A four storeyed building has an elevation shown in Fig. 20.10 and is located inseismic zone IV. Determine the lateral forces and storey shears on an inner frame due toearthquake using the following data:Bay width =Frame spacingHeight of ground floor =6 m centre to centre (c/c);5 m c/c4 m,%3Dno beol boeoqnlROOFTHIRDFLOORSECONDFLOORFIRSTFLOORto tgiow inoTFig. 20.10Height of other floorsFloor thickness including finish3.5 m15 cmOuter columns25 cm x 30 cm, 2 No.;Inner columnsGirders below floor slab25 cm x 40 cm 3 No.%3|25 cm x 40 cmLive load3 kN/m2%3DThere are no walls in this frame. Its foundation rests on hard soil.

Answered: Image /qna-images/answer/d441855a-b910-47e4-88c3-ea3d16ae36ea.jpg

A four storeyed building has an elevation shown in Fig. 20.10 and is located in seismic zone IV. Determine the lateral forces and storey shears on an inner frame due to earthquake using the following data: Bay width = Frame spacing Height of ground floor = 6 m centre to centre (c/c); 5 m c/c %3D 4 m, ROOF THIRD FLOOR SECOND FLOOR FIRST FLOOR Fig. 20.10 Height of other floors Floor thickness including finish = 3.5 m %3D 15 cm Outer columns 25 cm x 30 cm, 2 No.; %3D Inner columns Girders below floor slab 25 cm x 40 cm 3 No. %3D 25 cm x 40 cm %3D Live load 3 kN/m %3D There are no walls in this frame. Its foundation rests on hard soil.

A four storeyed building has an elevation shown in Fig. 20.10 and is located in seismic zone IV. Determine the lateral forces and storey shears on an inner frame due to earthquake using the following data: Bay width = Frame spacing Height of ground floor = 6 m centre to centre (c/c); 5 m c/c %3D 4 m, ROOF THIRD FLOOR SECOND FLOOR FIRST FLOOR Fig. 20.10 Height of other floors Floor thickness including finish = 3.5 m %3D 15 cm Outer columns 25 cm x 30 cm, 2 No.; %3D Inner columns Girders below floor slab 25 cm x 40 cm 3 No. %3D 25 cm x 40 cm %3D Live load 3 kN/m %3D There are no walls in this frame. Its foundation rests on hard soil.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The roof is supported by cables as shown in the photo. If the cablesexert forces FAB = 100 N and FAC = 120 N on the wall hook at A asshown , determine the resultant force acting at A. Expressthe result as a Cartesian vector.
In the gate AB is hinged at B and is 1.2 m wide. What vertical force, applied at the center of gravity ofthe 20kN gate, will keep it in equilibrium?
Find the: Righting moment Overturning moment Factor of Safety against sliding Factor of Safety against overturning Given: u = 0.8 y (kN/m^3) = 22.50 b1 = 1.60 b2 = 6.50 h1 = 12.00 h2 = 10.00 pls, thank you
wind blows on the side of the fully enclosed agriculture building located on open flat terrain where V=105mi/h. Determine the external pressure acting over the windward wall, the leeward wall, and the side walks also, what is the internal pressure in the building which acts on walls ? use linear interpolation to determine qh and Cp,
Determine the area of the moment diagram of the structure Choices: (-wL^3)/24 (wL^3)/24 (4wL^3)/24 (-4wL^3)/24
Engineering MechanicsA 22-kg ladder with a span of 21 m is resting against a smooth wall at B and the other end rests at A with μs = 0.45. Find the angle of inclination (θ) of the ladder if it is about to slip. Type answer in 2 decimal place.
Given: 1. Structural Component: Beam 300 mm x 400 mm Column 400 mm x 400 mm Slab thickness 110 mm 2. Dead Load: Super Imposed dead load = 4.5 KPa (including slab weight) CHB = 3.11 KPa 3. Seismic Parameter: Soil Profile - Sb Closest distance to the source - 10 km Ductility Coefficient R = 8.0 Seismic Zone Z=0.40 Ct = 0.0731 A. Compute TOTAL LATERAL FORCES in the 2nd floor? B. Compute LATERAL FORCES in the 3rd floor?
As shown in Figure, astone is thrown vertically into theair from the top oftower 100 ft.high. At the same instant, a second stone is thrown upward from the ground. The initialvelocity of first stone is 50 ft/secand that of second stone is 75 ft/sec.When and where will the stones be at the same height from the ground?
What is the vertical reaction at support A? A. 35.81 kN B. 46.31 kN C. 50.90 kN D. 51.33 kN What is the vertical reaction at support B? A. 46.32 kN B. 56.32 kN C. 58.32 kN D. 59.32 kN
The dimensions of a 9-m-high warehouse areshown in Figure P2.12. The windward and leeward windpressure profiles in the long direction of the warehouseare also shown. Establish the wind forces based on thefollowing information: basic wind speed = 40 m/s, windexposure category = C, Kd = 0.85, Kzt = 1.0, G = 0.85,and Cp = 0.8 for windward wall and −0.2 for leewardwall. Use the Kz values listed in Table 2.4. What is thetotal wind force acting in the long direction of thewarehouse?
What is the Vertical component (y-component) reaction force at support C? A. 600N, ( + ) upward B. 200N, (+) upward C. 600N,(-) downward D. 200N,( - ) downward SHOW SOLUTIONS
If the wall shown is a part of a structure and has a unit weight of 60 psf, find the maximum value for load P acting on the wall without causing overturning. Factor of safety = 1.5