Question

Asked Nov 3, 2019

3 views

Find out the value of the current i_{0} and voltage v_{0}.

Step 1

According to Kirchhoff’s current law (KCL), total current entering a node is equal to the total current leaving a node.

Now, applying KCL at node* a*, the following equation can be obtained:

Step 2

From equation (1), the value of the current *i _{0}* becomes

Step 3

Now, the voltage *v0* is the voltage drop across the 4-ohm resistor. Therefore, the ...

Tagged in

Q: Exercise: A sinewave voltage with amplitude 2 V and frequency 500 Hz is applied across an ideal indu...

A: Drawing the circuit by using the given data from question:

Q: Finel)inefollo Can ollomh -0 et 2v2 ols) Lo

A: When t < 0, the switch is open and there is no independent source connected to the circuit.So, at...

Q: .il Verizon LTE 7:42 PM 100%- Done 2- In the following circuit find ve) and i(t) given; y(1)-240 V ,...

A: We have been given with below values: -v1(t) = 240V, v2(t) = 120V, L=1H, C = (1/16) F and R=2 Ohm fo...

Q: A sinewave voltage with amplitude 2 V and frequency 1 kHz is applied capacitor. The capacitance is 0...

A: Given parameters are,

Q: I need to find the Thevenin equivalent.

A: The Thevenin equivalent voltage across ab can be calculated as,

Q: In the following circuit, use two different methods (Nodal Analysis, Mesh Analysis, or using Theveni...

A: Let us find the Nortons's Current (Isc) :

Q: 3. For the following circuit determine (include and show all the steps): (4 marks) a. Total impedanc...

A: consider that the total impedance of the circuit is Z.

Q: why 3-phase power has replaced 2-phase power.

A: Three phase system has phase difference of 120 degrees.Phasor diagram of 3 phase system is –

Q: Could you please help me on this problem and also explain what the difference is between a loop and ...

A: The circuit is given as: