Electrical Engineering = 100 µA/V and72 A MOS transistor is biased at a drain current of Ip, with K =CV, = 1 V as shown in the figure below.EROThe value of k varies t10% of the actual value, then the value of R that would result in I, = 100 µAwith a variablity of t1% is equal to(a) 35 ka(c) 55 ka(b) 45 ka(d) 65 kowwww

Answered: Image /qna-images/answer/dd3603a4-de9f-41ca-9a22-c23a3d2da288.jpg

Answered: A MOS transistor is biased at a drain…

Engineering

Electrical Engineering

A MOS transistor is biased at a drain current of Ip with K HConT 100 uA/V and V, = 1 V as shown in the figure below.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

For many years, MOS devices were scaled tosmaller and smaller dimensions without changingthe power supply voltage. Suppose that the widthW, length L, and oxide thickness Tox of a MOS transistor are all reduced by a factor of 2. Assume thatVT N , vGS, and vDS remain the same. (a) Calculatethe ratio of the drain current of the scaled device tothat of the original device. (b) By what factor hasthe power dissipation changed? (c) By what factorhas the value of the total gate capacitance changed?(d) By what factor has the circuit delay Tchanged?
The outer surface of a transistor is cooled convectively by a fan-induced flow of air ata temperature of 25 °C and a pressure of 1 atm. The transistor’s outer surface area is 5x 10 -4 m 2 . At steady state, the electrical power to the transistor is 3 W. Negligible heattransfer occurs through the base of the transistor. The convective heat transfercoefficient is 100 W/m 2 K.Determinei. the rate of heat transferbetween the transistor and theair, in Wii. the temperature at thetransistor’s outer surface, in °C.
ı just need fınal answer Considering the dc operating conditions of the NMOS circuit in the figure, gm = 1.5 mS was obtained. Also, the load current IL flowing through RL when Rsig1 = 2 kΩ, Rsig2 = 3 kΩ, RF = 60 kΩ, R1 = 50 MΩ, R2 = 12 MΩ, RD = 4.7 kΩ, RS = 1.2 kΩ and RL = 13.3 kΩ What would be the value of ? (Vi1 = 20 mV, Vi2 = 30 mV) NOTE-1: Capacitors are negligible at mid-band frequency. NOTE-2: The NMOS output impedance will be taken into account and its value is rd = 20 kΩ. a. 0,28 mA b. 0,20 mA c. 0,84 mA d. 0,40 mA e. 0,52 mA f. 0,72 mA g. 0,60 mA h. 0,12 mA
Considering the dc operating conditions of the NMOS circuit in the figure, gm = 4.1 mS was obtained. Also, the load current IL flowing through RL when Rsig1 = 2 kΩ, Rsig2 = 3 kΩ, RF = 60 kΩ, R1 = 50 MΩ, R2 = 12 MΩ, RD = 4.7 kΩ, RS = 1.2 kΩ and RL = 10.2 kΩ What would be the value of ? (Vi1 = 20 mV, Vi2 = 30 mV) NOTE-1: Capacitors are negligible at mid-band frequency. NOTE-2: The NMOS output impedance will be taken into account and its value is rd = 20 kΩ.
Considering the dc operating conditions of the NMOS circuit in the figure, gm = 4.1 mS was obtained. Also, the load current IL flowing through RL when Rsig1 = 2 kΩ, Rsig2 = 3 kΩ, RF = 60 kΩ, R1 = 50 MΩ, R2 = 12 MΩ, RD = 4.7 kΩ, RS = 1.2 kΩ and RL = 10.2 kΩ What would be the value of ? (Vi1 = 20 mV, Vi2 = 30 mV) NOTE-1: Capacitors are negligible at mid-band frequency. NOTE-2: The NMOS output impedance will be taken into account and its value is rd = 20 kΩ. a. 1,34 mA b. 0,40 mA c. 1,74 mA d. 0,94 mA e. 0,67 mA f. 2,01 mA g. 2,81 mA h. 2,41 mA
An npn transistor with IS = 5 × 10−16 μA, αF =0.95, and αR = 0.5 is operating with VB E = 0.3 Vand VBC = −5 V. This transistor is not truly operating in the region defined to be cutoff, but we still saythe transistor is off. Why? Use the transport modelequations to justify your answer. In what region isthe transistor actually operating according to ourdefinitions?
A transistor with k = 1 mA / V2 and VTH = 1.1 V is configured so that VDS is always one fifth of VGS. If the transistor is to act as a 400 Ω resistor, what must the value of VGS be set to? Express your answer in volts, accurate to two decimal places.
Considering the given transistor circuit and given values(β=60; V BE =0,5 V; VCC =15V; R E=1K ; R c=10K ; R1=60K ;R2=30K ).a. Find the base, collector, and emitter currents b. Find the voltage gain of this circuit c. Find the voltage gain by ignoring the capacitor connected to the emitterd. Briefly describe the transistor active zone and state its importance
An npn transistor with IS = 1 × 10−16 μA, αF =0.975, and αR = 0.5 is operating with VB E = 0.70 Vand VBC = 0.50 V. By definition, this transistor isoperating in the saturation region. However, in thediscussion it was noted that this transistor actually behaves as if it is still in the forwardactive region even though VBC > 0. Why? Use thetransport model equations to justify your answer
The PMOS transistor in the circuit below has ∣Vt∣=0.5 V, kp=20 mA/V2 , and λ=0. Also, I=0.9 mA. (i) Find vO as a function of vI assuming the transistor is operating in saturation. (ii) Find the allowable ranges of vO and vI. Assume that the minimum voltage VCS required across each current source is 0.3 V. FIND: (i) vO =_____________ (ii) allowable vO range: ______________ allowable vI range: ______________
Answer as quickly as possible. I'll give upvote. Thank you. The circuit shown is a common source amplifier with a current mirror bias. It is given that the NMOS (M1) parameters are μoCox = 3mA/V2, VTH,n = 0.5V and λ = 0.02 and the PMOS (M2 and M3) parameters are μoCox = 1mA/V2 and VTH,p = −0.6V . The PMOS transistor M3 does not have channel length modulation while PMOS transistor M2 has λ = 0.02. It is also given that the dimensions of M2 and M3 have equal widths of 5µm and lengths of L2 = 3µm and L3 = 1.5µm, respectively. M1 has length of L1 = 1µm and width of W1 = 2µm. Find the gm and ro of transistor M1.
Please help with this Field-Effect Transistor problem. The problem is typed below, see the attached diagram for reference. 5.57 In the circuit of Fig. P5.57, the NMOS transistor has |Vt| = 0.9 V and VA = 50 V, and operates with VD = 2 V. What it the voltage gain v0/vi? What do VD and the gain become for l increased to 1 mA?