A horizontal cylinder equipped with a frictionless piston contains 785 cm3 of steam at 400 K and 125 kPa . A total of 83.8 joules of heat is transferred to the steam, causing the steam temperature to rise and the cylinder volume to increase. A constant restraining force is maintained on the piston throughout the expansion, so that the pressure exerted by the piston on the steam remains constant at 125 kPa. (a) Taking the steam as the system, show that Q = ∆U for this process. Then find that the final steam temperature. (b) Calculate the final cylinder volume, the work and the change in internal energy.

Q: Air enters a compressor at 1 atm, 300K then exits at 10 atm. What would bethe work needed per unit m...

A: To find work needed per unit mass of air in  (a) adiabatic and reversible compression (b) isothermal...

Q: Determine the quality of 350 kPa of pressure steam when 270 kJ / kg of energy is lost from the satur...

A: Initially, the steam is saturated at 350 kPa. Use the standard saturated steam table to get the enth...

Q: Determine the quality of 170 kPa of steam when 470 kJ / kg of energy is lost from the saturated vapo...

A: Given, Pressure of the steam, P = 270 kPa From steam tables, the thermodynamics properties  at 270 k...

Q: Petroleum oil of 0.9 specific gravity and 13 centipoise viscosity flows isothermally through a horiz...

A: Given: The reading on the manometer is 3 ft.  that means h=3 ft And acceleration due to gravity g=32...

Q: A material consisting originally of 25 mm particles is crushed to an average size of 7 mm and req ir...

A: a. The Rittinger's law is given as, E=Kr1Dsb-1Dsa        ........(1)Where,E=required energyDsb=Avera...

Q: Write down the equations and the product/s formed by the reaction of cyclohexene with bromine water?

A: There are cases for the reaction between Cyclohexane and bromine water. Case(1): No reaction takes p...

Q: Consider a steel pipeline (AISI 1010) that is 1 m in diameter and has a wall thickness of 40 mm. The...

A:

Q: A balloon is filled with 8.22g of helium gas in a room at sea level. The pressure inside the balloon...

A:

Q: Consider a steel pipeline (AISI 1010) that is 1 m in diameter and has a wall thickness of 40 mm. The...

A:

Q: Calculate the percent Fe (AW = 55.85) in a 0.2802 gram sample that requires 29.68 mL of 0.01831 M K2...

A:

Q: For TLC analysis, a student calculates the following Rf values for her samples: 0.69=aspirin; 0.80=I...

A: The identity of the unknown is to be determined in the given analysis.

Q: An engineering professor weighs 200 lbf. Express the mass and the weight of the professor in SI and ...

A: Weight of an object is defined as the product of mass and acceleration due to gravity. W = mg Here, ...

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp of flow with a rate of 0...

A:

Q: Number 7

A: Given data: 10cm cube is heated to 100oC. Normal derivatives on the sides are zero, since the block ...

Q: The gaseous compound BrCl decomposes at high temperature in a sealed container: 2 BrCl(g)           ...

A:

Q: If the measured input to a PI controller is a step change(Yₘ(s)=2/s) and the controller output chang...

A: The controller output of the integral control is pt=p+Kcet+1?1∫0tet* dt* Here, ?1=integral timeet=...

Q: Using the steam table, determine the enthalpy change of 1 kg of water for each of the following case...

A:

Q: Q2.  Calculate the ideal air standard cycle efficiency based on the Otto cycle for a gas engine with...

A: Given: Cylinder bore: dB = 50 mm Stroke: LS = 75 mm Clearance volume: 21.3 cm3  

Q: Consider the following reaction where K,1.29x10 at 600 K: 123 (3) + () 00 () p0) A reaction mixture ...

A: Given data: Number of mole of CoCl2 = 0.129 mol Number of moles of CO = 5.08 ×10–2 mol Number of mol...

Q: the concentration of alcohol in the bloodstream (Blood Alcohol Consumption, BAC) surges as the alcoh...

A:

Q: The molarity of a solution is o.85 and the normality of the same solution is 5.10. What is the norma...

A:

Q: Consider a steel pipeline (AISI 1010) that is 1 m in diameter and has a wall thickness of 40 mm. The...

A: Given:- Inner diameter DI=1 mOutter diameter DO=1+0.040 m=1.040 mFluid temperature Tf=60C∘inner sure...

Q: In a pharmaceutical plant, a copper pipe (kc=400 W/mK) withinner diameter of 20 mm and wall thicknes...

A: Given:-

Q: What is the definition of logarithmic mean in mass transfer?

A:

Q: A mixture of n-hexane vapor and air leaves a solvent recovery unit and flows through a 70 cm diamete...

A:

Q: Asuume equimolar mixer.

A: Given data: The graph of partial molar volume of an equimolar mixture of propylene (1) and benzene (...

Q: a solution of organic colloids is to be concentrated from 15 to 50 percent solids in a vertical-tube...

A: Assume the basis as 1 hr. Let the mass of solution feed be mf. mass of evaporation of water, E = 25,...

Q: What is the molar solubility of AgCl in a solution that is 2.0 M of NaCN?

A:

Q: In an electroplating operation, the cell potential is sometimes 0 V. Why is a zero potential possibl...

A:

Q: The successive reactions in the manufacture of HCI from salt and sulfuric acid may be represented by...

A: Given: NaCl+H2SO4→NaHSO4+HCl......................1NaCl+NaHSO4→Na2SO4+HCl....................2 Molec...

Q: What is called a fixed phase and mobile phase in chromatography? Does every type of chromatography h...

A: Chromatography is a type of separation technique used to separate components in a mixture. The mixtu...

Q: What factor allows molecules to be separated by chromatography?

A: Chromatography is a process used for the separation of mixture components . For this process Mixture...

Q: Classify each molecule as polar or nonpolar.

A:   CO32- = Non-polar Using VSEPR or Lewis structure rationale, carbonate (CO32- ion) ion is non-polar...

Q: MgCl₂ has a van't Hoff factor of 2.70. What would be the boiling point (in °C) of an aqueous solutio...

A: Given data: Van't Hoff factor (i) of MgCl2=2.70 Kb for water = 0.51oC/m We are asked to find out the...

Q: Calculate the value of ∆H°rxn for the reaction: N2H4(l) + O2(g) → N2(g) + 2 H2O (l) Using the follow...

A: Write the reactions as follows: N2O (g) + 3 H2 (g) → N2H4(l) + H2O (l); ∆Hrxno= -317.0 kJ Multiply w...

Q: Is the rate of air flow is equal to 81,500kg/hr??

A: As you have asked for rate of air flow i.e. part B , so i am assuming that you have solved for R(rec...

Q: At 600 K and 5.0 bar, the degree of dissociation of PCl5(g) is 0.920. Phosphorus pentachloride therm...

A: (a)   Let α be the degree of dissociation for the given reaction. Now, PCl5g⇌PCl3g+Cl2g1−α         α...

Q: Coal gasification consists of the chemical transformation of solid coal into gas. The heating values...

A: Given data: Gross heating of fuel = 29770 kJ/kg The composition of cola is given as: C = 71 % H2 =5....

Q: The flow rate through the pipe is 14999 L/hr. The pipe is new commercial steel pipe with an internal...

A:

Q: Is it always possible to identify any unknown liquid correctly by density measurement only? Explain ...

A: No, It is not possible to identify any unknown liquid correctly by density measurement, only.

Q: Radium decomposes at a rate proportional to the amount present. If half of the original amount disap...

A: The percentage loss of radium in 200 years is to be determined.