a function of Eb. SA 53

Q: Question 7 .1. What the advantages of a closed-loop control system? 7.2. What is the purpose of a s...

A: I am giving the answer of first 3 subparts as per guildlines. - closed loop control system is provid...

Q: Is it possible to an element to have zero voltage but a current is not zero? Or an elemer current bu...

A:

Q: 9  Listed are the factors affecting the capacitance except: A.   voltage rating B.   dielectric c...

A: Listed are the factors affecting the capacitance except: A. voltage rating B. dielectric constant C....

Q: 10 Ω 8Ω 40/0° V rms j4 Ω -6 Ω

A:

Q: A 10 B 5.0 Il 3V1 vi 1 211 8V

A: Given circuit shown 

Q: Assume that each diode has a turn-on voltage 0.7V in the circuit shown in Figure Q1. By using the co...

A: In this question,  We need to check which diode act as on and off.  Assume forward bias diode voltag...

Q: What is the peak factor of 169sin 377t?

A:

Q: 0.1 Ohm SW TIP2955 with Heat Sink 10 Amp 50 PV Bridge Rectifier 0.1 Ohm SW LM7812 with Heat Sink FUS...

A: Full wave bridge rectifier- A circuit in which four diodes are interconnected in a bridge form in wh...

Q: Q2: Using Nodal analysis, find the node voltages for the circuit below. 6 A 3 A 2Ω 5 A ww

A: Circuit diagram is given as,

Q: a) Deduce the expression for Y - A and A - Y conversions. Using such conversion, fir current I of th...

A:

Q: Ex. Calculate the PA for the follow assembly code which is assume the DS = 4500h, SS = 2000h, BX = 2...

A: The given code is: 01 org 100h02 MOV BX+20,  AX03 MOV SI+10, AX04 MOV BP+2, AL04 ret It is given tha...

Q: 15. For the network of Fig. 9.80: a. Determine re. b. Find Ay = Vo/Vi- c. Calculate Z. d Determine f...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: *39. For the network of Fig. 2.183: a. Calculate 57. b. Compare 57 to half the period of the applied...

A:

Q: Given an analog input signal whose voltage ranges from –-5 to 5 V, and a 8-bit digital encoding, cal...

A:

Q: 1.2 Determine the conversion efficiency of a 380 W Polycrystal PV module with the following paramete...

A:

Q: Determine what is being asked. Justify answers by showing complete solution or writing comprehensive...

A: Given: Resistance, R=2,50,000Ω or 250 kΩ

Q: 5. Sketch Vo for the following circuit. 12 V + 0.1 pF R2 56 ka 2V -12 V 1-1 kHz

A:

Q: #6) FINDI,: (Hint Supemade with dependent source) Vz V +) IZV YI.

A:

Q: Q2 A circuit with an unstable DC voltage source Vs and output Vzis shown in Figure Q2. The unstable ...

A:

Q: VEE =25V, R2 = 560000ohm, R3 = 1300, B = 90 Calculate IB , VC , VB , VCE , VE

A: The solution is given below 

Q: ID Si 12 V Ge Si o Vo GaAs 4.7 kQ 2.2 k2 6 4 V (b) (a)

A: We are authorized to answer only 1 question at a time since you have not mentioned which question yo...

Q: Explain the stability analysis of a Dc system in a detail

A: Dc system - It’s main use is to power anything that has a battery. The battery is used mainly for th...

Q: What is PNP and NPN ?

A:

Q: G. In AC OPF the locational marginal price (LMP) for different buses could be different due to (a) s...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: For the circuit shown in Figure below, how much current flows through the 20k2 resistor? 10 k2 R1 R2...

A:

Q: Simplify the following table in POS form

A: The solution is given below 

Q: True/False To convert the logic of a Full Adder (FA) to that of a Half Adder (HA), simply tie the C...

A:

Q: ) A ferromagnetic is shown in figure Q3(b). Find the value of the current that will produce a flux o...

