A hollow steel has an outside diameter of 5in. and it's inside diameter is 4in. What is the thickness of steel?" O 0.6 in O 1 in 0.5 in 2 in

Q: For the frame shown, a 4998-N load is acting on member ABD at D. If the allowable material shear…

A:

Q: Determine the force in members ac,be,ce,ei & gh of truss shown in figure f h b 3m + 3m 4m g + 4m d +…

A:

Q: Mass-spring system is a comprehensive representation of all vibration systems Ture False O

A: False

Q: (a) Determine the reactions at A and E if P = 790 N. The reactions are positive if to the right or…

A:

Q: 8. In Newton-cotes formula, if f(x) is interpolated at equally spaced nodes by a polynomial of…

A:

Q: Knowing that a system follows the equation of state U = k S5 V2 where k is a constant. Find the…

A: Concept: For adiabatic process, the given relations are used.

Q: Q3/ A cylinder fitted with a frictionless piston contained an ideal gas, with a volume of 23 m³, a…

A:

Q: An electric power plant operating on the Carnot cycle puts heat into a river with a water…

A: Given:TL=15°Cη=40%W=20 MW

Q: B-Prove that the entropy is a property

A: Property is always independent on path of thermodynamics process. It only depends on end state.

Q: Silicone, aluminum, magnesium :and oxygen are

A: To find correct option

Q: A closed vertical cylindrical vessel, 1.80m in diameter, 3m high is 8/10 full of oil (SG=0.85) and…

A: DISCLAIMER FOR MULTIPARTSince you have posted a question with multiple sub-parts, we will solve…

Q: The combined action of the three forces on the base at O may be obtained by establishing their…

A:

Q: Determine the resultant of forces system shown in Figure below and locate it with respect to point A…

A: Given force system: We have to determine the resultant and the position of the resultant for the…

Q: Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100 °C,…

A:

Q: The throttle-control lever OA rotates in the range 0 ≤ 0 ≤ 90°. An internal torsional return spring…

A:

Q: Th 04 A- A steam power plant operates on a simple ideal Rankine cycle The steam enters the turbine…

A:

Q: Which of these non-Intensive ?properties Mass None of them O pressure O Density O O O O O

A: Properties of a system: Intensive Property: The properties of system which are independent of mass…

Q: Q4/ An electric power plant operating on the Carnot cycle puts heat into a river with a water…

A: Given data: TL=15°C=288 Kη=40%W˙=20 MW Need to determine the maximum temperature and quantity of…

Q: Calculate the total power needed from the motor to drive an electrical conveyor belt, which carries…

A: The total power needed from the motor to drive an electrical conveyor is 10.8137 kW.

Q: A closed vertical cylindrical vessel, 1.80m in diameter, 3m high is 8/10 full of oil (SG=0.85) and…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Q.2 Choose the correct answer 1- A collision avoidance system uses .............. to detect a…

A:

Q: B) Write the actual combustion equation for the following cases: a. CH3OH with air at p = 1.0; 4 b.…

A:

Q: Rigid beam AB is supported by three bolts at A and a pin at B. The bolts at A are in double shear…

A: Introduction: A uniform distributed load is a force that is applied uniformly over the length of…

Q: Determine maximum shear stress Maximum principal stress=25 MPa Minimum principal stress=-5 MPa

A: Calculated the maximum shear stress.

Q: Critically analyse the practical solutions manufacturers offer to overcome problematic areas in gas…

A: Given Gas turbine To find Problematic area

Q: robotic arm

A:

Q: Use point A as the reference point for your moment calculations, i.e. sum moments at A. P P -3P 2d…

A:

Q: Determine factor of fafety ?

A: Given;  Principal stress at point in a critical section of a m/c component are;  σ1= 80 MPa  σ2= 5…

Q: A body weighing 445 N is drawn along a rough surface. The force applied in the direction of motion…

A: given; weight of body (w)=445Nforce in the direction of motion (F1)=135Nfrictional force(Fs)=90Nair…

Q: The amplitude of motion in the undamped system is diminishes with time to be then zero Ture False O

A: The general equation of motion for undamped free vibration is given by, x=X e-ζ ωnt×sin(ωd+φ)where,X…

Q: Calculate the magnitude of the tension T and the angle for which the eye bolt will be under a…

A:

Q: The throttle-control lever OA rotates in the range 0 ≤ 0 ≤ 90°. An internal torsional return spring…

A: Given: Moment applied about point O: →M=Kθ+π4                  (where K=550 Nmm/rad)→M=550×θ+π4 And…

Q: The x-coordinate of a particle in curvilinear motion is given by x = 5.3t3-5.1t where x is in feet…

A:

Q: Determine the resultant of forces system shown in Figure below and locate it with respect to point…

A: ◆ The magnitude of the resultant force is 4669.05 kN to the right at an angle of 46.7357° with the…

Q: Find roller support reaction

A:

Q: A steel rod, 2 m long and 20 mm × 20 mm in cross section, is subjected to a tensile force of 40 kN.…

A: Given, Length of the rod = L = 2 m = 2000 mm Cross sectional area = A = 20 mm x 20 mm = 400 mm2…

Q: * Kaolinite is (3:1 minerals) O (2:1 minerals) O (1:1 minerals) O (4:1 minerals) O (5:1 minerals) O

A: To find : Kaolinite is which type of clay mineral

Q: Q2/ Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100…

A:

Q: A block(unit weight = 19.5 kN/m^3) 0.51m square and 331mm deep floats on a stratified liquid…

A:

Q: Task (1) Consider a reheat Rankine cycle with a net power output of 100 MW. Steam enters the…

A: Given data: Net power output (Wnet)=1000 MW. Pressure at intel of high pressure turbine (P1)=10 MPa…

Q: B-Find the internal energy of perfect gas at 1MPa and U.2 is 30 and the adiabatic index of 1.23.

A: The total energy E of a system is basically stored in two modes macroscopic(due to bulk position)…

Q: In adiabatic process, the system has Q=max value W=0 O Q=0 O U=0 * A vertical piston-cylinder device…

A:

Q: (b) A 945L of 2,4-D in acetone has spilled, contaminating an area of soil approximately 300m² and 60…

A:

Q: The components of energy for flowing fluid flow through an inlet are mV² (KE), mgz (PE), and what?

A: The components of energy for flowing fluid flow through an inlet are mV2 (KE), mgz (PE), and what?

Q: 20-mm-diameter hose. Draw the energy and hydraulic grade lines for the hose using a datum at B. 0.4…

A:

Q: Question: By illustrating how the heat engines work in a cycle, summarize the Carnot engine cycle…

A:

Q: Q3/ A cylinder fitted with a frictionless piston contained an ideal gas, with a volume of 23 m², a…

A:

Q: Q1: If the resultant force of the force system shown in Fig.(1) is to be (700 N) directed along the…

A:

Q: In adiabatic process, the system has Q=max. value O W=0 O U=0 O O Q = 0

A: The adiabatic process is the process main process of the thermodynamics. It is the process in which…

Q: 1- A collision avoidance system uses .. to detect a vehicle or another object in front ….... of the…

A: as per our guidelines, we solved only 1 question so understand  1. G-sensor is used to measure the…