A motor with an input of 1000 watts deliver an output of 1 horsepower. If the copper losses are 134 watts, what are the constant or fixed losses, which are independent of the load?

Q: Q1: Calculate Io in the circuit of Fig. (1) 24 V + Μ Μ 20 Ω 40 Ω Μ 10 Ω 20 Ω Μ Figure (1) Μ Μ 60 Ω…

A: The circuit diagram,

Q: (d) Given a vector à = -1+2j-2k in Cartesian coordinate. (i) Sketch vector A

A:

Q: Q1: A single core of underground cable supplies 66 Kv. is covered by lead. The radius of its…

A:

Q: 2. Consider the system shown in Fig. 2. Determine whether it is (a) memoryless, (b)causal, (c)…

A:

Q: Parameters of the following transfer function is given as: k-5.1, a=3.5, b-3.4, and c=6, determine…

A: Parameters of the following transfer function is given as: K = 5.1, a = 3.5, b = 3.4 and c = 6  Step…

Q: Q3: Find Io in the circuit of Fig. (3), using mesh analysis method. 560 A 8 Ω -J5 Ω 6Ω J6 Ω 10 60° V…

A:

Q: Question 6  Given a formula for i(t)=10sin(200pit+pi/8) across a capacitor (C=5microfarads). Find…

A: here we have to find the voltage across the capacitor.

Q: 0 -π<t<0 la-t 0<t<a f(t) =<

A: Given Data: A continuous-time signal of, ft=0-π&lt;t&lt;0π-t0&lt;t&lt;π To Find: Fourier Series…

Q: (P. 6) For a particular junction for which Co= 0.6 pF, Vo = 0.75 V, and m= 1/3, find C, at…

A: All the values are given as, Cj0 = 0.6 pF V0 = 0.75V m = 1/3 VR1 = 1V VR2 = 10 V. Cj = ?

Q: A synchronous generator has a constant mechanical input power. In the fault followed by the…

A: In this question we need to choose a correct option

Q: Determine the input impedance of the circuit in Fig. 9.24 at = 10 rad/s.

A: It is given that:

Q: A half-wave rectifier has a 120 V rms, 60 Hz AC source. The load is a series inductance, resistance,…

A: `For a half-wave retifier,V=120Vrms.f=60 Hz.L=120mH.R=12Ω.Vdc=48V.

Q: Perform the following complex number conversions: a) Convert the following complex number to its…

A: here we have to convert the numbers

Q: For the circuit of Figure 2. Carry out the analysis in DC and small signal with Vt=0.7 V, Kn(W/L) =…

A:

Q: (e) Given B = -51 + 10j + 2k and C = 8î+ 3k Calculate the dot product of two vectors, B.C (1)

A: We need to find out the dot product of given vector.

Q: 120 V ww 6Ω www 302 ΖΩ www ΔΩ D 12 Α

A: Circuit diagram is given as,

Q: 2.) what is the power output of 502 resistor?

A: It is given that:

Q: 2. Refer to the DC network below and find the following values: i. voltage across RI, VRI ii.…

A: For the given diode-based circuit the voltage drop across the resistor R1 needs to be calculated and…

Q: For the circuit of Figure 2. Carry out the analysis in DC and small signal with Vt=0.7 V, Kn(W/L) =…

A:

Q: 1. Draw the internal design of a microcontroller and explain each block diagram. 2. What are the…

A:

Q: i=I sin(t+₁) V = V sin(oot+0 + v) Z

A: v = V sinωt + ϕv = 3458.8 sinωt + 31.7° Vi  =  I  sinωt + ϕi = 208.3 sinωt + 54° A

Q: A 12.0 V battery is connected into a series circuit containing a 14.00 resistor and a 1.50 H…

A:

Q: A speaker and a light bulb are connected in series to a 9-Volt battery. The voltage drop across the…

A: Supply voltage V = 9 V. Voltage across bulb = 4.4 V. Both bulb and speaker are connected in series

Q: PH www

A:

Q: Two resistors are connected in series to a battery. Their resistances are 2.7 2 and 4.4 2. The…

A: Value of resistances R1=2.7 Ω, R2=4.4 Ω. Current flowing through circuit I = 1.8 A.

