A gas is compressed in a cylinder by a movable piston to a volume one-half its original volume. During the process 300 KJ heat left the gas and internal energy remained same. The work done on gas in Nm will be O 30000 Nm O 3000 Nm O 300000 Nm 300 Nm REDMI NOTE 8 PRO AL QUAD CAMERA

Q: A 1000 m3 lake is found to be contaminated with TCE (trichloroethane) that is potentially toxic to…

A:

Q: A liquid food (p = 900 kg/m3, p= 2 cP) flows from a 15 m long pipe of 3-in. diameter to a 25 m long…

A:

Q: A long glass capillary with a diameter of 0.1 cm is in contact with water on one side and dry air on…

A: Diameter of tube = 0.1 cm Vapor pressure of water vapor at 20 0C = 17.5 mmHg Diffusivity of water =…

Q: A particular power plant operates with a heat-source reservoir at 350°C and a heat- sink reservoir…

A: Giventemperature of heat source reservoir=350oCtemperature of heat sink reservoir=30oCThermal…

Q: A 17.3 L container was filled with 0.500 mol of a gas at 20°C. What is the pressure of this gas in…

A:

Q: A petroleum stock at a rate of 700 bbl/hr of SG.= 0.8524 is passed through a train of heat…

A: Given data: m=700 bblhr S.G=0.8524 Air fuel ratio(G)=20 Avg specific heat of stock=2.268 kJkg °C…

Q: Two equal masses of Fe and C were heated by absorbing 30 KJ, which one of the following is correct?…

A: Given  Mass of Fe (MFe)  = Mass of C(MC) = M Specific heat capacity of   Cp ( Fe)  = 0.45 Specific…

Q: 5.38. Ten kmol per hour of air is throttled from upstream conditions of 25°C and 10 bar to a…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: One mole of an ideal gas expands isothermally and reversibly at 25C from a volume of 5 liters to a…

A:

Q: (B) By using Clausius-Clapeyron equation and the given correlation/equation determine vapor pressure…

A:

Q: Looking at the following pump and system curves, what are the operation time parameters (i.e.,…

A: Given: Pump and system curve In X axis- flow rate in gpm and Y axis- Total dynamic head ( TDH) in…

Q: An industrial wall is constructed of 20 cm thick fireclay (k =1 W/m.°C). This is covered on the…

A:

Q: Standard addition. A particular CO, compound electrode To potentiometer like the one in Figure 15-33…

A:

Q: Make a sketch: A flash drum is used to reduce the temperature of a butane stream. The butane enters…

A: Flashing is when a liquid changes its phase and becomes partly vapour and partly liquid, this…

Q: BME 101 Introduction to Biomedical Engineering Shown here is the Hawking equation that describes…

A: Write the Hawing equation as follows: S = πAkc32hG       ......1   Given the units of each variable…

Q: (a) Half-life of a compound decomposing in second order process only depends on the reaction rate…

A: Note: We are supposed to answer only 3 subparts of the questions as per our guidelines. please send…

Q: A solution composed of 47% ethanol (EtOH), 13% methanol (MeOH), and the balance water (H20) is fed…

A: Given Data

Q: Perform the conversions. Torr atm 1.167 atm = 931.7 mmHg = Pa atm 1108.9 mmHg = 979.1 kPa =

A:

Q: 5.1. Derive the transfer function H(sVQ(s) for the liquid-level system of Fig. P5-1 when (a) The…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A 300 L storage tank is initially half-filled with hydrochloric acid (HCI) of concentration 2.5…

A: Given that- Volume of tank= 300 L Initial volume of HCl in tank, V1= 150 L Concentration of HCl,…

Q: A throttling steam calorimeter is an instrument used for the determination of the quality of wet…

A:

Q: 6. A natural gas with a specific gravity of 0.75 has a gas formation volume factor of 0.00529 ft/scf…

A: The formation volume factor is the ratio between the volumes of gas. One of the volumes is obtained…

Q: 32 kg/h of liquid methanol is burned with 10% excess air. The flue gases exit at 787 mmHg. What is…

A:

Q: What is the change of energy (L. atm) of a system that absorbed 18.8 L atm of heat and had its…

A:

Q: The rate of heat loss from a tank to the surrounding by convection and conduction is expressed by:…

A: Given Equation; qA=0.7∆T1.27(Do)0.27where;q=rate of heat loss, Btu/hrA=Area of tank surface,…

Q: The coal analyzes 13.5% VCM, 74.8% FC, 8.5% ash, 3.2% M, 0% N and 1% S, and it has a heating value…

A: Coal is burnt with air.

