Answered: A horizontal curve has a degree of…

A horizontal curve has a degree of curvature of 10. Find the radius. Select one: a. 180 ft. O b. 1800 ft. O c. 5655 ft. O d. 573 ft.

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter15: Geometric Design Of Highway Facilities

Section: Chapter Questions

Problem 16P

See similar textbooks

Related questions

Q: USE THREE MOMENT EQUATION METHOD

A: Using three MOMENT equations calculation of member end moment Calculation ###

Q: Use THREE MOMENT EQUATION MET determine the member end moments of the beam of the rectangular cross…

A: Calculation End Moment of beam using Three Moment Equations ####

Q: For a design a concrete which will be exposed to seawater and sulfates in a structure that comprises…

A: Mix design is the selection and designing of proportion of ingredients needed for producing a…

Q: What are the specific procedures involved in conducting structural database testing, and how does it…

A: Structural database testing focuses on verifying the integrity and functionality of the database's…

Q: The average daily traffic on a stretch of road is 300 commercial vehicles per lane per day. Design…

Q: Express F as a vector in terms of the unit vectors i, j, and k. Determine the magnitude of…

A: The below figure is given;

Q: Annual rainfall at a given location can be described by a normal distribution with a mean of 127 cm…

Q: 3. A concrete floor slab is reinforced by steel rods placed 38mm above the lower face of the slab…

Q: Define the following traverse technical terms. (1) Traverse distance (d) x sin 8 (ii) Traverse…

A: The departure of a line is its projection on the east-west meridian and is equal to the length of…

Q: Determine the elastic curve equation for each span and the maximum deflection for each span.

Q: Rv is 800 ft. SSD is 360 ft. Central angle of the curve is 50 degrees. Find side clearance distance…

A: Radius to the vehicle's travelled path Rv = 800 ft Stopping sight distance SSD = 360 ft Central…

Q: 5.116 A pump is to move water from a late to a large, pressurized tank at a rate of 1,000 gallons in…

Q: how do you find SSD? how is SSD 1.47?how do you determine breaking conditions? How is it 2.5?

A: The speed of the vehicle = 40 mph The gradient of the uphill = 5% To determine:- The value of the…

Q: From the truss shown, design all the tension members using an unequal leg angle with a b of 127mm…

Q: Find the flow Rate " Open Channel

A: Manning roughness coefficient (n) = 0.02 Bed slope, S = 0.004

Q: average time headway is 2 seconds what is the flow? explain hpow you got each step/ number in…

A: The Average time headway is 2 second. For this average time headway we have to find the flow of…

Q: Draw the shear and bending moment diagrams and calculate the maximum normal stress. 25 kN - m 40…

Q: Draw a neat, fully annotated shear force and bending moment diagram, including the maximum in span…

A: The loading diagram is shown below. Hint : Horizontal distance of BD=3 cos45°=2.12 mVertical…

Q: 1) 1.5 m 2.0 m 1.5 m A rectangular footing as shown in the Figure below exerts a uniform pressure of…

Q: Leads with Long curve | = 107°21'42" T, = 800.76 S DL = 6°00'00" (arc definition) Ds = 12°00'00"…

A: Given- I=107°21'42''T=-800.76D=6°00'00"Ds=12°00'00" Formula- L=θ360×πD To Find- Length of short…

Q: For the structural loading shown in Figure 1, draw the shear and bending moment diagram complete…

Q: Given the state of stress shown, determine the normal stress (in MPa) acting on the inclined plane…

Q: 1600 lb B C D 4000 lb 2400 lb G 4 bays@12'-0"=48-0" 9-0"

Q: A raft of 5m x 8m is founded at a depth of 3 m in a cohesive soil having c = 120 kN/m². The ultimate…

Q: Solve for the maximum Deflection if EL=390,000 kN m^2 Use: double Integration method in solving

A: The simply supported beam of a span 15m is given with an overhang of 2m. EI=390000 kN/m2 Ccgg

Q: If the tension in the gantry-crane hoisting cable is T = 14 kN, determine the unit vector n in the…

A: Gantry girders are industrial cranes to carry and transportation of heavy loads. Here, the tension…

Q: 4 years R = 30 cm² Jes (P₂ of Vain fall=130cm, Area = 2500km 2 Find AS

A: Rainfall(P) = 130 cm Runoff(R) = 30 cm3/sec Period = 4 years Area = 500 Km2

Q: The plate is deformed into the dashed shape as shown. If in this deformed shape, the horizontal…

A: L = 303 mm a = 3 mm b = 6 mm determine the average normal strain along the side AB

Q: Q1 A survey conducted to determine the choice of transportation mode (public bus or private car)…

A: Utility function equation Um = Bm - 0.45C - 0.25T

Q: For the load group and influence line shown, P₁ = 32 kips, P2 = 32 kips, P3 = 8 kips, a = 14', and b…

A: Influence diagram for given loading P1 = 32 kips P2 = 32 kips P3 = 8 kips

Q: Data obtained from aerial photograph showed eight vehicles on 200 m long section of road. Traffic…

A: The length of the road section is L=200 m. The number of vehicles are 8. The time headway is T=3…

Q: 15.6 Solve Problem 15.2 for the loading shown in Fig. P15.2 and a settlement of in. at support B.…

A: Given: E = 29000 ksi=201.3876 ksf I = 1650 in4 = 0.07957 ft4 The settlement, h = 0.5 in Analyze the…

Q: Secant piles are often used in beachfront scour protection walls and basement groundwater cut-off…

A: a) Among the supplementary cementitious materials listed, ground granulated blast furnace slag…

Q: The rigid bar BDE is welded at point B to the rolled-steel beam AC. 12kN load is applied 0.75m from…

A: The given beam is, Cross-section is W410*85 MOI, I = 316x106 mm4 Young's Modulus, E = 200 GPa It…

Q: A town produces 8 million litre of sewage per day. BOD of sewage is 260 mg/L, it is to be discharged…

A: Given, Produces of sewage = 8 million/day BOD of sewage, ys = 260mg/L discharge of river, QR = 0.2…

Q: Prob. 2. Is the truss statically determinate? Show your solution

A: The given truss is shown below.

