a) In the circuit of Fig(1), if Vab = 400 10°, Vbc = 400 250° , Vca = 400 2130° V, find the line currents. %3D 3+ j22 1 10-j8a 3+ j20 1 10-j8n Fig(1) Va 10-j82 3+ j22 1 b) For the two – port networks prove that Z10 A = Z20 - Z2s

Q: A transmission line of 50 m long as shown in the figure below has Zo = 40 + j70 2, V. = 20 20 Vrms,…

A:

Q: 802 802 Q.22: For the following electnic circuit, find Z and Y parameters? Also, compute input and…

A: Given data:

Q: Example 17.3-1 (Companion Problem 1) (See Example 17.3-1 in the textbook for the solution to a…

A: Companion problem 1 Relation between Voltage and current for Z-parameter is given by

Q: Currents Il and 12 entering at port 1 and port 2, respectively of a two-port network are given by…

A:

Q: b) For the two – port network shown in fig.(7), Z11=92, Z12=62, Z21=62 and Z22=122, find: 1- The…

A:

Q: For the circuit shown, the following parameters are given: E=12020° V I=0.5260° A R=20 2 X,=Xc=20 2…

A: The solution is given below

Q: Exercise 17.3-1 (Companion Problem 1) Consider this two - port network: 53 Q ww + 41 63 Q Determine…

A: Companion Problem 1:-Apply Kirchoff’s current law at the nodes of the given circuit.

Q: b) For the two – port network shown in fig.(7), Z1=92, Z12=62, Z21=62 and Z22=120, find: 1- The ABCD…

A:

Q: If the Z parameter matrix of a two-port network is given by Z11 = 2- j4 Q Z12 = -j4 0 Z21 = -j4 0…

A:

Q: (a) Show that the transmission parameters of two-port network can be represent by Y parameters as…

A:

Q: Problem: 10 for the following circuit: + Find the Two-Port Admittance Matrix Form: V1 10 10 V2 CH…

A:

Q: HW.1: Given that vbn = 1104300 V, find van and ven assuming a positive (abc) sequence. 20 HW.2:…

A: Since you have asked multiple questions so we are solving first one for you . To get remaining…

Q: A network and its (ABCD] parameters are given below. Accordingly, find out the component value and…

A:

Q: Find the ABCD constants of the four-terminal network resulting when a resistance of 10 ohms is…

A: ABCD parameters can be expressed in matrix form as…

Q: b) For the two – port network shown in fig.(7), Z=92, Z12=6N, Z21=6N and Z22=12Q, find: 1- The ABCD…

A:

Q: (c) A two-port network with transmission parameter, A= 4, B = 302, C = 0.1S and D= 1.5 is shown in…

A:

Q: The S parameters of a 2-port network is given as 0.220° Lo.7260° 0.752- 45°1 0.2020° %3D (a) Is this…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Q4) A transmission line is 2 m long and operates at w = 106 rad/s and has = 1 rad/m, a = 4 dB/m, &…

A: Given-   ωo=106 rad/sβ=1 rad/mα= 4 dB/mVs=15∠0° VZo=60+j40 ohmZg=40 ohmZL=20+j30 ohmLength, l= 2 m

Q: 12 V 2.7 k2 10 μΕ HE Ris V Ipss = 10 mA Vp = -6 V 0.6 k2 10 µF Z. RL2 4.7 kN 1 M2 0.51 k2 20 µF FIG.…

A: First we will do DC analysis to find out transconductance then we will do ac analysis to calculate…

Q: Analytical Questions 4) Consider the two-port network shown below: Portl 15 0 36 O Port2 500 0 50…

A: The expression for the two-port network for the s-parameter is given by: V1-=S11V1++S12V2+…

Q: A causal LTE system has system function 1-z-1 H(z) = 1-1.5z-1 -z-2 Determine the input x[n] so that…

A: A discrete LTI system can be represented by its system function H(z) or impulse response h[n].…

Q: = 6 mA, Vp -6 V, and yos Determine Z, Zo, and A, for the network of Fig. 9.56 if Ipss 40 μS.

