A line was measured using a tape that is suspended with a pull of 145 N on both ends. The mean temperature during the measurement was 14°C. The whole length of the line was measured with 4 consecutive spans/segments. The tape was supported only at the ends of each segment when the measurement was done. The measured segments of the line are as follows: 29.988 m, 29.895 m, 29.838 m, and 29.910 m. Therefore the total length of the line measured was 119.631m. The tape was standardized with the following parameters: Standard pull = 95 N Standard temperature = 14°C Cross-sectional area = 3.35 mm^2 weight per length of the tape = 0.24525 N/m Coefficient of linear expansion = 0.9 x 10^-6 per °C Young's modulus = 14.8 x 10^4 MPa

A line was measured using a tape that is suspended with a pull of 145 N on both ends. The mean temperature during the measurement was 14°C. The whole length of the line was measured with 4 consecutive spans/segments. The tape was supported only at the ends of each segment when the measurement was done. The measured segments of the line are as follows: 29.988 m, 29.895 m, 29.838 m, and 29.910 m. Therefore the total length of the line measured was 119.631m. The tape was standardized with the following parameters: Standard pull = 95 N Standard temperature = 14°C Cross-sectional area = 3.35 mm^2 weight per length of the tape = 0.24525 N/m Coefficient of linear expansion = 0.9 x 10^-6 per °C Young's modulus = 14.8 x 10^4 MPa

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1025ft2 * 8ft = Convert answer to m3
Show complete solution SN = 76
A c-channel has a dimension of as shown in mm, with a thickness of 75mm. Determine the moment of inertia about x- axis, if the axis is also tye neutral axis. I=2, J=7, K=0
Length of B2 is 4 meters
Solve Part 3 and Part 4 only
A jet issues from the side of the tank under a head of a=4.36m. The orifice is positioned 5.94 meters above the bottom of the tank. Determine the point it strikes a horizontal plane c=1.17m below the bottom of the tank. Assume the jet will follow a projectile motion. The angle is 47 degrees and Cv=0.938.
Find the moment of inertia about the x' axis of the channel cross-section if the channel material has uniform thickness of 0.5 in.
A 30-m band standardized at 20°C was found to be 30.003 m. At what temperature is the tapeexactly30 m? Coefficient of expansion of steel = 0.000 011/°C.
Only correct solnm.
An instrument is setup at point A, and the rod at B. Elevation of point A is 300m. Height of instrument is 1.75m. Stadia Interval Factor = 100 Vertical angle = 7 degrees Middle Reading = 1.75 m Stadia Intercept = 60 m Stadia Constant = 0.30 Required: Solve for the elevation of B
Find centre of gravity from free surface
Calculate plastic Neutral Axis