Q: 1) Find the vertical deflection at joint D in mm?

A: Free body diagram: Compute the support reactions: ΣFx=0HA=0RA=5 kNRE=5 kN Inclined member length:

Q: Total degree of indeterminacy (both internal and external) of the plane frame shown in the Given…

Q: Solve for the maximum deflection if EL= 390,000 kn m^2

A: EI = 390000 KNm2 Determine the maximum deflection in the beam.

Q: 5. The 1800-N force F is applied to the end of the I-beam. Express Fas a vector using the unit…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: P5.16 to P5.21. For each beam, draw the shear and moment diagrams, label the maximum values of shear…

Q: A steel frame is shown in the given figure. A L B L O L/2 C 777 El Constant D If joint O of the…

Q: In undisturbed air stream, where the pressure is 14.7 psi and density at standard sea level…

A: V1 = 500 ft/s ; V2= 590 ft/s 1 ft/sec = 0.3048 m/s 500 ft/sec = 152.4 m/s =V1 590 ft/sec = 179.8…

Q: A solid circular shaft of 6m length is built in at its ends and subjected to an externally applied…

Q: 5.3 Four race cars are traveling on a 2.5-mile tri-oval track. The four cars are traveling at…

Q: -X 3 kips 4 3 Y Y -X

A: given- slope= 4/3 f= 3kips Concept- by finding x component and y component- Fx= F cosθFy= F sinθ…

Q: 9-3 Determine the deflections and slopes of section A and point C for following cantilevers.…

A: Since two methods are given, the two cantilever beams are solved using the first method. Analyze the…

Q: Q/Draw SFD and BMD 2m 12 N/m OLB 1m 40 N

Q: 1- Define underground storage tank systems and give some establishments that use USTs

A: Underground storage tank systems (USTs) are carefully designed and constructed…

Q: 1. Refer the Fig. 1. Estimate the side resistance Qs by a. Meyerhof's method. K= 1.5 and 8' 0.6 Ø1…

A: Size of the concrete pile:- D= 460mm k= 1.5 L= 20m To find: (a) side resistance Qs by Meyerhof's…

Concept explainers

Electronic Spreadsheet

Tabular listing has many advantages ranging from time management to efficient scheduling of tasks. Electronic spreadsheets allow the user to tabulate and analyze data, using its easy-to-use interface. An electronic spreadsheet is a staple application used among accountants, management staff, and IT professionals. It is used in various sectors worldwide for data management. An electronic spreadsheet is a system and computer software that could be used to do numerical computations automatically. Spreadsheet application programs are often organized as a table with rows and columns. Each row and column intersect to form a cell, which may be used to store data. These data can take the form of a written label, a number, or a formula that combines information from other cells.

Question

A horizontal curve has a degree of curvature of 10. Find the radius.
Select one:
a.
180 ft.
b. 1800 ft.
c. 5655 ft.
O d. 573 ft.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction.

VIEW

Step 2: Considering 20m arc.

VIEW

Step 3: Considering 30m arc

VIEW

Solution

VIEW

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 3-degree simple curve is used to connect two highways whose bearings are S11°W and S47°W. What is the length of the curve in meters?
Determine the distance between two parallel tangents of a reversed curve with the following properties: I= 20-degree, D1= 3.2-degree & D2= 4.6-degree.
A 3-degree curve has an angle of intersection of 24° What is the length of the long chord in meters? Use chord basis.
A 3 degree curve has an angle of intersection of 24 degrees. What is the length of the long chord in meters? Use chord basis
Please include figures and solutions An unsymmetrical parabolic curve has a forward tangent of 5% and a backward tangent of -3%. The length of curve on the left side of the curve is 120m while that of the right side is 90m. If the vertex is at station 5+040 is at elevation 101m, determine the elevation of the curve at station 4+980. ANS. 103.31m
A 3-degrees simple curve is to be laid out having a central angle of 39 degrees. If the station of P.I. is 2+250, what is the station of P.T.?
A certain horizontal curve has a central angle of 31.9°. If STA PC is 18+303 and STA PT is at 18+747, determine the station of PI.
The slope of the forward tangent of a parabolic curve is +4.2%, while the slope of the back tangent is -3.6%. The length of the curve is 120m long with elevation of the PC equal to 82.77. Determine the elevation of the curve directly above the PI.
a horizontal curve has I = 28.5 degrees, R = 750 ft . What is the length of the curve? If the curve has a PC at station 89+45+00 what is the station at PT? please show step
If the offset distance from tangent to SC is 5.70 m while length of spiral is 80 mm, what is the radius of the curve
A vertical sag parabolic curve has tangent grades of -2% and +3%. Compute the length of curve if the required sight distance is 178m. a. 218.15 m b. 212.66 m c. 234.45 m d. 271.12 m
Two tangents AB and BC intersect at point B at chainage 150.5 m. Calculate all the necessary data for setting out a circular curve of radius 100 m and deflection angle 30⁰ by the method of offsets from the long chord