A mixture of 0.5 benzene and 0.5 toluene was flashed into liquid and vapor phases at 368 K and 1 atm. What are the compositions of the vapor and liquid streams? [ Hint: Use Rachford-Rice equation and Raoult's Law ].

Q: 4. From the phase diagram, identify the peritectic and peritectoid reactions. Write the reactions.

A: The phase diagram represents the physical state of a material. This diagram is a graphical…

Q: The residence time and temperature parameters studied as in question (c) for both PFR and CSTR were…

A: A Continuous stirred tank reactor is also called a mixed flow reactor. Ideal CSTR is considered to…

Q: Calculate the pH of a 0.14 M HNO2 solution that is 2.3% ionized. A. 1.70 B. 11.90 C. 2.10 D. 0.85 E.…

A:

Q: (i) The amount of CO₂ being removed from the gas stream. (ii) The composition of gas leaving the…

A: Answer.

Q: List 4 main components of gas tank with its respective function used in gas chromatography

A: Gas chromatography is mainly composed of the following parts: 1) Carrier gas in a high-pressure…

Q: Air with mass of 12 kg expands polytropically (n=1.50) in a closed system from 720 °C to 20 °C.…

A: Given Data: Mass of air, m= 12 kg Polytropic process, Closed system n= 1.50 Initial temperature, T1…

Q: amount of heat produced.

A:

Q: Derive the Michaelis Menten equation

A:

Q: The polymerization of vinyl chloride (1.6x10³M) is carried out using hydrogen Peroxide (0.4x106 M),…

A: Given that- Concentration of vinyl chloride, M= 1.6 x105 M Concentration of hydrogen peroxide= 0.4 x…

Q: 2. Calculate the value of the mass transfer coefficient and the flux for mass transfer from a sphere…

A:

Q: 4. A perfectly insulated tank of negligible heat capacity contains P lb of brine at J-30°F. Hot…

A: Specific heat will be the heat amount that increases the temperature by one unit within one unit…

Q: 4.

A: △Hrxn = ∑stoichiometry coefficient of Product * △Hfproduct  - ∑stoichiometry coefficient of reactant…

Q: elevation of the boiling point

A:

Q: Q1// A liquid mixture of benzene-toluene is to be distilled in a fractionating tower. The feed of…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A mixture of gold (p= 19,320 kg/m³), pyrite (p= 5,010 kg/m³), and silica (p=2650 kg/m³) having a…

A: Stoke's law is found to be valid for the given case. Therefore, the terminal settling velocity of…

Q: 3

A: Given data are as follows: Diameter of steam carrying pipe = 10cm=0.1m Length of pipe = 50m Mass…

Q: Q2: The elementary gas phase reaction 2A + BC takes place isothermally in a constant volume batch…

A: Given elementary gas phase reaction is- 2A + B→C Condition is isothermal where tempearture is…

Q: For a feedback control loop like the one in the Figure, consider the following transfer 1 0.1s+3 2…

A: Given  gc =2 g= 2/(7s+1) gd = 1/(0.1s+3)

Q: A man is conducting a first-order reversible liquid reaction in a constant - volume isothermal batch…

A:

Q: 4. The turbines in a hydroelectric plant are fed by water falling from a 150 ft height. Assuming 15%…

A: For a detailed solution, please see the attached files.

Q: An ore having 80% passing 10 mm is fed to a mill with a capacity of 12 t/h. The ground product has…

A: The amount of ore required is to be calculated.

Q: Explain the term sublimation in your own words

A:

Q: fuel and combustion

A: Given that- Fuel is unnkown as CxHy. Mass fraction composition of products are- mCO2=0.0301…

Q: b) Consider a refrigerant-134a power plant that operates on a simple ideal Rankine cycle. The boiler…

A:

Q: 4. An ideal vapour-compression refrigeration cycle operates at steady state with Refrigerant 134a as…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: 1st order kinetics.

A:

Q: A MATLAB program for solving %excess air?  A mixture of propane and butane gas is burned in excess…

A: Given that- Mixture of propane nadd butane gas is burned in excess air. Basis feed = 100 mol…

Q: Water is pumped between two tanks at an hourty rate of 20.40 m' through a 122 meter long of 50…

A:

Q: N2(g) + C₂H2(g) → 2HCN (g) Determine heat of reaction from heats of formation, use heats of…

A:

Q: A light hydrocarbon gas mixture is stored in a tank at 25C and 9.5 MPa. The gas mixture contains…

A: A mixture of hydrocarbon is given.

Q: Consider ammonia synthesis: N₂ + H₂NH₂. At temperature (T) and pressure (P), the extent of 2…

A:

Q: A laboratory investigation into the spontaneous decomposition of a liquid organic compound Z under…

A:

Q: A perfectly insulated tank of negligible heat capacity contains P lb of brine at T, = 30°F. Hot…

A: When there is an increase in the temperature of the body by one unit with unit mass and the amount…

Q: An ammonia plant cost 66 million dollars to construct in 2000 with 300,000 MTPA production rate.…

A: Here the plant's total capital investment is given. Here the method to calculate the new total…

Q: Determine the change of entropy of the gas As

A:

Q: Please consider CO₂ that entered a process at the rate of 2.64 kg/min. The CO₂ entered at 274 °K and…

A: The initial mass flow rate of carbon dioxide is calculated. The mass balance is expressed in terms…

Q: Question 3 What is the impact on the distillation operation if more trays are added to the column?…

A: Option D is correct . For a detailed solution, please see the attached file.

Q: b) A complete drying experiment for two different materials (sand and minced meat) was conducted in…

A: the two major parts of the drying rate curve are period of constant rate and a period of falling…

Q: An evaporation-crystallization process is used to obtain solid potassium sulfate from an aqueous…

A: The feed amount will be equal to the combined amount of wet cake and water. The wet cake is composed…

Q: The polymerization of vinyl chloride (1.6x105M) is carried out using hydrogen Peroxide (0.4x106 M),…

A: Given data are as follows: Initial rate(Ri)=1×10-4mol/L.S, DP=300, Kd=1, f=1

Q: Calculate the Annual limit on Intake in Bq for a worker. The Committed Effective Dose per unit…

A:

Q: Determine the emission rate (lb/hr) of HCI (MW= 36.45 g/mol) resulting from the incineration of 760…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: adsorption of sodium oleate

A:

Q: 1) CI and Kw are among the most important classifications adopted in the classification of crude oil…

A: Part 1: CI of the crude oil is the correlation Index for the crude oil. This index tells about the…

Q: Determine the enthalpy of combustion of ethane (C2H6) (a) in kJ per kmol of fuel at 200 °C, 1 atm,…

A:

Q: J 5

A:

Q: A copper wire is stretched with a stress of 80 MPa at 20°C. If the length is held constant, to what…

A: Given data: Stress at 20 0C = 80 MPa αl for copper = 17×10-6 0C-1 Modulus of elasticity = 110 GPa

Q: und a

A:

Q: g-0. flowing through nozzle ects the mer ube gage. Determine the value of h if the pressure at A is…

A: Given data: Specific gravity of Oil;SG=0.750PA=20 psi=137895 Pad=2.75 inches=0.069 m

Q: Represents and describes by means of a diagram the main parts of the evaporation equipment.

A: Evaporation  It is the process of concentrating the stream by removing water. The process is energy…