Answered: A forced air system takes return air at…

A forced air system takes return air at 62 degrees Fahrenheit (°F). It heats theair 59°F. What is the temperature of the heated air blown out to the room?

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter8: Direct Use Of Solar Energy

Section: Chapter Questions

Problem 17P

See similar textbooks

Related questions

Q: minutes later the thermometer reading is 15°C. Determine the temperature reading 5 minutes after the…

Q: ospheric pressure is about 1.00×10° Pa on average. vert the downward force of the air on a desktop…

A: Given that Atmospheric pressure P = 1 * 10^5 Pa Surface area A = 2.1 m2 Force F = ?

Q: 17-A refrigerator is to remove heat from the cooled space at a rate of 300 kJ/min to maintain its…

A: Let us estimate the Input power required by the refrigerator.

Q: A pipe 40 cm in diameter contains steam at 100°C and is covered with asbestos (K = 0.0006…

Q: piston to move outward by 8.00 cm. If the remains at a pressure of 140 kPa for this process, t is…

A: According to given data When a certain quantity of helium gas contained inside and engine cylinder…

Q: In a condenser containing air and water, the air pressure is 22.1 kPa absolute. What is the gage…

A: given that pressure at absolute Pabs=22.1 KPaThe pressure at a point 2.09 m below 1 ltr water…

Q: A well-insulated and perfectly sealed room is installed with 4-hp fan to circulate air for 1.5…

Q: 2. A cup of tea is prepared in a preheated cup with hot water so that the temperature of both the…

A: Answer: a. The temperature of the tea after 6 minutes is 106o F. b. The time required for the tea to…

Q: The air in a certain room 150’ x 50’ x 12’ tested 0.2% CO2. Fresh air containing 0.05% CO2 was then…

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

Q: 50 m length of tape is of standard length at temperature of 50.76°C. What would be the error in the…

Q: At the start of compression in an air standard Otto cycle with a compression ratio of 10, air is at…

A: It is required to determine the Otto cycle thermal efficiency. ηth, Otto=1-1rck-1×100 Here rc is the…

Q: A heat pump supplies heat energy to a house at the rate of 140,000 kJ/h when the house is maintained…

A: It is required to determine the maximum Coefficient Of Performance for air. We know that, 0oC = 273…

Q: Water flows through a 4-in steel pipe (k=16 W/m-K) wrapped with a layer of 5-cm thick insulation…

A: Determine the value of heat flow through the pipe if the water is at 80℃ and air outside is at 20℃…

Q: *1-8. The bottle tank has a volume of 1.12 m³ and contains oxygen at an absolute pressure of 12 MPa…

Q: A glass of a hot water has an initial temperature 80°C, placed in a room where the temperature is…

A: The given data is shown below: Initial temperature=80°CRoom temperature=30°C

Q: A classroom that normally contains 40 people is to be air-conditioned with window air-conditioning…

A: Given: The total number of people in the classroom is 40. The cooling capacity of window…

Q: Precipitation requires lifting of air mass so that it warms and condenses. O True O False Next

A: This statement is true

Q: Determine the number of fins and overall fin efficiency using Figure 2.7. (c) Determine the total…

Q: ntly), but with 10 kg of air at 800 kPa, heated at constante pressure up to 400°C. Use the values…

Q: 2.21 The difference between the air and the inside wall temperature in a room is 10°F (5.5°C). What…

A: Given Data: The difference between the air and inside wall temperature is ΔT=5.5°C The height of the…

Q: How can a gas-fired warm-air furance be used to cool a building

A: Gas-fired warm air furnace- In this, they have a burner in the furnace filled with natural gas. A…

Q: Precipitation requires lifting of air mass so that it warms and condenses. O True O False

A: Precipitation occurs only when there is some mechanism to cool the atmospheric air to bring it to…

Q: The measured distance from A to B was 300.0m. The tape used has a standard length of 30m, at 20 °C…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In an air standard Otto cycle the maximum and minimum temperature are 1400 C and 15 C .the heat…

A: Solution: Considering the Diagram: Given Data: T1=Min temp=15°C=288 KT3=Max temp=1400°C=1673…

Q: On a hot summer day, the flat roof of a tall building reaches 50° C in temperature. The area of the…

A: The rate of heat energy radiation (R) Joule/sec/m2 or watt/m2 Depends upon certain parameters, they…

Q: calculate the heat loss through the ceiling, if the R-19 insulation batt is replaced by R-40…

A: To find:- heat loss through ceiling if R-19 insulation batt is replaced by R-40 fiberglass…

Q: Calculate the amount of energy required in BTU to heat the air in a 10°F house 30 by 50 by 40 ft and…

A: Specific heat of air(Cp) =0.241 BTU/lb oF Density of air=0.0844lb/ft3

Q: D

A: The gas inside the pressure vessel have the property to change the volume and pressure. And the…

Q: Determine which of the following answers is the heat flow across the plane wall

A: Given thermal conductivity k = 8.45W/m °C Temperatures T1= 65 °C , T2 = 35 °C Surface area A = 10…

Q: Convert the temperature of scalding water, 54 °C, into degrees Fahrenheit and kelvin.

