A heat engine having an efficiency of 70% is used to drive a refrigerator having a coefficient of performance of 5 .The energy absorbed from low temperature reservoir by the refrigerator for each KJ of energy absorbed from high temperature source by the engine is

A heat engine having an efficiency of 70% is used to drive a refrigerator having a coefficient of performance of 5 .The energy absorbed from low temperature reservoir by the refrigerator for each KJ of energy absorbed from high temperature source by the engine is

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter45: Domestic Refrigerators And Freezers

Section: Chapter Questions

Problem 12RQ: Refrigerators currently being manufactured in the United States are using______as their refrigerant.

See similar textbooks

Related questions

Q: Draw the shear and bending- moment diagrams for the beam and loading shown, and determine the…

Q: 4-1.Draw a free-body diagram of pump handle AC in Figure P4-1. .7 m .1 m 20 N A .8 m

A: Introduction: Free body diagram: A free body diagram is a visual, dematerialized, symbolic…

Q: 1:25:31 > A cantilever beam is subjected to an inclined force (P) as shown in Figure 1, the…

A: Given data:- P= 400 kN find the normal component of force at point A.

Q: Describe briefly the difference between a heat engine and a heat pump.

Q: 4) A flat steel bar, 25 mm. wide by 6 mm. thick and 1m. long, is bent by couples applied at the ends…

A: Given Deflection = 20 mm Length, L = 1 m Modulus of…

Q: Det er min Length 3 cm width cm, hic es so, com constant al equal to 3.45 +10º, Intenst of see p.84…

Q: 200 N 200 N 500 N 200 N A C D E 300 225 300 225 Dimensions in mm Fig. P5.14

Q: Q3. An engine operate on air standard Otto cycle with a compression ratio of 7, Determine: 1. The…

Q: A building has a total heating load f 200,000 Btu/hr. The sensible heat factor for the space is…

Q: For the cantilever beam shown. find the value of compound stresses at :point C due to Normal…

Q: 3. The 80-mm-radius wheel shown rolls without slipping to the left with a velocity of 900 mm/s.…

Q: Consider an air-standard Otto cycle that has a compression ratio of 9.0 and a heat addition of 870…

Q: PROBLEM S5.3 A thin spherical vessel 1 m in diameter and 12 mm thick is filled with water. More…

A: Given data:

Q: A vapor-compression refrigeration system operates on a cycle with evaporation temperature of 0°C and…

A: Evaporation temperature, Te=0oCCondensation temperature, Tc=26oCRefrigerant= Tetrafluoroethane…

Q: An ideal Rankine cycle has a boiler pressure of 8 MPa, a condenser pressure of 0.05 MPa, and the…

Q: At a given section a shaft is subjected to a bending stress of 30 MN/m2 and a shear stress of 60…

Q: Ex/ A Carnot engine is operating at temperature 200 k and 800 k, if 13500 J of heat energy in…

A: GivenT1=200 KT2=800 KQa=13500 J

Q: Q.2 The heat absorption and rejection temperatures of a Carnot refrigeration cycle are -8°C and 55°C…

Q: A pipe contains an oil of specific gravity 0.8. A diferenual manometer connected at the two points,…

Q: There is no negative force, but the negative and positive represent the direction of the compound T…

Q: A beam is constructed from two i-sections as shown in Fig. Determine the maximum shear stress if the…

Q: A steel cylinder (Est = 200 GPa and G = 79 GPa) undergoes an azial compression in which its diameter…

Q: Pressure drop and heat transfer in suction line Decrease compression ratio & discharge temperature…

A: Correct answer: (B)

Q: In general, copper has . . tensile strength. medium O high O low O none of them

A: ◆ In general, copper has high tensile strength. ◆ The correct answer is option (b).