A: It is given that: IDSS=6 mAVP=-6 VYos=40 μSRG=1 MohmRD=2 kohm

Q: b) For the two port networks prove that: Z1,Z1s A %3D | Z2s(Z10-Z1s)

A:

Q: Question 3. Consider a causal LTI system whose input x[n] and output y[n] are related by the…

A:

Q: For the electric two-port circuit shown, write the voltages w.r.t currents equations (Z-Parameters).…

A: The two port network, the z parameters are  V1=z11I1+z12I2V2=z12I1+z22I2 z11 is calculated by open…

Q: Problem 2: Two cascaded system is shown below. If the transmission parameters of the Network N1 and…

A:

Q: For the two-port network shown, calculate the maximum average load power. | Z1=200$2 R$ Z12-2052…

A: Two Port Network: A two-port network has one pair of input terminals and one pair of output…

Q: Q6: The system shown in fig. below is an alternative to the one shown in fig. of Q3 for sending two…

A:

Q: 5. For the network of Fig. 10.47: (a) Determine AN, Zi, and Z. (b) Sketch the two-port model of Fig.…

A: As per the guidelines, we are supposed to answer the first three-part of the question at a time so…

Q: (b) A lossless 4-port power divider is shown in Fig. 3. This power divider is perfectly matched and…

A: Impedance The measure of opposition to AC-DC electricity, electronic component, circuit, etc. that…

Q: A two-port network is driven at both ports such that the port voltages and currents have the…

A: Given Data: Zo = 50 ohm

Q: Q1) For the two-port network shown in Figure (1) below, obtain the Y-Parameters and state whether…

A: Given:

Q: Q2/ For the Two Port Network shown below find the impedance (Y) parameters i 302 1002 + 40Ω 602 12vx

A:

Q: Z129 Za402 34: For the two-port electric network shown in fgure beside, calculate the maximum power…

A:

Q: A 3-phase, 60 Hz, long transmission line of 442km has |Vs| = 1.0 p. u., and |VR| 90% of V, Line…

A: Given: f=60Hz, l=442km Vs=1pu VR=90% of Vs Zc=450 ohm θmax=40° P=8750MW Vrated=820KV

Q: Q5: The system shown in fig. below can be used for sending two messages on one carrier. (a) If fi(t)…

A: a) Given- f1t=cosω1t and f2t=cosω2t then we can write, y1t=f1tcosωct       = cosω1t+cosωct       =…

Q: Q2: Answer two of the following questions: a) Determine the Z parameters for the two-port shown in…

A:

Q: 24. Determine Z, Zo, and A, for the network of Fig. 8.75 if Ipss = 6 mA, Vp = -6 V, and 8os = 40 µS.

A: Given Data: Idss = 6 mA Vp = -6 V yos= 40 us

Q: The S-parameters of a 2-port network are given by 0.5+ j0.5 [0.95+j0.25 (S] = l095 0.15-j0.05]…

A: As per our policy, i am attempting first three question. Given S- parameter,…

Q: Considering the following circuit, find the Z parameters of a reciprocal network (that is, z_12 =…

A:

Q: b) For the two - port networks prove that: Z1,Z1s A = Z.2s(Z10- Z15)

A:

Q: For the two - port network shown in fig.(2), Zı=92, Z12=62, Z2ı=62 and Z22=12Q, find the ABCD…

A:

Q: 21. Derive Ar, Zí and Zo for the cct shown, Rs G Rd

A: We need to find gain and input, output impedance for given circuit.

Q: Q2. For the two-port circuit shown in the Figure, Let, Z1 = 10, Z2 = -6. Za =-4, Z2 = 12, Find : 1.…

A: In the circuit, Two port Z parameters are given. We know V1 = Z11 I1 +Z12 I2  V2= Z21 I1 +Z22 I2…

Q: a) Choose the Correct Answer 1. The impedance parameters Z11 and Z12 of the two-port network in the…

A: "Impedance parameter(Z-Parameter)" is defined as the total impedance offered by the transmission…

Q: The Z- parameter of the two – port network N in Fig. 6 areZ1 = 4s, Z12 = Z21 = 3s, and Z22 = 9s.…

A: A general network having in two pairs of terminals, one perhaps labeled the input terminal and the…

Q: Given the Y-parameters of a two port Network, in order to calculate Z11 then Select one: Z1 = Y1 Z1…

A:

Q: The z-parameters of the two port network shown in the figure are z,,= 40 2, Z,, = 60 2, Z = 80 2 and…

A: Given:  Brief description: Here in the above given question they want to know the value of average…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.