A hemispherical dome of 45 m diameter covers a 25 m diameter ice sink. Both ice and dome can be treated as blackbodies. The dome is at 10 C and the ice at -5 C. Calculate the rate of heat transfer in kW

A hemispherical dome of 45 m diameter covers a 25 m diameter ice sink. Both ice and dome can be treated as blackbodies. The dome is at 10 C and the ice at -5 C. Calculate the rate of heat transfer in kW

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.25P: 1.25 A spherical vessel, 0.3 m in diameter, is located in a large room whose walls are at 27°C (see...

See similar textbooks

Related questions

Q: The rate of heat addition to an ideal air-standard Brayton cycle is 1.0 x 107 Btu/h. The pressure…

Q: a) Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for…

A: Find , Clearance volume Swept volume ,

Q: viscosity and density of olive oil at 20C. use perrys table

A: To find Olive oil at 20 deg c

Q: A conical tank having a radius of the base equal to 0.39 m and a height of 0.75 m. The cone is laid…

Q: Initially, a closed system consists of 2 lb of water vapor at the temperature and volume of 300°F…

A: Given Mass, m = 2 lb Volume, V1 = 20 ft3 V2 = 9.05 ft3 Work done, W…

Q: The roof of an airconditioned home is 7 m long, 9 m wide, and 20 cm thick. It is made of a flat…

A: find the cost of electricity.

Q: A refrigerator operates at steady-state with a COP of 4.5 and power input of 0.8kW. If energy is…

A: Answer: (a) The rate of energy rejection: 4.4 kW. (b) The lowest theoretical temperature inside the…

Q: Determine the pressure difference between pipe A and B for arrangement shown in Fig. P. 1.13.20. 0.2…

Q: Consider the rectangular cardboard shown in the figure. If you cut a hole in the material, the…

Q: Given an open tank filled with oil that is discharging through a 35-meter long commercial annulus…

Q: The assembly shown in the figure consists of a brass core (diameter d1 = 0.25 in.) surrounded by a…

Q: Calculate the notch sensitivity factor of a plate with a central hole of 0.81" diameter if the…

Q: Determine the force (written as a vector) which BC exerts on member AB (a) if the 650-N load is…

A: When a push or pull applied on the object in compressible or tensile manner, it has the ability to…

Q: In a gas turbine, air at 15°C is compressed from 1.01 bar with a pressure ratio of 6/1. Afterward,…

Q: 12. The defect depicted in the diagram below is known as... (b) 2A a. helical b. edge dislocation c.…

Q: The figure (not drawn to scale) shows a metallic cylindrical column submitted to a combined load:…

Q: Determine the force in member BF. The force is positive if in tension, negative if in compression.

A: To find force in member BF

Q: A container is floating in water. The container has a rectangular shape of 1.52 X 0.66 X 0.50 m…

Q: What is the largest safe torque, in Nm, can be applied to the circular cross-section?(Provide answer…

Q: Using calculus, find moment of inertia of a right triangle of Show how you would find the vertical…

Q: In Basic Occupational Safety and Helth Describe the Chain Reaction that is triggered when fire…

A: Given question: Describe the Chain Reaction that is triggered when fire has started.

Q: GRESFA1 PhC-hydrostatic pressure experienced by Aaron 36. What is 8 feet in meters? 2.4 M 37. What…

Q: I Review Part A- Transmitted power Learning Goal: To determine the maximum possible power…

Q: Problem 1: Calculate the forces in the required members of the truss shown: F1 F2 F3 H F h F4 D E C…

Q: Q1/ In the equilibrium position shown in figure below, the uniform bar (AB) has a mass of (50 kg)…

Q: 5. If 528 kJ of heat are added to 2.5 kg of helium at constant volume process when the initial…

A: Correct answer: (a) 1.52 kJ/K

Q: The drag force, Fd, imposed by the surrounding air on a vehicle moving with velocity V is given by…

A: Velocity of vehicle, V=50 miles per hour =50*1.46667=73.3335 ft/s 1 mile/h=1.46667…

Q: Steam engine with incomplete expansion receives saturated steam at 1.04 Mpa, expands it to 0.105 Mpa…

A: Since you have posted a question with multiple sub-parts, and each subparts there are more than one…

Q: The Single Stage Two Speed Supercharger and its Operation

A: The answer is given below-

Q: Two forces L (parallel to the y-axis) and A (parallel to the z-axis) are applied at point Q on the…

Q: The heat capacity of a liquid is 250 J/K, if its mass is 50 kg the specific heat capacity of the…

Q: A certain steel shafting material has an ultimate strength of 93 ksi, a notch radius of 0.25 inch,…

A: Given data as per the question sut=93 ksiNotch radius =0.25 inkf=2.5cycles=166077from the standard…

Q: A piston cylinder contains air at 600 kPa, 290 K and a volume of 0.01m3. A constant pressure process…

Q: a) What is the required tube length for these conditions? b) To design a water heating system,…

A: first we calculate reynolds numebr then evaluate nusselt number then figure out h and the use…

Q: 2.) Two sinusoidal currents are given by, i1 = 20 sin (w t + Tt/4) and i2 = 25 sin (w t + Tt/5).…

A: General expression for sinusoidal current is given by, i=Asin(ωt±ϕ) where, A = maximum amplitude of…

Q: p= 998 kg/m, Cp = 4171 J/kg K, k = 0.651 W/m K, po = 4.71 x 104 kg/m s, Hu = 2.82 x 104 kg/m s and…

A: We calculate reynolds number , then the nusselt number and then the heat transfer coefficient.

