A Flyback converter (for questions 1-3) shown below has the following parameters. Vin-100v, Vo-20V,Po-ioW, D-025, Fsw-250kHz4. The magnetizing inductor at the primary side winding is 100uH, what is the peak current in the powerswitch?A. 1.8AB. 1.6AC. 2.1AD. None of the above

Given Vin =100VVo =20VPo =40WD =0.25 Fsw =250 KHzL =100 μH

A Flyback converter (for questions 1-3) shown below has the following parameters. Via-100V, Vo-20v, Po-dow, D-025, F-25ote 4 The magnetiring inductor at the primary side winding is 100ul, what is the peak current in the power witch? A LRA B LA C.2.1A D. None of the abeve

A Flyback converter (for questions 1-3) shown below has the following parameters. Via-100V, Vo-20v, Po-dow, D-025, F-25ote 4 The magnetiring inductor at the primary side winding is 100ul, what is the peak current in the power witch? A LRA B LA C.2.1A D. None of the abeve

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Related questions

Q: The 3-phase wound-rotor induction motor has .... . a) high starting torque b) low starting current…

A: In this question , we will write induction motor starting related questions..

Q: The function of Copper shading band in induction type energy meter is to ensure flux produced by…

A: One of the two coils in energy meter is potential coil called shunt magnet and copper shading bands…

Q: E-06, PC-05. Why are the iron cores of most induction coils laminated? O To increase the core…

A: core are laminated to tranfer efficient power from primary coil to secondary coil.

Q: 4. Generator is said to be a. series field aids the shunt field c. the commutation device is used…

A: A compound generator has two field windings I.e series field winding and shunt field winding .…

Q: The generator convert from PV to PQ if the active power of the generator exceed the * maxinum and…

A: In this question , we will find when PV bus changes to PQ bus.. Note:- I will give answer of 1st…

Q: 4- An induction Motor is a) Self-starting with high torque c) Self-starting with low torque 5- In…

A: (4) Starting of induction motor: Because each phase's winding displacement is 120 degrees, and the…

Q: Q-From the figure below, select the capital letter representing the external load characteristics of…

A: For shunt generator we almost flat curve their is very ohmic drop so we get curve below closes to no…

Q: onous reactar transformers are operating in parallel, they will share the load as ous motor is…

A: In this question we will write about synchronous machine related answers.....

Q: - Inter pole winding is connected in

A: Inter pole produces a counter emf to nullify reactance voltage.

Q: A Flyback converter (for questions 1-3) shown below has the following parameters. Vin=100V, Vo=20V,…

Q: 2. In an induction motor, no-load the slip is generally.....

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: What is the winding configuration of the primary? What is the winding configuration of the…

A: Transformer is an electrical device used for stepping up or stepping down the voltages. The…

Q: 1. The rotor is separated from the stator by a small air gap that range from depending on the power…

A: In this question, Choose the correct option 1. What is range of air gap between stator and rotor in…

Q: What is the Shunt de generator and Draw equivalent circuit?

A: In DC generator field current is needed to excitation. DC field current excited separately through…

Q: A G.E. potential relay with the number 3ARR3-D4F6 would have a continuous coil voltage of ?

A: According to the question we have to find the value of continuous voltage.

Q: A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance…

A: Rsh = 200 Rse = 1 ohm Ia = 10 A

Q: 5. Two shunt generators A and B operate in parallel and their load characteristics may be taken as…

Q: Complete the blank In AC-DC power transmission system,…

Q: Q-From the figure below, select the capital letter representing the external load * :characteristics…

A: For DC series Genrator the curve is rising . For DC differential compund genrator curve is above no…

Q: 8. Name of the DC generator part is used to connect the Armature winding to the external circuit…

A: to find Name of the DC generator part is used to connect the Armature winding to the external…

Q: A three-phase, four-pole, 415-V,

A: This question is solved by drawing equivalent circuit of the generator.

Q: A shunt DC generator has no load terminal voltage of 140V. Armature resistance is 1ohm and shunt…

Q: In a 4 pole, 20 kW, 200 V wave wound DC shunt generator, the current in each parallel path will be

Q: ----- In d.c. generators armature reaction is produced by armature current O none of the mentioned O…

Q: Three ideal CTS with turns ratios of 600 : 5 configuration as shown in Figure 3 21a and b

A: Since the CTs are connected in star-delta configuration, so there is a phase difference of 30°…

Q: amature windings commonly used in DC machines a DC shunt generator are wound with a large numbe C…

A: 3. In Dc generator brushes are used to convertalterating current (ac) which is armature wlndingsto…

Q: 16 test which do to find the value of stater winding losses (Rs) in * synchronous generator DC test…

A: To find the stator winding losses in the synchronous generator can be found by using the DC…

Q: Which of the following is the rotor fault of alternator? Phase to earth Over current Inter turn Non…

A: Choose the correct option Which of the following is the rotor fault of alternator?

Q: Three Phase Induction Motor Load Test, . At what load will the efficiency be maximum

A: The answer as given below:

Q: The dc generator fixed with commutator to __________. increase the field change the speed convert…

A: In this we will write about commutator use..