Q: A 3-phase system has a single phase to earth fault (i.e. phase A is short circuit to earth while…

A: In this question we need to find the per unit phase A current of the given system when a single line…

Q: Determine the input impedance of the circuit in Fig. 9.24 at = 10 rad/s. Answer: (149.52 - j195)

A: ω = 10 rad/s

Q: A modified square wave DC-AC inverter is designed using an H-bridge. The output waveform voltage is…

A:

Q: What is the function of the circuit in the following figure? Y-x< B -Y

A: Note: I am solving it in the handwritten format as well as in Text format The main disadvantage of…

Q: does the principle argument in part B, have no 2*n*pi on the end? isn't that worked out with…

A: Does the principle argument in part B, have no 2nπ on the end?

Q: Determine the Fourier Series corresponding to the following periodic function, and then determine…

A: To determine the Fourier series corresponding to the following periodic function, and then determine…

Q: 2. Define system type. Determine the position-velocity-acceleration error coefficients K(s + 1) s…

A: Given: Forward path gain, G's=Ks+1s+0.1, with controller transfer function, Cs=1ss+3, To find: i)…

Q: Construct the Root Locus of a unity feedback system with G(s) = K(s+1) s(s+2)(s+3) H(s) = 1

A: Given data Gs=Ks+1ss+2s+3 Hs=1 To find out We have to sketch the root locus for the given open-loop…

Q: (a) Vs R1 R2 R3 R4 Vs=24V R1₁=452 R₂ = 60 Figure 1.1 For the circuit shown in Figure 1.1, calculate…

A:

Q: Calculate the total power radiated by the sun in watts and in dBW. Hint: The sun is 93 million miles…

A: R=150 million kilometers,Flux density= 1.36 kW/m2,

Q: 30/0° V 4Ω www V₁ ell 40/60° V (+ j4Ω V2 -1Ω www 2 Ω

A: In this question we need to find the  V1 and V2 in the circuit shown in given Fig.

Q: An 11 KV generating station has four identical 3-phase alternators A,B,C and D and each of 10 MVA…

A: Here,  Every generator is having a reactance of 0.12 Pu G1∥G2=0.12∥0.12=0.12×0.120.12+0.12=0.06…

Q: 3. Use Kirchhoff's Laws to solve for the voltage Vo 69 40 www * Vo O 10 A 2%

A: Circuit diagram is given as,

Q: The reverse recovery time of a diode is trr = 10 µs and the rate of fall of the diode current is=2…

A: Given- Reverse recovery time, trr=10 μs. Rate of fall of diode current, didt=2 Aμs.   To find- The…

Q: 1. Fill in the blanks by inserting appropriate words/figures. . wire system. (i) The most common…

A: Since you have posted multiple questions, we will provide the solution only to the first five…

Q: Example 13.1. A 2-wire d.c. distributor cable AB is 2 km long and supplies loads of 100A, 150A,200A…

A: It is given that: AB=2kmI1=100 AI2=150 AI3=200 AI4=50 AL1=500 mL2=1000 mL3=1600 mL4=2000 mVA=300 V

Q: Would it be possible to use mesh analysis in this case

A:

Q: Determine the synchronising power and torque per mechanical degree of rotor displacement of a…

A: S = 50 MVAVL = 11 kVZs = 4.181 + j39.78%pf = 0.8lagging

Q: if a zener diode is placed forward bias, what would be expected forward voltage if it was on

A: Asked to explain about Zener diode  forward bias condition

Q: (3): Parallel plate capacitor Q4. A capacitor of initially capacitance 0.08pF is filled with…

A: Given,Initial capacitance, Ci=0.08 pF.and,The table of applied voltage and its charge…

Q: = Figure 1 shows a potentiometer used to measure the displacement and velocity of an elevator. The…

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Three wire single phase dwelling services and feeders shall be permitted to be calculated using NEC…

A: We need to select correct option for given statement about NEC.

Q: A 480 V, 50 Hz, Y-connected, 4 pole synchronous generator has the OCC shown in the figure 1 below.…

A: Since the question posted by you has multiple sub-parts, we will solve the first three sub-parts for…

Q: A certain Norton equivalent circuit consists of a 100 μA current source in parallel with a 10 kΩ…

A:

Q: 2) 13-2 ww 30 240V 1722 30-2 W 15-2 M 20 150 150. Find the power at 20.2 resistor. 5-2 ·102

A:

Gear Motor

A gear motor is a combination of a gearbox and an electric motor. This combination of two systems is used for efficient usage of the motor. It makes a cost-effective solution for high torque, low-speed applications. These motors are used in our household as, garage door openers, alarm clocks. In commercial areas, hospital beds, cranes.