a) For a liquid transformer oil system, the oil has relative dielectric constant ɛ = 3.35, density p = 2.59 g/cm3 and ionic mobility u = 3.62 x10-5 cm2/V-s. If the applied voltage is 680 V and the o container's top to bottom plate distance d = 2.45 cm, find the electro convection coefficient M b) If ɛ /p is now changed to 1.33 and V,/d is changed to 278.5, what is the new uM product value? Compared to 1 (a), has the uM product for 1 (b) increased or decreased?

a) For a liquid transformer oil system, the oil has relative dielectric constant ɛ = 3.35, density p = 2.59 g/cm3 and ionic mobility u = 3.62 x10-5 cm2/V-s. If the applied voltage is 680 V and the o container's top to bottom plate distance d = 2.45 cm, find the electro convection coefficient M b) If ɛ /p is now changed to 1.33 and V,/d is changed to 278.5, what is the new uM product value? Compared to 1 (a), has the uM product for 1 (b) increased or decreased?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For a transformer oil system, if the insulation through which oil flows has a higher thickness,comment whether you will choose higher dielectric permittivity or lower dielectric permittivity todecrease the electro convection coefficient M ?
Assume that a single-conductor belted cable has a conductor diameterof 0.681 in., inside diameter of sheath of 1.7025 in., and a length of8000 ft. The cable is to be operated at 12.47 kV. The dielectricconstant is 4.5, and the power factor of the dielectric at a ratedfrequency and temperature is 0.05. Calculate the following:(a) Capacitance of cable.(b) Charging current.(c) Dielectric loss of cable.(d) Equivalent resistance of insulation.
A solid cylindrical aluminum conductor 25 km long has an area of 336,400 circular mils. Obtain the conductor resistance at 20C and 50C. Find the AC resistance per Km of the cable at 50C. Assume a skin-effect correction factor of 1.02 at 50 Hz. The resistivity of aluminum at 20C is 2.8x10-8 Ωm
) A conductor moves with a velocity of 15 m/s at an angle of (a) 90◦, (b) 60◦ and (c) 30◦ to a magnetic field produced between two square-faced poles of side length 2 cm. If the flux leaving a pole face is 5 μWb, find the magnitude of the induced e.m.f. in each case. (b) Determine the delta-connected equivalent network for the star-connected impedances shown in
An RG 58 Coaxial Cable, having an inner diameter of 0.5 mm and using an insulator with dielectric constant of 2.7, the characteristic impedance of a cable is 90 ohms. Compute for the outer conductor diameter in mm. Answer
Derive the expression for the motional and transformer emf. Calculate the maximum emf induced in a coil of 500 turns of radius 10 cm rotating at 30 rps in a magnetic field of 250 wb/m^2
ı know answer but how? z=2, p=1,n=1 and system is unstable
Q4. A Transmission Line has a span of 250 meters between two level supports. The conductor has a cross-sectional area of 1.29 cm2, weighs 1170 kg/km and has a breaking stress of 4218 kg/cm2. Calculate the sag for a safety factor of (5), allowing a wind pressure of 122 kg per square meter of projected area. What is the vertical sag?
A transmission line has a span of 150 m between level supports. The conductor has a cross-sectional area of 8 cm^2. The ultimate strength is 5000 kg/cm2. The specific gravity of the material is 8.9 gm/cm3. If the wind pressure is 1.5 kg/m length of the conductor, calculate the sag if factor of safety is 5.
For a transformer oil system, if the insulation through which oil flows has a lower thickness, comment whether you will choose lighter oil or denser oil to increase the electro convection coefficient M?
Two power lines, line 1 and line 2, both of length LL = 62 m, are strung east-west between two towers. line 1 is r12 = 2.8 m directly above line 2. The current in both power lines is IL = 75 A to the west. Assume the power lines are straight and you can use the approximation r12 << LL. Part (a) Find the magnitude of the magnetic field B21, in teslas, produced by line 1 at line 2. Part (b) What is the direction of the magnetic field produced by line 1 at line 2? 1. Up. 2. East. 3. South. 4. Down. 5. North. 6. West. Part (c) Calculate the magnitude of the magnetic force F21, in newtons, that the current in line 1 exerts on line 2. Part (d) Assume a typical power line has a mass of 890 kg per 1000 m. How many times larger would the current in both lines have to be for the magnetic force on the line to balance the force of gravity?
It is viewed from the cross-section of a coaxial cable consisting of a cylindrical conductive tube with an internal radius R and an outer radius of Rz wrapped around a cylindrical conductive wire with a RADIUS of R. r to indicate the radial distance from the center, the inner cylindrical conductor,if it is j1 = Gr and the outer conductive tube, j2 = Car has improper current densities. Here, the two conductors carry the same I flow in zit directions. What is the size of the B2 magnetic fields at r=1 cm and B2 at r= 8 cm?(R=4 cm; R=7 cm, R3=9 cm; Io=2 A; uo=47.10-7 T.m/A and our aquani-positive forehead outward from the page plane).