A flue gas analyzed to contain 80.0% nitrogen, 7.00% oxygen, and 13.0% carbon dioxide is sent to a dryer at 500 K and 95 kPa. In the dryer it picks up moisture from the wet material and leaves at 90 kPa and 360 K with the following composition: N2=50%, O2=4.5%, CO2=8.0%, and H20=37.5%. Per 100 m' of gas entering the dryer, determine the following: a) The volume of gas leaving the dryer b) The weight of water evaporated

Q: A Simple Rankine cyele works heturenpressure 3400 kpa.and baahpa,the initial conelifion of Steam bei...

A:

Q: 3. The irreversible first order liquid phase reaction A »R is to be carried out in an insulated mixe...

A:

Q: Pure CO2 may be prepared by treating limestone with aqueous sulfuric acid. The limestone used contai...

A: This is system follows law of conservation of mass. Consider the basis of residue and obtain the mas...

Q: In a gas mixture there are 0.0083 lb mol of water vapor per lb mol of dry CH, at a temperature of 80...

A: The vapor pressure is obtained from steam tables for different temperatures. The total pressure is o...

Q: A physics experiment is conducted at a pressure of 14.0 kPa. What is this pressure in mmHg?

A:

Q: A simple Rankine cycle works betw een pressures 64 bar and 10 Kpa, the initial condition of steam be...

A: Given data  P1= 64 bar = 6400 Kpa P2 = 10 Kpa = 0.1 bar  (Use steam table , P in bar)

Q: Homework Submit to Ziqi Li before Nov 23, 2021 •In a study of sorption of arsenate and sulfate onto ...

A:

Q: b) In the ferrite process for the manufacture of caustic soda, soda ash and gangue from pyrites roas...

A: GIVEN:  △HfO for Na2OFe2O3 = -1412.2 KJ/mol we know that,  Standard Enthalpy of Formation  (△HfO ) △...

Q: QUESTION 6 Some hypothetical metal has simple cubic crystal structure. If its atomic weight is 62.28...

A:

Q: The vapor pressure of component A is 300.3 torr, and that of component B is 70 torr at 35 °C. A Solu...

A:

Q: PART 1. Classify each reaction as addition, elimination, and substitution. A) CH3CH2B1 LİOH CH3CH2OH...

A:

Q: A cylinder of 0.25m diameter and 1.2m height is fixed centrally on the top of large cylinder of 0.9m...

A: Let us see what data is given : Diameter of the cylinder  =  0.25 m Height of the cylinder  =  1.2 m...

Q: A small storage room has the dimensions of 20 m X 20m X 3m high. The walls of the storage consist of...

A: Given: Room dimensions are 20m×20m×3m Wall layers: Drywall (thickness=0.5inch, k=0.5W/mK) Fiberglass...

Q: Calculate the total heat required to raise the temperature of 1 kg of tin from 30C to 300C.  Tin r...

A: Given that: Mass of tin = 1 kg = 1000 g Initial temperature, T1 = 30⁰C = 303 K Final temperature, T2...

Q: A simple Rankine cycle works betw een pressures 57 bar and 10 Kpa, the initial condition of steam be...

A: Given:  For Rankine Cycle P1 = P2 = 57 Bar  P3 = P4 = 0.1 Bar  = 10 Kpa From Steam Table,  At P1 = P...

Q: Write the sequence of steps in the processing Plant of Ain Zaleh wet e oil to be ready for refining.

A: Basically there are series of steps in crude refining process  First is pretreatment to remove salt ...

Q: Enter your answer in the provided box. Calculate the molality of a 4.21 M ethanol (C₂H5OH) solution...

A:

Q: You are learning Russia {passiv}

A: The given statement is to be converted into a passive form.

Q: O1. A belt moves upward at velocity Vo, dragging a film of viscous liquid of thickness h, as in Fig....

A: Given-Q1 A belt moves upward Velocity =V0 Dragging a film of viscous liquid Thickness = h Other ...

Q: The feed to the reactor contains 7.8 mole % C*H_{4} 72.8% N_{2} and 19.4% O_{2} . The gas leaving th...

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: For the binary mixture of benzene (1) and acetonitrile (2), the following vapor-liquid balance data ...

A: Given 1-Benzene 2-Acetonitrile Vapor-liquid balance data at 45℃ is P(bar) x1 y1 0.2778 ...

Q: 4.4 Calculate the difference in slope of the chemical potential against temperature on either side o...

A: The difference in slope of the chemical potential against temperature on either side of (a) the norm...

Q: A 10 mL sample of H2SO4 solution required 16.85 mL of NaOH solution in a titration. Each mL of the N...

A: Frist we will calculate the volume of solution sodium hydroxide. We will calculate the moles of the ...

