A force of 500 N is applied to the end of the cord Block A weighs that is attached to block A of Fig. 2000 N, and block B weighs 4000 N. The coefficient of friction between the blocks is 0.30, and the coefficient of friction between B and the floor is 0.20. Determine The maximum force P for which the system is in equi- librium. 500 N 30° B P

A force of 500 N is applied to the end of the cord Block A weighs that is attached to block A of Fig. 2000 N, and block B weighs 4000 N. The coefficient of friction between the blocks is 0.30, and the coefficient of friction between B and the floor is 0.20. Determine The maximum force P for which the system is in equi- librium. 500 N 30° B P

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.3P: Two identical chairs, each weighing 14 lb, are stacked as shown. The center of gravity of each chair...

See similar textbooks

Similar questions

Calculate the horizontal force P required to push the 85-lb lawn mower at constant speed. The center of gravity of the mower is at G, and the coefficients of rolling resistance are 0.12 for the front wheels and 0.18 for the rear wheels.
The spring attached to the homogenous bar of weight W is undeformed when =0. Determine the smallest spring stiffness k for which the =0 equilibrium position will be stable. Use W = 10 lb, a = 24 in., and b = 6 in. Assume that the spring remains horizontal, which is a valid approximation if is small.
The figure shows a steel bar being processed by a rolling mill. Given that P=80kN and r =0.016, determine the force F required to advance the bar at a constant speed.
. The small piston of a hydraulic lift (g. 1) has a cross-sectional area of 3.00cm2, and its large piston has a cross-sectional area of 200cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0kN?
A 2-m long concrete traffic barrier is used to provide safety for workers, pedestrians, and motorists during highway construction. The concrete has 0.024 N/cm3 specific weight. The interface between the barrier and pavement has static and kinetic coefficients of friction of 0.45 and 0.4, respectively, and h= 45 cm. Determine the force P that will cause motion of the barrier.
The small piston of a hydraulic lift has a cross-sectional area of 3.00cm^2,and its large piston has a cross-sectional area of 200cm^2.What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg= 15.0kN?
A ball of mass mand radius Rrests at the edge of a step barrier of height has shown in thefigure. There is a horizontal force Tapplied to the ball from its top through a string wrapped around the ball to lift it above the barrier as shown in the figure. What is the minimum tension required to begin to lift the ball off the ground? (g = 9.8 m/s2, m = 1 kg, R = 0.5 m, h = 0.2 m).
A block that has a weight Wa = 100 N is placed on a rough inclined plane, as shown in the figure. Block A is attached to block B by means of a flexible, inextensible cable with a non-compressible mass, which passes through a smooth pulley with a non-compressible mass; for such conditions determine the interval of values of the weight Wb for which the system will remain in equilibrium. Consider mE = 0.25
Box A weighs 1000N and has a height of H1=3m and width W1=2m. Box B weighs 800N. the static friction coefficient between the boxes is uA=0.7 and the static friction coefficient between box B and the ramp is uB=0.5. Find the max allowable angle for the following instances where no motion occurs, box A and B remain stationary. 1) Box A slides, Box B remains stationary 2) Box A tips, Box B remains stationary 3) Box B slides, Box A remains stationary on block B
A straight pole of length l = 7 ft and weight W = 25 lbf leans against the corner of a wall of height h = 5 ft as shown. A rope at the bottom prevents the pole from sliding. All surfaces are smooth (no friction). Determine the force F in the rope that produces static equilibrium.
A 8.0 m long ladder AB leans against a smooth wall making an angle of 70º with the floor. The ladder is uniform and has a mass of 40.0 kg.(a) Determine the forces exerted on the ladder by the floor and the wall (i.e. at A and B respectively).(b) Determine the minimum value of the coefficient of static friction to prevent the ladder from slipping.
. A 25-kg ladder, 4 m long, rests on a rough floor and against a vertical wall. The ladder makes an angle of 350 with the horizontal as shown. It starts to slip when a man weighing 75 kg has climbed halfway up. If f = 0.20 at the wall, find the coefficient of friction (µf) at the floor.