Q: Determine the velocity and frequency of vibration of a rope 6 m long with a mass of 2 kg and…

Q: A piston contain a mixture of water vapor (0.9 ?3 ) and liquid (0.1 ?3 ) both at 0.5MPa. The mixture…

Q: 3. A 2-mm-diameter and 10-m-long electric wire is tightly wrapped with a 1-mm-thick plastic cover…

Q: the system shown starts from rest in the position shown. when block A hits the floor the cable…

Q: 4. What kind of line on a distance-versus-time graph indicates that the object is accelerating? a.…

A: Correct answer: (a) curved

Q: Which distance represents height of the fall for measurement of the time?

A: In the question, a machine is given and when it rotates it is needed to find out the height and time…

Q: Calculate the components of the forces at B and C.

Q: How are you to calibrate the calipers? What is the essence of doing so?

A: Soln:- caliper calibration process :- 1. Firstly you should record the actual temperature and…

Q: The mass of flywheel of an engine is 8 tonnes and the radius of gyration is 1.8 metres. It is found…

A: Given Mass, m = 8 ton = 8000 kg Radius of gyration, k = 1.8 m…

Q: How can you prevent the outbreak of fire?

A: Given question: How can you prevent the outbreak of fire? The given question is related…

Q: A cylinder vessel filled with water with a 2m diameter and 5m high. It was rotated with uniform…

Q: A block with weight (W=75lbs) can move vertically between two smooth walls. It is held by a rope…

Q: 11-75 PtD | Consider a shell and tube heat exchanger in a milk pasteurizing unit in which the milk…

Q: The figure (not drawn to scale) shows a metallic cylindrical column submitted to a combined load:…

Concept explainers

Radiation

Radiation can be described as the energy in the form of a particular matter or electromagnetic waves traveling in the air and can be in the form of light, sound, and heat. Radiation can be detected through special instruments like X-rays. The radiation from a cooler object is less intense as compared to the radiation from hot objects.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1.28 The sun has a radius of and approximates a blackbody with a surface temperature of about 5800 K. Calculate the total rate of radiation from the sun and the emitted radiation flux per square meter of surface area.
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 816C and 260C, respectively. Determine the rate of heat transfer by radiation between the plates in W/m2 and the radiative heat transfer coefficient in W/m2K.
11.31 A large slab of steel 0.1 m thick contains a 0.1 -m-di- ameter circular hole whose axis is normal to the surface. Considering the sides of the hole to be black, specify the rate of radiative heat loss from the hole. The plate is at 811 K, and the surroundings are at 300 K.
Determine the rate of radiant heat emission in watts per square meter from a blackbody at (a) 15C, (b) 600C, and (c) 5700C.
Determine the total average hemispherical emissivity and the emissive power of a surface that has a spectral hemispherical emissivity of 0.8 at wavelengths less than 1.5m, 0.6 at wavelengths from 1.5to2.5m, and 0.4 at wavelengths longer than 2.5m. The surface temperature is 1111 K.
11.68 Two infinitely large, black, plane surfaces are 0.3 m apart, and the space between them is filled by an isothermal gas mixture at 811 K and atmospheric pressure. The gas mixture consists of by volume. If one of the surfaces is maintained at 278 K and the other at 1390 K, calculate (a) the effective emissivity of the gas at its temperature, (b) the effective absorptivity of the gas to radiation from the 1390 K surface, (c) the effective absorptivity of the gas to radiation from the 278 K surface, and (d) the net rate of heat transfer to the gas per square meter of surface area.
1.25 A spherical vessel, 0.3 m in diameter, is located in a large room whose walls are at 27°C (see sketch). If the vessel is used to store liquid oxygen at –183°C and both the surface of the storage vessel and the walls of the room are black, calculate the rate of heat transfer by radiation to the liquid oxygen in watts and in Btu/h.
A long wire 0.7 mm in diameter with an emissivity of 0.9 is placed in a large quiescent air space at 270 K. If the wire is at 800 K, calculate the net rate of heat loss. Discuss your assumptions.
Calculate the radiation heat exchange in 1 day between two black planes having the area of the surface of a 0.7-m-diameter sphere when the planes are maintained at 70 K and 300K.
Calculate the net heat flux per unit area and by radiation between two infinitely large parallel plates with a very small space between them. They both behave as black bodies and are kept at 1000K and 500K, respectively.