A magnetically coupled coil has mutual reactance of 5.655 ohms, inductive reactance in coil 1 of 15 ohms, inductive reactance in coil 2 of 10 ohms, supply voltage of 220 volts and voltage at the load of 200 volts. If the product of number of turns of coil 1 and coil 2 is 150,000 and their sum is 800, calculate the magnetic fux in coil 2. Use 60 Hertz frequency.

A magnetically coupled coil has mutual reactance of 5.655 ohms, inductive reactance in coil 1 of 15 ohms, inductive reactance in coil 2 of 10 ohms, supply voltage of 220 volts and voltage at the load of 200 volts. If the product of number of turns of coil 1 and coil 2 is 150,000 and their sum is 800, calculate the magnetic fux in coil 2. Use 60 Hertz frequency.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A solenoid coil needs to be manufactured which produces an inductance of at least 2000 Gauss (in SI system = Tesla) when a 10mA current flows through the conductor. Due to space limitations, the coil should be composed of 10 turns over a 1cm length. Do the required calculations and select a core material for the coil from the table below. Your answer will be given over the following series of questions. A. H = 0.12566 oersted B. H = 12.56637 oersted C. H = 1.25664
Given a two magnetically coupled coils -coils physical structure is P11=P22 -self-inductance of coil 1: 288mH -coefficient of coupling: 0.75 -mutual inductance: 90mH -wound on a nonmagnetic core Determine the turns ratio N1/N2 BLANK If N1 =1200, what is the value of P1? BLANK micro
A solenoid coil needs to be manufactured which produces an inductance of at least 2000 Gauss (in SI system = Tesla) when a 10mA current flows through the conductor. Due to space limitations, the coil should be composed of 10 turns over a 1cm length. Select a suitable core material for the manufactured solenoid coil from the table. A. MnZn Ferrite B. 4750 alloy C. None of the mentioned/ Geen van die genoemde D. Silicon iron
Show complete solution. 18. A 2000-turn coil is uniformly wound on a ring mean diameter 320 mm and cross-sectional area 400 mm². Calculate the inductance of the toroid. Assume the permeability of the core is 1000. Answer: 2H 19. The coils of an electromagnet have an inductance of 0.2 H and are carrying a current of 8 A. What will be the value of self induced emf when the current is reversed in 0.02 s. Answer: 160 V
1. Determine the force in pounds upon each side of a coil of 40 turns carrying a current of 15 A if the axial length of the coil is 10 inch and flux density is 20,000 lines per square inch. The conductors are at right angles to the flux.? 2. Two coupled coils with L1= 20 mH, L2 = 10mH and k = 0.5 are connected in series opposing. Determine the total inductance.?
Choose correct answer ? Mutual inductance between two magnetically coupled coils depends on the ........................ * Current direction and coupling coefficient Dot polarity and coupling coefficient Current direction, coupling coefficient and dot polarity Current direction and dot polarity
Given a two magnetically coupled coils -coils physical structure is P11=P22 -self-inductance of coil 1: 288mH -coefficient of coupling: 0.75 -mutual inductance: 90mH -wound on a nonmagnetic core Determine L2 Blank 1 milli If N1 =1200, what is the value of P2? Blank 2 micro
Show the complete solution. 1. A solenoid 20 cm long is wound with 300 turns of wire and carries a current of 1.5 A. What is the approximate relative permeability of this core so as to produce a magnetic field of 0.6 T inside? A. 225 B. 212 C. 210 D. 280 8. Two coils have inductance of 4 mH and 9 mH and coefficient of coupling is 0.50. If the two coils are connected in series opposing, the total inductance will be A. 10 mH B. 8 mH C. 9 mH D. 7 mH
In a pair of coupled coils, coil 1 has a continuous of 2 A and the corresponding fluxes φ11 and φ21 are 0.3 and 0.6 mWb respectively. If the turns are N1= 500, N2= 500, find L1, L2, M and K.
A 460-turns square wire coil rotates about a vertical axis at 2690 rev per min as in FIGURE 5. The side of the square wire is 3.3 m each. The horizontal component of the Earth's magnetic field at the location of the loop is 37 µT. (i) Calculate the maximum emf induced in the coil by the Earth's magnetic field. (ii) Find the time for the coil to make 3 complete rotations. (iii) Sketch a graph of emf against time.
explain why Two coils are said to be mutually coupled if the magnetic flux Ø emanating from one pass through the other. The mutual inductance between the two coils is given by M=ksquare root of L1xL2
Two coupled coils N1 = 100 and N2 = 800, have a coupling coefficient k = 0.85. With coil 1 open and a current of 5 A in coil 2, the flux is Ø12 = 0.35 mWb. Find the inductance of coil 1.