A: Given that Scalding water (t) = 54°cwe need to °c convert into Fahrenheit and Kelvin(i) oc to…

Q: The inside temperature of an oven is maintained at 230° C while the kitchen air temperature is 25° C…

A: The measure of hotness or coolness of a body is characterized as temperature. It is expressed in…

Q: 100°? air flows through a round aluminum tube of ID 60mm and OD 80mm at 4 ?? .The tube is covered in…

A: Take 25 °C as room temperature r1=30 mmr2 = 40 mmr3 = 45 mm Assume unit length of the tube Thermal…

Q: A 200 ft. steel pipe is heated (by filling it with steam) from 40 °F to 240 °F. Given a linear…

A: given: length(l)=200ft temperature increases from 40∘F to 240∘F α=6.5×10-6 per degree Fahrenheit

Q: When the temperature was 3 deg. C, the distance from E to F was measured using a steel tape that has…

Q: midnight, with the temperature inside your house at 70°F and mperature outside at 20°F, your furnace…

A: To find time at which temperature will reach 40oF

Q: A line was measured with a 50-m tape which was found to be 532.28 m. the tape is known to be of…

Q: 10. When is air assumed to be incompressible? a) At low speed b) At high speed c) Independent of its…

A: Option (a) is correct At low speeds the air is assumed to be incompressible. At Mach number value…

Q: An insulated steam pipe having outside diameter of 3 cm is to be covered with two layers of…

A: Given data D1=30 mmD2=30+25=55 mmD3=30+25+25=80 mm So there will be two cases Case 1 Case 2 k…

Q: A closed cylinder having a volume of 3 m² contains 0.03 m³ of saturated liquid water and 2.97 m of…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: hat temperature will the steam be just dry and saturated?

A: Given data m=0.05kg P=1.5MPa=15bar volume of 0.0076 m3

Concept explainers

Thermal Processes

Some of the key areas where thermal processes find their application are:

Question

A forced air system takes return air at 62 degrees Fahrenheit (°F). It heats the
air 59°F. What is the temperature of the heated air blown out to the room?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

100°? air flows through a round aluminum tube of ID 60mm and OD 80mm at 4 ?? .The tube is covered in 5mm thick fiberglass insulation. The tube is surrounded by RT air flowing at 5?? over the outside of the insulation. What is the heat rate through the wall of the tube? Assume that the air temperature is constant throughout the tube. Note: RT is 25 celsius
An electrical current flows through a long bar, generating thermal energy at a rate uniform volumetric of q = 2 × 105 W/m 3. The bar is concentric with a hollow ceramic cylinder, creating an air-filled space between the two. If the external surface temperature cannot exceed 40 °C, what is the minimum speed that the ambient air should be blown? the neighborhood meets at 25 °C and the emissivity of the ceramic is 0.8. If the bar has an emissivity of 0.2, what is the bar surface temperature?
How can a gas-fired warm-air furance be used to cool a building?
Compute the pressure heat at m, in feet of fluid A, indicated by open manometer in figure 2 below when (a) Fluid A is oil (sp gr 0.851), the gage liquid is carbon tetrachloride (sp gr 1.51), y=30.15 in, z=3051 in. (b) Fluid A is molasses (sp.gr 1.50), gage liquid is water, y=3.51 ft, z=1.15 ft
Calculate the heat loss from a double-pane glass window consisting of two pieces of glass, each having a thickness of 10 mm with a thermal conductivity of k = 1.3 W/m.K . The two glass panes are separated by an air gap of 7 mm. Assume thermal conductivity of air to be k = 0.022 W/m.K .
A room 3.6m x 5m x 8m fully replaces inside air after 3 hours. If the temperature from the outside is 80 F and temperature inside is 60F. Determine the ventilation heat load in Watts. subject Engineering utilities 2
What are the main disadvantages of using a heat exchanger to cool the exhaust gases?
A glass of a hot water has an initial temperature 80°C, placed in a room where the temperature is 30°C. After one minute the water temperature drops to 70°C. What will be the temperature after 3 minutes? At what time the water cools down to 40°C?
A 10m dia. Cylindrical tank has a height of 5m and is full of water at 20ºC (unit weight of water=9.789kN/m3). If the water is heated to a temperature of 50ºC (unit weight of water=9.689kN/m3 ). a. Compute the weight of water. b. What is the final volume when heated to a temp. Of 50ºC? c. Determine the volume of water that will spill over the edge of the tank.
Compute the pressure heat a m, in feet of fluid A, indicated by open manometer in figure below when; (a) Fluid is oil (sp gr 0.895), the gage liquid is carbon tetrachloride (sp gr 1.95), y = 30.75 inch, z = 30.95 in(b) Fluid A is molasses (sp gr) 1.50), the gage liquid is water, y = 3.95ft, z = 1.75ft Note: Clear handwritten solution
On a hot summer day, the flat roof of a tall building reaches 50° C in temperature. The area of the roof is 400m2. Estimate the heat radiated from this roof to the sky in the evening when the temperature of the surrounding air or sky is at 20° C. The temperature of the roof decreases as it cools down. Estimate the rate of energy radiated from the roof, assuming roof temperatures of 50, 40, 30, and 25° C. Assume ε = 0 9 . for the roof.
Compare the masses and volumes of water, concrete, sand, and wood needed to store 106 Btu of heat if the operating temperatures are Tc = 85F and Th = 180F. In each case, calculate the edge length of a square storage unit with a height of 8 ft.