A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between two impervious strata. When equilibrium was established, 90 liters of water was pumped Observation wells Ap- Test well me 1, = 6 m Impermeable stratum , = 3 m hz = 2.7 m h, = 2.1 m Confined aquifer Ho = 4 m Impermeable out per hour. The water elevation in an observation well 3.0 m away from the test well was 2.1 m and another 6.0 m away was 2.7 m from the roof level of the impervious stratum of the aquifer. Find the value of k of the soil in m/sec. (

A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between two impervious strata. When equilibrium was established, 90 liters of water was pumped Observation wells Ap- Test well me 1, = 6 m Impermeable stratum , = 3 m hz = 2.7 m h, = 2.1 m Confined aquifer Ho = 4 m Impermeable out per hour. The water elevation in an observation well 3.0 m away from the test well was 2.1 m and another 6.0 m away was 2.7 m from the roof level of the impervious stratum of the aquifer. Find the value of k of the soil in m/sec. (

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A well pumping test was carried out to determine the bulk permeability of a confined aquifer. The aquifer was overlain by a clay layer 4m thick, the depth of the aquifer was 20m, and the initial piezometric level in the aquifer was 2m below ground level. After a period of pumping when steady state conditions had been reached, the following observations were made:pumped flowrate q=1.637 li/swell radius=0.1mdrawdown just outside well = 2mdrawdown in piezometer at 100m distance from well = 0.2m.Determine the bulk permeability of the aquifer in m/s . Use the format for your answer 1.111 x 10^(-4).
) A pumping test carried out in a 50 m thick confined aquifer resulted in a flow rate of 600l/min. The thickness of the impermeable layer above the aquifer is 20 m and the originalwater level in the well was 2 mm below the ground surface (which is also the top of theimpermeable layer). Drawdowns in two observation wells located 50 m and 100 m fromthe well are 3 and 1 m respectively. Calculate:i) The coefficient of permeability of the aquifer, ii) The drawdown in the well, iii) The radius of influence. The diameter of the well is 0.6 m.
A well with a diameter of 18 in. penetrates an unconfined aquifer that is 100ft thick. Two observation well are located at 100 ft and 235 ft from the well, and the measured drawdownsare 22.2ft and 21ft, respectively. Flow is steady and the hydraulic conductivity is 1400 gpd/ft^2. What is the steady-state rate of discharge from the well?
A well 12‐in in diameter penetrates 108 ft below the static water table. After a longperiod of pumping at a rate of 350 gpm, the drawdowns in wells 57 ft and 148 ft from thepumped well were found to be 12 ft and 7.4 ft, respectively.(a) What is the transmissivity of the aquifer?(b) What is the approximate drawdown in the pumped well?
Problem # 2. A pumping test was made in a sand layer extending to a depth of 15m. The initial groundwater table is located 2 m. below the ground surface. Observation wells were sighted at distances 3m and 7.5m from the pumping well. Using a discharge of 0.4 m^3 per hour, a steady level is attained at the pumping well. The measured drawdowns at the two observation wells are 1.5 m and 0.35 m. respectively. a. Find the hydraulic head at the first observation well.b. Find the hydraulic head at the second observation well.c. Compute the coefficient of permeability.
A well with a diameter of 18 in. penetrates an unconfined aquifer that is 100 ft thick. Two observation wells are located at 100 ft and 235 ft from the well, and the measured drawdowns are 22.2 ft and 21 ft, respectively. Flow is steady and the hydraulic conductivity is 1400 gpd/ft 2
A fully penetrating well with diameter of 0.25 m is bored into an unconfined aquifer with hydraulic conductivity of 22 m/d and porosity of 0.3. The water table is initially at a height of 55 m above the bottom of the aquifer. After continuous pumping, a steady state drawdown of 12 m is reached. (a) If the pumping rate has no effect on the water table at a distance of 1.2 km from the pumping well, determine the pumping rate. Determine the drawdown in an observation well 600 m away from the pumping well. Determine the travel time from the observation well to the pumping well.
An artesian well has a diameter of 10 cm. Under steady state condition, what is the expected discharge (lps) if the drawdown is 2.5 m and the radius of influence is 120 m? The aquifer's hydraulic conductivity and thickness are 75/day and 4 m, respectively. Please do not solve wrong , in unsure allow others to do it .
b) A 30-cm well fully penetrates an unconfined aquifer of saturated depth 25 m. When a discharge of 2100 lpm was being pumped for a long time, observation wells at radial distances of 30 m and 90 m indicated drawdown of 5 and 4 m respectively. Estimate the coefficient of permeability and transmissibility of the aquifer. What is the drawdown at the pumping well?
Calculate the discharge from a tubewell of 20-cm diameter penetrating fully intoa confined aquifer of 20-m thick and having a permeability of 40 m/day. Thedrawdown in the well is 3 m and zero drawdown at 300 m from the well.
A pumping test was carried out in a confined aquifer 15m thick overlain by an impermeable layer 30m thick. Rate of pumping was 0.12 m3/s, drawdowns in observation wells located 15m and 30m from the center of the pumping well were 1.60 m and 1.40 m respectively, from the initial groundwater level. The diameter of the pumping well is 0.40m. Determine the coefficient of permeability
Two identical groundwater pumps are operating 4.2 km apart. Each pump well structure has a tube diameter of 90cm. The original water table has an elevation of 60m and the hydraulic conductivity is 32m/day. However, it is maintained that the maximum drawdown (at the tube) is 14 m. The water table will not change at the midpoint between the two pump wells. If the water source is from a confined aquifer with thickness of 5m: A. Determine the drawdown at a point 0.5 km from the pump. B. Determine the discharge of each groundwater pump in m^3/s.