A:

Q: A voltage is given by v(t) = 10 sin(1000TTt-30°). Find the amplitude (A), frequency (f), Phase angle...

A:

Q: Problem #1 Design a series RLC bandpass filter with a center frequency fo = 1 MHz and a quality fact...

A:

Q: a. SketchtheoutputvoanddeterminethedcleveloftheoutputforthenetworkofFig.2.49. Repeat part (a) if th...

A:

Q: insulating material that separates the electrodes of a capacitor. Select one: a. dielectric b. air...

A: We need to select correct option for capacitor .

Q: Consider the Gaussian surface shown in Figure 2. A uniform external electric field E, having magnitu...

A: Net electric field due to inside charge E-int=E-2-E-1E-int=6.4×103 n^2-3.2×103 n^2E-int=3.2×103 n^2D...

Q: + 10 V + 10 V 10 kN 5 kΩ I2 Z D2 V В B 5 kM 10 kN - 10 V - 10 V (а) (b)

A:

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A:

Q: 220V () 2.5k ohms

A: The solution is given below 

Q: Explain what the stack pointer register is and what it does in a few words.

A: In this question we will write about stack pointer register in microprocessor....

Q: Find ix Hix 2u mA 9 2ix

A: Consider the given circuit,

Q: Q1/(b) Calculate cutoff frequency high for the cct. below at R1=R2= 10K2 and C1=C2=0.002 µF *

A: The given circuit is shown below: R1=R2=10Kohm=10X103ΩC1=C2=0.002μF=0.002X10-6F

Q: (a) Calculate the ratio of the polar optical phonon emission rate to the absorption rate for AIAS at...

A: It is given that: Temperature=300 KPhonon energy in =50 mEV=0.05 eVElectron energy=35 meV=0.0.035 eV

Q: 4 HpCox 400 µA/V², VGsı 0.6 V, and For the circuit shown, unCox |Vt = 0.4 V, 2 = 0.01, L = 0.2 um, a...

A:

Q: 6. A 3-phase star connected AC generator is rated at 2.5 MVA, 11 kV, 60 Hz. The generator has a negl...

A:

Q: 1. Solve I. 2. Solve for Ip and V. 20 V + + 8 V 1.2 k2 Si Si 4.7 k2 10 2 Si 20Ω 6-6 V 4. Solve for I...

A: As per company guidelines we can solve only first three questions kindly post another question separ...

Q: Q1 R2 R3 VEE

A:

Q: 1.Describe the following feedback control system in terms of simple block diagrams: a. DC motor posi...

A: (a) DC motor position control system: Consider the simple block diagram for the DC motor position co...

Q: Ex8: Find the Thevenin's equivalent circuit of the circuit to the left of the (72) resistor for the ...

A:

Q: VEE =12V, VCC = 15V, RC = 1200 ohm, RE = 2700 ohm B = 50 Calculate IB , VC , VB , VCE , VE

A: In this question,  Given data VEE =12V, VCC = 15V, RC = 1200 ohm, RE = 2700 ohm Dc current gain B = ...

Q: Find the RMS value.

A:

Q: 2.37 Determine the 4 × 4 bus admittance matrix Yus and write nodal eq tions in matrix format for the...

A: Given circuit,    

Q: Which transmission medium is ideal for the most densely inhabited areas? Discuss

A: Transmission medium- Transmission Media are the communication channels through which data is transmi...

BJT (Bipolar Junction Transistor)

A BJT is a semiconductor device with 3 terminals that consist of a p-n junction diode that can amplify the signal or current. It is a current-controlled device. The three BJT terminals are base, collector, and emitter. The BJT works with the charge carrier, the two type of carriers in the BJT are holes and electrons, the charge carriers flow by the process of recombination. The signal to be amplifier is generally given as the input at the base terminal and an amplified form of it is available at the collector terminal.