Q: Why is it necessary to include an element of carbon, hydrogen, oxygen, and nitrogen in the chemical…

A: Introduction: Bagasse, also known as megass, is fibre remaining after the extraction of the…

Q: A sample consisting of 1.00 mol of the molecules in air is expanded isothermally at 25°C from 24.2…

A: Given data: Number of moles = 1 mol Initial temperature = 25 0C Initial volume = 24.2 dm3 Final…

Q: Two equal masses of C and Au were heated by absorbing 30 KJ, which one of the following is correct?…

A: Specific heat capacity is defined as the amount of heat required to raise the temperature of unit…

Q: Experimental data showed that the atmosphere of planet X is composed of pure CO2, with the pressure…

A:

Q: 2. Why sand has a low porosity but a high permeability?

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: A stream 40% by mass acetone and 60% water is mixed with a stream of pure MIBK in an extraction…

A:

Q: A rigid vessel with an internal volume of 100000 litres contains 2 kg of saturated water mixture at…

A: GIVEN: V1 = 100000 Litres  = 100 m3  Mass = m = 2 kg  V = Volume in m3/Kg =  V1/m = 100 m3/2 kg = 50…

Q: A right 10-L tank initially contains a mixture of liquid water and vapor at 120°c with 20 percent…

A: Given Data Volume of the tank (V) = 10 L Temperature of liquid water and vapour (T1) = 1200C = 393 K…

Q: (b) Consider the gas phase reaction A(g) + B(g) = 2C(g). (ii) Show that the reaction is spontaneous…

A:

Q: • Consider one such alloy that initially has a uniform carbon concentration of 0.25 wt% and is to be…

A: Given data: Initial concentration of carbon = 0.25 wt % Surface concentration of carbon = 1.2 wt %…

Q: From such an experiment, it was found that the concentration of hydrogen peroxide remaining after 65…

A: Given data: Initial concentraction of hydrogen peroxide; Co=57.90 moles/mLFinal concentration of…

Q: Consider the following reaction: NO + O3- NO, + 02. Which is the correct expression for the…

A:

Q: An ideal gas in an isolated system is expanded isothermally but irreversibly from V1 to V2 at 400K…

A: Given Isothermal expansion T= 400 K

Q: Nitrogen gas has a heat capacity of 20.8 and 29.1 J/mol-at constant volume and constant pressure…

A:

Q: What horsepower is required to isothermally compress 800 ft3of air per minute from 14.7 psia to 120…

A: Given:  P1 = 14.7 Psia   P2 = 120 psia  V1 = 800 ft3/min  we know that,  W =  P1V1 ln(P1P2)

Q: In order to meet a certain octane number specification, it is necessary to produce gasoline…

A: Given Data To Find  The volume of high octane gasoline required  blended with straight run gasoline…

Q: Round everything to 4 decimal places. Two inlet streams enter a mixing tank, both of which consist…

A: Given that for mixing- For Stream (1)- Molar flow rate, n1= 1.5 mol/s Initial temperature, T1 = 600…

Q: Sultur dioxide is absorbed into water in a packed column. At a certain location, the bulk conditions…

A: Hav = (H1 + H2 + H3 + H4) / 4 where Hav = constant henry rate H1 = PA1 / CA1 = 0.0382 / 0.03126 =…

Q: how much would flow (lb/hr) into steam distillation unit through a perforated sparger pipe…

A: To equalize operating pressure in the distillation column there will be contribution of steam which…

Q: In a combustion of coal, the stack gas, which contains CO, CO2, H2, H2O, SO2, N2, and free O2…

A:

Q: What is the change of energy (L. atm) of a system that absorbed 19.9 L.atm of heat and had its…

A:

Q: Nitrogen gas has a heat capacity of 20.8 and 29.1 J/mol-C at constant volume and constant pressure…

A: Given Cv = 20.8 J/K.mol Cp = 29.1 J/K.mol Initial temperature = 50K Final temperature = 100K Find…

Q: The reversible (elementary) reaction 2A C+D is conducted in a CSTR at a feed rate of 100 L/min with…

A: Dear User, According to Bartleby policy, we can answer only one problem, we are gonna solve the…

Q: 19 The following reaction was allowed to reach equilib- rium at 25°C. Under each component is its…

A: Given ,        Temperature = 25 0 C = 298 K         Equilibrium Concentration of NOCL = 2.6 M…