Q: Water flows through a horizontal tapered pipe with a diameter of 300 mm at one end and 200 mm at…

A: Water flows through a horizontal tapered pipe with a diameter of 300 mm on one end and 200 mm on the…

Q: e a planet rises, and cool material sinks towards the center. nergy throughout the Earth's core.…

A: 1 correct answer is options c In conversation medium is required for the heat transfer

Q: The crate, which has a mass of 100 kg, is subjected to the action of the two forces. If it is…

Q: The resultant of a force system is the force which can replace the original system with out changing…

A: This question is based on the concept of classical mechanics.

Q: The Question: An airplane has to land at a destination 300 km northeast, with a wind blowing at 40…

A: Given data:- destination = 300km northeast, wind blowing speed = 40 km/hr airplane speed = 180 km/hr…

Q: Figure 1: y P = 400 kN 30° 1000 mm A Area 30 mm 20 mm In Figure 1, the equilibrium shear force…

A: Given data :- force = 400KN find the shear force at point A.

Q: b. Explain the following term. i. Resolution ii. Dead band iii. iv. Precision Repeatability

A: During the measurement of any physical quantity different terms of measurement are necessary to…

Q: A reservoir built 5 km away from town. has to supply water at the rate 1000 lit/ min. Calculate the…

A: We have a reservoir 5 kilometres from town that must supply water at a rate of 1000 litres per…

Q: 3.00 6.00 Z symmetric about horizontal axis 4.00 3.00 (3 2.00 9.00 3 1 2 3 Enter the missing terms…

A: 1: b= ? , h= 6 , Iy= 542: b= 4 , h= ? , Iy= 93: b= 2 , h= 9 , Iy= ?

Q: Determine the rate of flow of water through a pipe of diameter 20 cm and length 50 m when one end of…

A: given data diameter = 20cm length = 50 m f= 0.009 height of water in the tank = 4 m find the flow…

Q: c) A sound wall is to be constructed at the edge of shoulder, along the inside of a horizontal curve…

Q: Q5: How is the surface quality improved in ball burnishing?

Q: Find the intersection of the line / and the plane T. 1:7=(4,-1,4) +t(5,-2,3) x: 2x+5y+z+2=0

A: Given: r = (4,-1,4) + t(5,-2,3) π: 2x + 5y + z + 2 = 0

Q: Consider the figure below. Arrange the kinetic energies of the final states in decreasing manner.…

A: Need to arrange the kinetic energies of the final states in decreasing manner

Q: Thermodynamics (Brayton Cycle) Round up the answer up to 5 decimal places. A 120 MW gas turbine…

Q: Q.3 A Carnot cycle heat pump operates with R134a as the refrigerant. The condenser and evaporator…

Q: 7.21- In a textile manufacturing plant, the waste dyeing water (Cp = 4295 J/g Cº) at 75C° is to be…

Q: One end of a spring is attached to a solid wall while the other end just reaches to the edge of a…

Q: F E 2 m A B 2 m 1 m 1m

Q: A 20.0kg crate is subjected to a constant force of 100 N as shown in the figure. When the distance…

Q: Determine the reactions at A and B on the Fink truss shown in FG are respectively Fig. below.…

A: Let's mark the points H, I, J as shown in below figure. Let the reaction at roller support A is…

Q: 6. A 10-ton load is to be lifted through a height of 60 ft within 40 seconds. Determine the minimum…

A: Given Load = 10 ton = 10*2204.62 lb = 22046.2 lb height = 60 ft time = 40 s To determine Minimum…

Q: 2. Compute the equivalent resultant force and moment for the system of forces and couple shown in…

A: find the equivalent resultant force and moment about 'o'.

