A lightweight rope is wrapped around a drum as shown in Fig. drum and the ground is 0.30. Determine the maximum an- gle 8 such that the drum does not slip. Also determine the tension in the cable for this angle if the drum weighs 100 N. The coefficient of friction between the 60°

A lightweight rope is wrapped around a drum as shown in Fig. drum and the ground is 0.30. Determine the maximum an- gle 8 such that the drum does not slip. Also determine the tension in the cable for this angle if the drum weighs 100 N. The coefficient of friction between the 60°

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.55P: A wedge is used to prop up the 6000-lb block of marble. The wedge angle is =30, and the angle of...

See similar textbooks

Related questions

Q: n the figure shown, compute the minimum value of θ so that there is impending motion of the block.…

A: To determine the minimum value of θ

Q: Determine how far up the ladder the man can climb (in m) before the ladder starts to slip if the…

Q: QI-The W=250o-N block shown in Fig. below is in contact with 30° incline. The coefficient of static…

A: Given W=2500 N μs=0.25 P=? θ=30o

Q: : Boxes A andB with weight of 250 N and 200 N, respectively shown in Figure (1). Determine the…

Q: A (400 N) block is resting on a rough horizontal surface for which the coefficient of friction is…

Q: In the figure shown, compute the minimum weight W to prevent impending motion of the block up the…

A: Given:- m=100lb θ=45° μ=0.45 To find:- Weight of W

Q: If the coefficient of friction is 0.25, calculate the tension T in the cable to raise the load. Find…

A: Given:Coefficient of friction, μ=0.25mass, m=800 kg

Q: Block A in figure 3 below has a mass of 4 kg and is on the verge of tipping as it begins to slide…

A: According to the details provided in the question, we need to calculate the coefficient of the…

Q: In figure shown, determine the value of P just sufficient to start the 10 degrees wedge under the…

Q: A block weighing 500 N is held by a rope that passes over a horizontal drum. The coefficient of…

Q: Two blocks with masses mA = 20 kg and mg = 80 kg are connected with a flexible cable that passes…

A: Write the given data:

Q: Q2: The ladder in fig.(1), has a uniform * weight of 100N and rests against the wall at B.If the…

Q: Find the least value of P that will just start the system of blocks shown in the figure. moving to…

Q: Determine the smallest force the man must exert on the rope in order to move the (162 kg crate shown…

A: 1 2

Q: Determine the range of weight (W) that the block shown in figure (3) may have, which will make it…

A: For solution refer below images.

Q: Determine the smallest force the man must exert on the rope in order to move the (160 )kg crate…

Q: The weight of the box is W = 150 N and the coefficient of static friction between the box and the…

A: Given dataWeight of the box W = 150NCoefficient of static friction between the box and floor μ =…

Q: The crate has a weight of W = 350 lb and the coefficient of static Friction between the crate and…

Q: Calculate the minimum coefficient of static friction for each contact location to prevent the pole…

A: Free body diagram for the given figure; Given Data Mass of the pole, m=135 kg Length of the pole,…

Q: The coefficient of friction between 200 Ib homogeneous cylinder and the horizontal plane is 0.4 as…

A: Write the expression of friction force in case of slipping. Fk=μkN=μkW But, in this case…

Q: Q3/. Determine the maximum force P that can be applied without causing movement of the 200 lb crate…

A: Given, W = 200 lb μs = 0.4 There are two possible movements of crate. (i) Slipping movement (ii)…

Q: Given the coefficient of friction for all surfaces A, B, C, and D Is0.30. Neglect friction at the…

A: Given: μ=0.30 WA=20KN WB=15KN WC=15KN WD=10KN

Q: 1.) Compute the weight of block B that will prevent the two block system from sliding. Block A…

Q: The crate has a weight of W = 350 lb and the coefficient of static Friction between the crate and…

Q: A lightweight rope is wrapped around a 25-lb drum . The coefficient of that is 3 ft in diameter (see…

A: Draw the free body diagram for the above system.

Q: A bumper jack, used to raise the wheel of an auto- mobile in order to change a tire, is shown in…

A: Given: p=pitch of the screw=6 mm d=mean diameter of screw=30 mm W=weight of the automobile=3KN…

Q: (a) A force F pushes on a 25kg box as shown in the figure. The coefficient of static friction…

Q: From the given figure, determine the value of the horizontal force P if the coefficient of static…

Q: The block of weight W = 10 kN is pulled by the force P inclined at the angle 0 = 15° to the…

Q: Determine the range of weight (W) that the block shown in figure (3) may have, whi make it neither…

Q: In the figure shown, compute the minimum value of 0 so that there is impending motion of the block.…

A: Given data as per question Mass of block =550 lb u =0.20 Calculations Considering FBD of system…

Q: A block with weight (W=75lbs) can move vertically between two smooth walls. It is held by a rope…

Q: 4. The weight of the box is W = 90 N and the coefficient of static friction between the box and the…

Q: 0: The maximum weight is( body.The coefficient of friction between all surfaces is ( 0.3 ), and the…

Q: When a force of 500 N pushes on a 25 kg box as shown in the figure, the acceleration of the box up…

Q: Determine the coefficient of static -friction force

A: Given: To determine: Coefficient of static friction

Q: A solid strut attached to each block is a frictionless pin that connects the two blocks. If the…