Q: (Please help with 2 impacts per type not less thank 60 words. Thx.) In your own idea using various…

A: Consider the diagram for the capacitor run and capacitor start motor.

Q: A short-shunt compound generator supplies a load of 10kW at 200V through a pair of feeder resistance…

Q: The compensating winding operation aid the commutating winding operation True False

A: Compensating windings are used to overcome the commutation and cross-magnetization effect of…

Q: 1. Calculate the flux per pole required on full load for a 50KW, 400V, 8 pole, 600 rpm dc shunt…

Q: hat are the differences in terms of construction and working principle between shaded pole induction…

A: The working guideline and development of Capacitor turn over inductor engines and capacitor start…

Q: H.W: Write a short report about using internet of things (loT) in speed control of a three- phase…

A: To control and screen the speed of the three-stage enlistment engine by utilizing the Arduino and…

Q: 9. With the loading-back method of testing induction machines, the load can be changed by adjusting…

A: The load test on induction motor is performed to compute performance that is torque, slip,…

Q: A Flyback converter (for questions 1-3) shown below has the following parameters. Vin-100V, Vo-20v,…

A: The flyback converter is shown below: The output voltage is given by the expression as shown…

Q: A 100kW generator, 250V, 6 poles have a wave wound armature with 300 turns then the number of…

A: In this question we have to find out compensating winding turns per pole.

Q: the rheostat were connected in series with the shunt f winding and the combination placed across a…

A: A self-excited DC shunt motor, also known as a shunt wound DC motor, is a form of self-excited DC…

Q: For a four pole, 16 slot armature with two coil-side/slot having wave connected progressive winding…

A: Given: Number of poles, P=4 Armature slots, S=16 Two coil-side/slots Wave connected progressive…

Q: How is : 1-gate- turn-off thyristors turned on and off? 2-phase- control thyristors turned on and…

A: GTO's or gate turn off thyristor are fully controllable 3 terminal semiconductor switch. It can be…

Q: Complete the wiring diagrams as per Worksheets 3-A and 3-B then solve for A through N for DC…

Q: A 4-pole, simplex lap wound armature contains 16 slots and has two coil sides per slot, Find back…

A: We have been given a simplex lap wound armature which contains, Pole (P) = 4 Slots = 16 Coil sides…

Q: Mention three (3) reasons for arcing at the commutator. 2.

A: Carbon brushes at the commutator are the main cause of arcing or sparking. The reasons for arcing at…

Q: A single-phase fully-controlled converter is connected to a 240 V supply. Plot the d.c. generator…

A: We have given the following problem

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 4-pole induction motor (main) and a 6-pole motor (auxiliary) are connected in cumulative cascade. Frequency in the secondary winding of the auxiliary motor is observed to be 1 Hz. For a supply frequency of 50 Hz the speed of the cascade set is ?
5a) With the aid of power-load angle curves explain in detail the following: an electronic governor’s response to frequency changes resulting from changing loads. b) A circuit breaker’s response when a transient fault occurs c). the response of an automatic voltage regulator to voltage dip as the result of the start-up of a high rated induction motor.
1) analyse the resone behind the positive and negative tourqes produced by three phase syncronous motor. 2) derive the output voltage of the VSI used in three phase induction motore when switches S1 and S6 are turned on and draw the waves form the crossponding gate pules and output voltage that results.
Q7: Which of the following is a correct combination of load and MCB rating? Five numbers of ordinary sockets of 13A, grouped in parallel: [6A, SP MCB] Nine numbers of light/fan grouped in parallel: [20A, SP, MCB] A 2-kW air conditioner: [20A, SP, MCB] A three phase motor of 4 KW: [20A, SP MCB]
Draw the No Load characteristic From run (1) and calculate RF, show different lines of shunt field resistance winding?
In a three phase induction motor, voltage between the slip rings at standstill is 50 V. At full load the slip is 0.04. What is the voltage between the slip rings at full load?
A three phase induction motor is wound for 8 poles and is supplied from 50Hz system. Calculate the synchronous speed and speed of the motor when slip is 6% What are the advantages of squirrel cage induction motor over motor? write any four advantages
IN Counter-Current Breaking o f a 3-Phase Induction Motor(Reversing the Operation o f a 3-Phase Induction Motor) How it was insured in the control circuit as to avoid the operation of both positiveand negative sequences simultaneously?
A G.E. potential relay with the number 3ARR3-D4F6 would have a continuous coil voltage of ?
A freewheeling DC motor is driven with 1000 rpm and a nominal load torque of 80Nm. The field circuit resistance is 200 and the armature circuit resistance is 0.2 O. The field coils are fed with a zero degree transmission angle through a single-phase fully controlled converter connected to a single-phase 240V source. The armature circuit is fed from a single phase 400V source through another fully controlled converter. Magnetic saturation has been neglected, the motor constant is given as 0.8 V - s / A - rad. Assuming that there is no fluctuation in armature and field current, find the control angle of the converter feeding the armature at nominal load. If you want to leave the question blank, click again on the option you marked.
a capacitor for a capacitor-start copacitor-run motor is connected in _____ with the windings to provide a continuous leading current in the start windings.
1-why the slipoccur in the induction motor? 2- why the slip is less than 1? 3-what the adrantage of study the slip in the induction motor?