Q: A coal fired in a furnace analyzes 16.6% VCM, 16% ash, 61.4% FC, 6% M, 1.2% N and 1.8% S with a calo...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: Chemical Engineering Question

A: Black is the absence of light. When there is no light, everything is black. Test this out by going i...

Q: Indicate whether the following systems described by the transfer function Y'(s) = G(s)U'(s) are stab...

A: Note: As per our guidelines, we are supposed to answer only 3 sub-parts questions. Please send the r...

Q: Two cubical castings of the same metal and sizes of 2 cm side and 4 cm side are moulded in green san...

A: The time required to solidify the large casting is to be determined.

Q: Mention at least three main differences between TBP distillation and ASTM distillation method?

A: Distillation is a separation process in which the light hydrocarbons are separated from heavy hydroc...

Q: What volume of 1.24 N CACO3 solution contains 108.7 grams of CaCO3?

A: Given: Normality is 1.24 Amount of CaCO3 is 108.7 grams   

Q: Employing the Kammerlingh Onnes equation of state, find the compressibility factors of CO at -500C a...

A: Given that  CO substance  T =-50 C  We have to find Z at different pressure 

Q: A simple Rankine cyele works befween pressures 3100 hfa aneb looo kpa, the initial condifion of Stea...

A:

Q: A schematic flow sheet of a process is shown in figure below. The following table gives the composit...

A: Given flow sheet Composition table  In stream N ,A=75% of total A present in Stream M F/P=5/3 Fi...

Q: 3. The irreversible first order liquid phase reaction A »R is to be carried out in an insulated mixe...

A:

Q: Example 2.8 Calculate the internal energy and enthalpy changes resulting if air changes from an ini-...

A:

Q: 1. The following undergoes simultaneous heat and mass transfer operations except: a.Humidification ...

A: Hello Subscriber! There are multiple questions posted. As per our policy, we have solved the first o...

Q: Q1/ A Petroleum cut has the following ASTM D86 distillation data:- Volume% distilled Temperature "C ...

A: given to calculate watson constant K K=(MeABP)13SGMeABP=VABP-∆VABP=T10+T30+T50+T70+T905

Q: Example 2.14 Water at 90°C is pumped from a storage tank at a rate of 3 Ls1. The motor for the pump ...

A: Given T1=90℃ Flow rate m =3L/s W=1.5kJ/s Q=670kJ/s h= 15m Find Temperature of water delivered to t...

Q: A simple Rankine cycle works betw een pressures 64 bar and 10 Kpa, the initial condition of steam be...

A: Given data  Pressure (P1) = 64 bar  Pressure (P2) = 10 Kpa = 0.1 bar

Q: c) Describe the difference between the gate valve and globe valve d) Give some examples of smart mat...

A: c)  Gate valves are used for On-Off manipulate whereas Globe valves in addition can additionally be ...

Q: Q.3 a). A tensile stress is to be applied along the long axis of a cylindrical brass rod that has a ...

A: The magnitude of load is to be calculated.

Q: 5.15(a) Substances A and B are both volatile liquids with pÅ= 300 Torr, PÅ= 250 Torr, and K = 200 To...

A: The concentration of a solution or a mixture can be expressed in different ways. Molality and mole f...

Q: 17. In a combustion device, propane (C3H3) burns with oxidizer (0.2502 + 0.75CO2) on mole basis at s...

A: The combustion of any species gives us carbon dioxide and water. If excess oxygen is supplied the re...

Q: A solution containing 10% NaCl, 3% KCl and 87 % water is fed to the process shown in the following f...

A: Apply mass balance on the system or corresponding individual unit to obtain unknowns. Apply composit...

Q: a. What are the effects of the presence for sulfur compounds in crude oil?

A:

Q: Calculate the molarity of a solution containing 211 grams of NaCl in 1263 ml of solution? (Atomic ma...

A: Given data: Mass of NaCl= 211 g Volume of solution= 1263 ml                             = 1.263L Ato...

Q: Two cubical castings of the same metal and sizes of 2 cm side and 4 cm side are moulded in green san...

A: The time to solidify the large casting is to be determined.

Q: Will dew (liquid water) form at 25°C if PH.O is 3210 Pa? Provide a brief explanation justifying your...

A: Given that, Temperature T = 25oC = 298 K The partial pressure of water pH2O = 3210 Pa The saturation...

Q: The Sohar Refinery Company was set up in 2003 to construct, commission and operate a new grass roots...

A: Given Refinery feed stock=10115mol/hr Simple figure is Find Complete distillate and bottom analysis...

Q: 5. The combustion gases from an industrial furnace using a hydrocarbon fuel and dry air enter the st...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: A petroleum cut has the following TBP Distillation data: Volume % distillate 0 10 30 Temperature °c ...

A: A petroleum cut has the following TBP Distillation data  Vol% Temp℃ 0 71 10 85 ...