Given the structure of the compound is 

Q: Briefly define and explain Pitzer’s correlation.

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If yo...

Q: Calculate the terminal settling velocity of dust particles having a diameter 30x10-6 m falling throu...

A:

Q: The mole fraction of H20 and CO are equal then, the equivalence ratio is: a) 1.15 5) 1.25 c) 1.35 1)...

A:

Q: Q18:-Calculate the work in (hp) required to pumplb of water per minute from 100 psia and80°F tol000 ...

A: Given: m=1 lbmin=0.0166 lbsecP1=100 psia=100 lbfin2T1=80 °FP1=1000 psia=1000 lbfin2T1=100 °Fρ=62.4 l...

Q: QI\Find the volume of nitrogen gas when change heat at temperature 20 C" to 50 C" if that gas contai...

A: Consider the normal pressure and temperature conditions and we also know the volume at this NTP cond...

Q: I need solution please with steps Figure 22 (B) (B) Calculate the enthalpy change for 1 kg of water ...

A:

Q: Q3 Calculate mole fraction for hydrogen gas by electrical hydrolysis at 23 C" if the water pressure ...

A: The ratio of moles of a specific component in the mixture to the total moles of mixture gives the mi...

Q: By fitting the experimental data into Margules model, Perform consistency test with respect to Gibbs...

A: Given data: P, xy diagram, of binary mixture is given,  

Q: . I change my experiment around a bit, so that it will allow me to change the viscosity of the fluid...

A: a)Reynolds number is given as Re=ρuDμ Where ρ- Density of fluid μ- Dynamic viscosity u- Average flu...

Q: ( 42 ) A straight tube having a diameter of 40 mm carries water with a velocity of 10 m/sec. The tem...

A: Given data: Diameter of tube = 40 mm Velocity of water = 10 m/s Temperature of surface of tube = 50 ...

Q: Given the following data, determine the % relative error if the true concentration of NazsO4 is 0.50...

A: Given data: True concentration of Na2SO4= 0.5 M Mass of crucible = 43.2714 g Mass of crucible + BaSO...

Q: Q3: Propane (C3H8) enters a combustion chamber at 200° C at a rate of100 mole/h. The gas is mixed an...

A: Given data: Flow rate of propane = 100 mol/h Temperature of propane = 200 0C Temperature of air = 20...

Q: Q12:- Detergent with a specilic gravity of 0.96 flows from a storage tank to a washing machine by gr...

A:

Q: (a) LPG (liquefied petroleum gas) is commonly used in households. It contains 95% propane (C3H8) and...

A:

Q: Which of the following MNPS (or synthetic analogue) prevent heart disease and stroke? Select one or ...

A:

Q: Calculate the reversible work in (J) required to compress N2 isothermally from the initial condition...

A:

Q: Q27:- Steam at 45 bar and 450°C (specifie volumeV1= 70 liter/Kg, spceific internal energy Ui=300GKJ/...

A:

Q: Why does methane capturing is an important part of POME treatment?

A: Palm oil industry plays a vital role in economy. A part of this waste when getting mix with water be...

Q: Why is hydrotreatment considered as a finishing, not a conversion process?

A: Hydrotreating is of two types: mild hydrotreating and moderate hydrotreating. If we just want to rea...

Q: Problem 4: A Nigerian kerosene has an API gravity of 41.2, aniline point of 55.6°C. Estimate the smo...

A:

Q: One can has your teeth cleaned professionally Problem 3: Continuity. HD 8.13-like using a rotating b...

A: Given data: Exit velocity = 25 m/s Diameter of tip = 0.51 mm

Q: A pure hydrocarbon gas at 30°C and 1.1 bar is burned in a furnace giving a flue gas containing 7.2% ...

A: Given data: Flue gas analysis is, CO2 = 7.2 % CO = 1.8 % O2 = 4 % N2= 87 %

Q: N.

A: It is cyclic No. SP3 conjugated planar: 4n +2  where, n= number of aromatic cyclic = 1   

Q: Another group performed the combustion of sucrose. Determine the AHcombustion (in kJ/mol) of sucrose...

A: Normally, the heat absorbed by the solution is given by specific heat capacity mass and temperature ...

Q: An irreversible process O yields the amount of work less than that of a reversible process O is an i...

A:

Q: The critical velocity ratio for a depth of flow 2.5 m in alluvial channel is 1.25. If the manning's ...

A: Given V0= Critical velocity of water y= Depth of flow  m=Critical velocity ratio

Q: Consider the isothermal gas-phase decomposition reaction: A → B + C. The reaction is to take place a...

A: Given: FAO=0.4 mol/sXA=0.8-rA=0.00125 from given table

Q: Carbon dioxide (CO2) is an important greenhouse gas with a Henry volatility constant of 3.3x 10-4mol...

A:

Q: 21. The entropy of water at 0°C is assumed to be (a) 0 (b) -1 (c) 2 (d) 1

A: The amount of randomness present in a system is known as entropy.

Q: Why is it critical for the ph to be 2 or below. In a lab discussing the effect of pH on food preserv...

A: Microorganisms, including yeasts, molds, and bacteria, are sensitive to a food’s pH. Very low  pH va...

Q: Can you help me solve this? A 25 mL water sample is placed in a dish that weighs 500 g, after evapo...

A:

Q: 2* Resclve the fallowing Conversion factors:- a) 7ogorlo, bl 6o07/s o BTU/h c) 15 00 kg/h kof airto ...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: Explain how the concept of vapor pressures would differ between simple distillation and steam distil...

A: The separation of components in a mixture through their difference in relative boiling points is cal...

Q: Q3: Define half-life time and then show the ability to find reaction order of irreversible reaction(...

A:

Q: How many grams of chromic sulfide will be formed from 0.718 grams of chromi oxide according to the e...

A:

Q: 1. When a system absorbs heat, a part is stored within the system as the energy of internal motions ...

A:

Q: Q2) Consider the following temperature distribution for a rectangular 8, sinh mx + 0, sinh m(L - x) ...

A:

Q: (ii) Two Malaysian crudes, X and Y, are reported with the characteristics in Table 1. Describe the s...

A: The properties of two different crudes are given.  

Q: The strength and hardness of steel increase as carbon content decreases. A Doğru B Yanlış

A: Strength is defirend as  how much load can withstand by a steel before fracture. Hardness provide re...

Q: Q13:- It is desired to dilute a concentrated sulfuric acid solution containing 70 wt% H2SO4 of a rat...

A:

Q: Q4: Calculate W, Q, AU and AH for reversible isothermal compression process of an ideal gas from the...

A:

Q: What rotational speed, in revolutions per minute, would you recommend for a ball mill 1200 mm in dia...

A:

Q: 2. For an irreversible and isothermal process, the change in entropy is А. 1 В. 1 D. 0

A:

Q: A pure hydrocarbon gas at 30°C and 1.1 bar is burned in a furnace giving a flue gas containing 7.2% ...

A:

Q: Example 5: An inclined, circular gate with water on one side as shown in figure. Determine the total...

A:

Q: 4. When 1,000 [bbl] of mud have to be increased from 10 [ppg] to 13 [ppg] mud weight by adding API B...

A: Given data; Initial density of mud = 10 pounds per gallon (ppg) Final density of mud = 13 pounds per...

Q: A certain reaction is first order in A. In 30 min, A decreases from 0.55 to 0.15 mol/L. The time it ...

A: Given t=30 min CA0=0.55moll CA=0.15 moll