A mixture is 10.0 mole% ethyl alcohol, 75.0 mole% ethyl acetate, and 15.0 mole% acetic acid. Calculate: 1. the mass fractions of each compound. 2. Average molecular weight.

Q: 3. Chemical company recovers crystalline K2CrO4from aqueous solution of the salt using evaporation a...

A:

Q: The feed to a reactors contains 100kmol C,H4 and 100kmol 02. a) which is limiting reactant? C2H4 b) ...

A: Given that, 2C2H4 + O2 → 2C2H4O The number of moles of C2H4 in the feed nC2H4,F = 100 kmol The numbe...

Q: Calculate the fugacity and fugacity coefficient of steam at T = 400 °C and 200 bar using Table 2. be...

A: Given that- For steam   Temperature, T =400 ⁰C = 673.15 K Pressure, P = 200 bar For, 200 bar pressur...

Q: A 1.0-m long pipe with an inside diameter of 2.5 cm carries water at a rate of 25 kg-min-. Steam out...

A:

Q: - Compute the formula weight and density of exhaust gas which contains 72% N2, 1% Ar, 12% H2O, and ...

A: As per our guidelines, we are supposed to answer only the first question. please send the other ques...

Q: One hundred tons per hour of a feed containing 20 wt% Na2CO3 and the balance insoluble solids is to ...

A: given: 100 tons per hour of feed y1=0.15 k=0.5 lb solution/lb insoluble solid N=logyN+1-yN*y1-y0*log...

Q: Sugarcane is produced by dissolving the sugar in the sugarcane in water, filtering the solution, hea...

A: Given: The ratio of sugar to water in feed is 1:3. Basis: 25 kg sugar and 75 kg of water entering th...

Q: CO2 is diffusing through N2 at atmospheric pressure and 25C. The mole fraction of CO2 at point A is...

A: As per our guidelines, we are supposed to answer only three subparts, please send the other part as ...

Q: 5. An increase in enthalpy leads to an increase in a) Increase in pressure b) Increase in volume c) ...

A:

Q: 5-7. Malfunctioning in a uranium oxide compacting machine resulted in the manufacture of a 0.2-in. t...

A:

Q: A certain piston assembly contains a certain gas inside. The gas is to be compressed in a series of ...

A: Work done = Pext*dV  Now work done total can be found by summing work done for individual process  

Q: The true density of the solid material in an activated alumina particle is 3.675 g/cm3. The density ...

A:

Q: 1.) Estimate the molar volume of CO2 at 400 K and 125 atm by treating it as a Van der Waals gas. 2...

A: 1.Given: P=125 atm T=400k From vanderwaals table a=3.610 atm dm6/mol2 ,b=4.29*10-2 dm3/mol Vanderwaa...

Q: gas has a pressure of 1050 psig and temperature of 170 F. The gas consist of ethane. The critical va...

A:

Q: 9.

A: The compound shown in the image belongs to heterocycles. In simple words, heterocycles mean a ring c...

Q: Q1) Answer the following (6 Marks): 1. In well logging technology, what are the two main interpretat...

A:

Q: IUPAC NAME. Use small lette

A: I have to write the products IUPAC name

Q: Consider that an iron is forgotten to be open throughout two days while its surface temperature is a...

A: As given heat transfer is taking from iron to air ,it is a convection mode of heat transfer. followi...

Q: Classify the following compounds as to what organic group it belongs. Choices: alkane, alkene, alkyn...

A: Here present group is R-O-R where R is benzene .

Q: Because intermolecular forces can only be controlled at surfaces & interfaces. Because of the high s...

A:

Q: 4. For the following reaction sequence, give the structure of alkyl halide B, compound C and ketone ...

A:

Q: 1. Write mathematical expressions of the following a.Fraction conversion of reactant а. b. Yield of ...

A: Chemical reactions are not instantaneous but slow proceed. The fractional conversion describes the c...

Q: A liquid paint stripper is composed of 40% toluene, 30% methanol, and 30% methylene chloride by volu...

A: Given that  the liquid composition of the gas is given 40% toluene, 30% methanol, and 30% methylene ...

Q: respectively. The 80% return air is mixed with 20% fresh air and then passed The room design conditi...

A: Given Outside design condition=43 °C DBT , 27.5°C WBT Internal design condition=25 °C DBT    50% RH ...

Q: The vapour phase alkylation of phenol is carried out by a selective zeolite catalyst to yield a mixt...