Q: Qustion 3 ProPylene (C3 H6) Process - ASsuming Combustion and totol Pressure oF 105 Kpa determine is…

Q: Round off all your values to 3 decimal places. The 50-kg crate rests on a horizontal surface for…

A: Given data mass (m) = 50 kg coefficient of kinetic friction = 0.3 F = 400 N To determine a)…

Q: A turbine passes 67.5 kg/h of steam at 200 km/h at 8 MPa and leaves at 0.5 MPa as wet steam with a…

Question

A heat engine having an efficiency of 70% is used to drive a refrigerator having a
coefficient of performance of 5 .The energy absorbed from low temperature reservoir by the
refrigerator for each KJ of energy absorbed from high temperature source by the engine is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A heat engine operates on the Carnot cycle, and has a thermal efficiency of 75 percent. The waste heat from this machine is rejected to a nearby lake at 15 ° C at the rate of 14 kW. Determine the power output of the motor and the temperature of the source, in ° C.
A heat engine is operating on a Carnot cycle and has a thermal efficiency of 75 percent. The waste heat from this engine is rejected to a nearby lake at 60°F at a rate of 800 Btu/min. Determine the temperature of the source.
A heat pump can use a maximum of 2 kW power for maintaining a house at 20°C during winter. The rate of heat transfer from the roof and walls is 3000 kJ/h per degree temperature difference between inside and outside. The coefficient of performance is 25% of a reversible heat pump. Determine the minimum outside temperature for which the heat pump can meet the heating requirements of the house.
A solar energy based heat engine which recieves 90kJ of heat at 900C and rejects 70kJ of heat to the ambient at 200C is to be designed. Determine the thermal efficiency of the heat engine.
A heat engine is operating on a Carnot cycle and has a thermal efficiency of 55 percent. The waste heat from this engine is rejected to a nearby lake at 60°C at a rate of 900 kJ/min. Determine the temperature of the source.
A heat pump designer claims to have an air-source heat pump whose coefficient of performance is 1.8 when heating a building whose interior temperature is 300 K and when the atmospheric air surrounding the building is at 260 K. Is this claim valid?
Estimate the annual operating cost for a heat pump that delivers 30,000 BTU per hour of heat during winter and a similar rate of cooling during summer. Assume the heat pump operates 8 hours per day for 120 days in summer, and 12 hours per day for 120 days in winter. The Seasonal Energy Efficiency Ratio (SEER) for summer cooling is 16 BTU/Wh, and the Heating Season Performance Factor (HSPF) for winter heating is 12 BTU/Wh. The cost of electricity is $0.20/kWh.
A heat engine operates by receiving heat from a reservoir at 900 oC at a rate of 800 kJ/min and rejects heat at a rate of 560 kJ/min to the ambient air at 27 oC. The entire work output of the heat engine is used to drive a refrigerator that removes heat from the refrigerated space at -5 oC and rejects heat to the same ambient air at 27 oC.i) Sketch the schematic diagram of the engine-refrigerator system.ii) Determine the thermal efficiency of the heat engine, %.iii) Determine the maximum thermal efficiency of the engine if it operates on a reversible cycle, %.iv) Determine the maximum COP of the refrigerator if it operates on a reverse Carnot cycle.v) Determine the maximum rate of heat removal from the refrigerated space, kJ/s.vi) Determine the rate of heat rejection to the ambient air from the refrigerator,kJ/s.
Prove that if you had a heat engine whose efficiency was better than the ideal value (4.5), you could hook it up to an ordinary Carnot refrigerator to make a refrigerator that requires no work input.
A reversible heat engine operate between two reservoirs at temperature of 600°C and 40°C. The engine drives a reversible refrigerator which Operates between reservoirs at a temperature of 40°C and -20°C. The heat transfer to the heat engine is 2000KJ and the net work out put of the combined engine refrigerator plant is 260 KJ. Evaluate the heat transfer to the refrigerator and the net heat transfer to the refrigerator at 40°C.
A heat engine is operating on a Carnot cycle and has a thermal efficiency of 56.2 percent. The waste heat from this engine is rejected to a nearby lake at 60.26 F at a rate of 842.35 Btu/min. Determine the temperature (R) of the source.
Provide complete solution and detailed diagram. A refrigerator is to remove heat from the cooled space at a rate of 300 KJ/min to maintain itstemperature at - 8oC. If the air surrounding the refrigerator is 25oC, determine the minimum powerrequired for this refrigerator? A. 0.263 kw B. 0.473 kw C. 0.623 kw D. 0.984 kw