Q: A bumper jack, used to raise the wheel of an auto- mobile in order to change a tire, is shown in…

A: Here we have GivenQ=Applied load=3 kNp=pitch of the screw=6 mmμ=Coefficient of friction=0.03R=200…

Q: The crate has a weight of 100 Ib and a center of gravity at G rests on the floor for which the…

Q: Determine the smallest force the man must exert on the rope in order to move the (136 kg crate shown…

Q: 02 A block of 15 kg was place on an indined surface as shown in Figure 2. If the static coefficient…

A: Whenn an external force is applied to a body ,it does not ,move because frictional force balance the…

Q: Determine the smallest force the man must exert on the rope in order to move the (160)kg crate shown…

Q: P Ms= 0.20

Q: Determine the smallest force P that must be applied in order to cause the 150 lb uniform crate to…

Q: The crate has a weight of W= 350 lb and the coefficient of static Friction between the crate and the…

A: Given Data Weight of the crate, W=350 lb Angle = 45 degree Coefficient of static friction, 0.3…

Q: A 25 kg ladder, 4m long, rest on a rough floor and against a vertical wall. The ladder makes an…

Q: The crate has a weight of 490 lb and a center of gravity at G rests on the floor for which the…

A: Vector is a physical quantity that has magnitude and direction both. Scalar is a physical quantity…

Q: Consider the situation shown where a 15-kg box is to be held on a steep vertical slope by a cord…

Q: a A crate, which has a weight of W, is placed on an inclination. The force P is applied to prevent…

A: Law of Static equilibrium: A body is said to be in static equilibrium if it satisfies the following…

Q: 4. Determine the smallest horizontal for P required to pull out a wedge A. The crate has weight of…

Question

A lightweight rope is wrapped around a drum as
shown in Fig.
drum and the ground is 0.30. Determine the maximum an-
gle 8 such that the drum does not slip. Also determine the
tension in the cable for this angle if the drum weighs
100 N.
The coefficient of friction between the
60°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Trending now

This is a popular solution!

Step by step

Solved in 6 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The block of weight W is pulled by the force P inclined at the angle to the horizontal. Find the smallest force P and the corresponding angle that would cause impending sliding of the block. The angle of static friction between the block and the ground is s.
The square-threaded screw 0f the C-clamp has a mean diameter of 8 mm and a pitch of 1.6 mm. The coefficient of static friction between the threads is 0.2. If the torque C=1.50Nm is used to tighten the clamp, determine (a) the clamping force; and (b) the torque required to loosen the clamp.
A wedge is used to prop up the 6000-lb block of marble. The wedge angle is =30, and the angle of static friction is s=12 between all contact surfaces. Determine the smallest force P that would prevent the wedge from sliding out.
A 1.1-kg disk A is placed on the inclined surface. The coefficient of static friction between the disk and the surface is 0.35. Is the disk in equilibrium if P=5.5N and =30?
The screw of the clamp has a square thread of pitch 0.16 in. and a mean diameter of 0.6 in. The coefficient of static friction between the threads is 0.4. Determine (a) the torque C0 that must be applied to the screw in order to produce a 28-lb clamping force at A; and (b) the torque required to loosen the clamp.
The test specimen AB is placed in the grip of a tension-testing machine and secured with a wedge. The coefficient of static friction at both surfaces of the specimen is s. If the wedge angle is =18, determine the smallest s for which the grip is self-locking (no slipping takes place regardless of the magnitude of the force P). Neglect the weight of the wedge.
The single-threaded screw of the floor jack has a pitch of 0.5 in. and a mean radius of 1.75 in. The angle of static friction is 8.5. (a) Determine the couple C that must be applied to the screw to start lifting a weight of 4000 lb. (b) What is the couple required to start lowering the weight?
Two identical chairs, each weighing 14 lb, are stacked as shown. The center of gravity of each chair is denoted by G. The coefficient of static friction is 0.2 at B (the contact point between the chairs) and 0.35 at A, C, and D. Determine the smallest force P that would cause sliding.
The leather rein used to fasten the horse to the hitching rail weighs 3.5 oz per foot. The coefficient of static friction between the rail and the rein is 0.6. If a 34-lb force acting on the bridle is sufficient to restrain the horse, determine the smallest safe length L for the free end of the rein.
The square-threaded screw with a pitch of 10 mm and a mean radius of 18 mm drives a gear that has a mean radius of 75 mm. The static and kinetic coefficients of friction between the gear and the screw are 0.12 and 0.06, respectively. The input torque applied to the screw is C0=10Nm. Assuming constant speed operation, determine the output torque C1 acting on the gear.
The force P applied to the brake handle enables the band brake to reduce the angular speed of a rotating drum. If the tensile strength of the band is 3800 lb, find the maximum safe value of P and the corresponding braking torque acting on the drum. Assume that the drum is rotating clockwise.
A uniform plank is supported by a fixed support at A and a drum at B that rotates clockwise. The coefficients of static and kinetic friction for the two points of contact are as shown. Determine whether the plank moves from the position shown if (a) the plank is placed in position before the drum is set in motion; and (b) the plank is first placed on the support at A and then lowered onto the drum, which is already rotating.