A: Given data: Number of ideal trays = 9 Flow rate of feed = 50 kmol/h Composition of feed is, p-cresol...

Q: Ethanol and benzene are separated in a network of distillation and membrane separation steps. In one...

A: Given: Feed mixture of ethanol and benzene sent to the evaporation membrane is F = 10000 kg/h Ethano...

Q: The piston areas of dead weight gauges are sometimes difficult to determine with sufficient aCcuracy...

A:

Q: Water with kinematic viscosity vr = 0.892 cm?/s flows in a smooth pipe of radius, R = 25 mm and leng...

A: The discharge is a product of area and velocity. The area is obtained from its diameter. The entranc...

Q: It is concerned with the rational design and/or analysis of performance of chemical reactors. (A) Qu...

A: 7. (D)Chemical reaction engineering is concerned with the rational design or analysis of performance...

Q: 4- Natural gas can be used in ?

A: To answer What is natural gas used for?

Q: Problem 1: According to chemistry textbooks, the basic reaction of carbon combustion (per mole of C)...

A: Reaction is C+O2→CO2+95 kcal Find High heating value(HHV) of coal,MJ/kg

Q: Natural gas is widely used as a fuel to cook food and provide heat in homes, to produce electricity ...

A: There can be two options for oil reserves such as it can be either decreasing or increasing. Here as...

Q: 2.) An Isothermal process is done on air, and it has a pressure of 500 kPa and a volume of 0.5m3. Th...

A:

Q: Q3) A: Give the crystal structure for the following metals. Fe , Ni , Pb , Cr , Al , Ag , Zn , Mo , ...

A:

Q: The first-order reactions below take place in liquid phase in an isothermal CSTR, with concentration...

A: Given: The given reaction is a series-parallel reaction: A →k1B→k2CB→k3D Since the reaction takes pl...

Q: In a LPG fuelled truck, (85% propane and 15% butane by volume), 5% (by volume, dry) oxygen is measur...

A:

Q: A thermometer having a time constant of (10 mh) is initially at (250°C), it is suddenly placed in a ...

A:

Q: In another separate kinetic study conducted for the alkylation of ethylene process at a similar temp...

A: As we can see that ethylbenzene is an important we would derive a feasible process to ensure maximum...

Q: Water flows at a velocity of 3.0 m/s. Calculate the dynamic pressure, pd, by assuming that the densi...

A:

Q: 1. Process integration definition and one example of the use of process integration

A: Since you have asked multiple question, we will solve the first question for you. If you want any sp...

Q: The nitric acid catalyzed isothermal decomposition of a 15.6 g urea 1. nitrate (CHSN304) produces fu...

A: Given: The reaction of urea nitrate to produce ammonia and fulminic acid is as follows: CH5N3O4(aq.)...

Q: Predict the diffusion coefficient of dilute solutions of fructose in water at 45C. What would you do...

A: Given data: T = 45 0C

Q: Question 2 For every 100 kg of C charged into the system, 27.5 kg of a vapour mixture of toluene and...

A: This system is an open system and unsteady. The energy balance involves energy accumulated, heat abs...

Q: 3.) Air is heated in an Isometric process where the pressure increases. It initially has a state of ...

A: Given Isometric process (Isochoric process) P1=1.5 kPa P2=2.5 kPa T1=500 k  

Q: a.)In the synthesis of ammonia stoichiometric amounts of N2 and H2 are sent to reactor where the fol...

A:

Q: EX:- Ahomeyenous liqui'd phase reactiom A, R (-rA) = KG5 50% ConVersion rn mixed 6.5 take place with...

A:

Q: A sphere of diameter, Dp, of 8.0 cm and density, p, of 1505 kg/m3 falls in still water at the termin...

A: Given Details: Diameter of sphere, Dp=8 cm =0.08 m Density of sphere,ρS=1505 kg/m3 Density of water ...

Q: A drug having a molar mass of 160 is being produced in a reactor.  The aqueous effluent (exit stream...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: Ex: How much heat is required to heat 100 bbl of crude oil (API = 40) from 100 to 200 F. %3D

A: Given Crude=100 bbl API=40 T1=100 °F T2=200°F  

Q: A methane-nitrogen mixture of fuel gas (96% methane) is burned with 40% excess air in a continuous w...

A: Consider combustion reactions of methane and heat of combustion of the reaction. The total heat of c...