A multilayer coil of 2000 turns of fine wire is 20 mm long and has a thickness 5 mm of winding. If the coil carries a current of 5 mA, the mmf generated is (a) 10 A-t (b) 500 A-t (c) 2000 A-t (d) None of the above

A multilayer coil of 2000 turns of fine wire is 20 mm long and has a thickness 5 mm of winding. If the coil carries a current of 5 mA, the mmf generated is (a) 10 A-t (b) 500 A-t (c) 2000 A-t (d) None of the above

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PA: You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor...

See similar textbooks

Related questions

Q: Q2 Two self-inductive coils, one L1 and the other L2, and their mutual inductance M Prove that their…

Q: coil has a resistance of 14 Q at 50°C. If the temperature coefficient of resistance at 0°C is…

Q: An inductance of 1 H and a resistance of 2 0 are connected in series with a constant emf of E volts.…

Q: A.An iron core 0.4m long and 5 cm2. In cross section, is wound with 300 turns. When a current of 0.5…

A: In this question , we will find inductance of iron core coil with given length , area ,…

Q: A 30V electromotive force is applied to an LR-series circuit in which the inductance is 0.1H and the…

Q: 4. 7.4 The switch shown has been open for a long time beforeclosing at t=0 3. c) Find io(∞), iL(∞),…

A: Calculate the current through the inductor for t < 0.

Q: A series circuit consists of a resistor with R=24 Q, an inductor with L =2 H, a capacitor with…

Q: The switch in Figure Q2(c) has been in position a for a long time. At t = 0 s, the switch moves to…

Q: In the figure ɛ = 10.0 V, R, = 4.00 N , and R2 = 1.00 : inductor is ideal. If the switch is closed…

A: According to question :

Q: A closely wound, flat, circular coil of 25 turns of wire has a diameter of 10 cm and carries a…

A: Given: A closely wound flat circular coil with Number of turns, N=25 Current, I=4.0 A Diameter, d=10…

Q: A coil draws 1800W when connected to a 120V dc source. It consumes 3000W when used on a 200V, 60Hz…

A: We need to find out the value of the inductance of given coil

Q: 5. Two magnetically coupled coils have 500 and 1500 turns, respectively. When the first coil carries…

Q: Two magnetically coupled coils have 500 and 1500 turns, respectively. When the first coil carries a…

Q: 5. When the current through an inductor is cut in half, the amount of energy stored in…

Q: A 6.0 H coil whose resistance is 12 Q is connected in series with a 24 0 resistor and to a 144 V…

A: Since you have asked multiple question , we will solve first question for you . If you want any…

Q: 800 -5+10u(t) mA ( 1H 1202

Q: A coil draws 1875 watts when connected to a 150 V dc source. It consumes 3072 watts when used on 240…

Q: Part 1:. The switch is connected to 20V voltage source for a long time. At time t = 0 the swit…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should be…

Q: Q2 Two self-inductive coils, one L1 and the other L2, and their mutual inductance M Prove that their…

Q: A coil with a resistance of 10 Ω and an inductance of 10 H is connected in series to a 100 V DC…

A: A coil with a resistance 10 Ω inductance 10 H is connected in series to a 100 V DC voltage source.…

Q: The figure below shows the lengthwise cross-section of a current-carrying coil. The coil carries a…

Q: The switch in the circuit hasbeen closed for a long time. The maximum voltage rating of the 1.6…

A: Given: A circuit. Formula and concept:

Q: A 1 ohm resistor is connected in series with a 2-mH inductor. If a 12-V dc source is suddenly…

A: According to question

Q: Wind turbine is a device for converting Kinetic Energy to Mechanical Energy. Select one: True False

A: Wind turbine is a device converts wind's kinetic energy into mechanical energy and then generator…

Q: The EMF of 100 V is induced in a coil, when a current of 4 A collapses uniformly to zero in 2 8ms,…

Q: 1.The equivalent inductance between A and B of the circuit shown in figure B2 is 5.33mH. Find the…

Q: The next seven questions pertain to the situation described below. A circuit is constructed with…

Q: A coil has a resistance of 18 Q when its mean temperature is 20°C and of 20 Q when its mean…

Q: Write the current and voltage relations for the following two components. R U U (a) (b)

A: According to the question we have to discuss the voltage and current relation for a given component.

Q: An R-L circuit takes a current 7A that lags behind the 231 V source by 35 electrical degrees.…

Q: The alternating electric current at a wall outlet is mostcommonly produced by(a) a connection to…

A: Given: The correct option is shown as:

Q: In the following circuit, the switch was moved to position 'B'. The capacitor C = 35.71 µF is…

Q: A 2-nF capacitor with a 5-µC charge on it is discharged through a 2-k2 resistor. What is the maximum…

A: In this question , we will find maximum current in circuit with capacitor...

Q: An iron core 0.4 m long and 5 cm2 is wound with 300 turns. When a current of 0.5A flows in the coil,…

Q: A circuit comprises an inductor of 9 H of negligible resistance connected in series with a 60 O…

Q: 3. In the circuit shown below, switch 1 closes at t-0. Switch 2 has been in position a for along…

A: Given:-

Q: A 12 resistor is connected in series with a 2mH inductor. if a 12-V dc source is suddenly connected…

Q: A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10 Nm/rad. The…

A: In this question we need to find

Q: A current of 12 A is reversed in a 3-H coil in 24 ms. The induced voltage is

A: In this question, We need to determine the induced voltage across the inductor? We know Induced…

Q: A coil with a resistance of 10 Ω and an inductance of 10 H is connected in series to a 100 V DC…

A: R-L series Circuit

Q: An iron core 0.4 m long and 5 square cm in cross section, is wound with 300 turns. When a current of…

A: Need to find L

Q: A 4 H inductor has a voltage waveform v(t) as shown in Figure Q3. Determine and plot the current…

Q: A flat circular coil with 40 loops of wire has a diameter of 32 cm. What current must flow in its…

A: The magnetic field at the center of the circular loop is given by the expression as shown below:…

Q: A resistance of 12 ohms and capacitance of 0.01 farad is connected in series with a 200 volts…

Q: A RC series circuit is shown in Figure B2, when the switch is closed at t=0 sec, compute the…

Q: The field winding of a DC generator is wound with 900 turns and has a resistance of 50 ohm. If the…

A: Given 900 turns R=50ohms V=240V DC Flux=4mWb

Q: A 6.0 H coil whose resistance is 12 Ω is connected in series with a 24 Ω resistor and to a 144 V…

A: For the given circuit we have to calculate the energy at steady state

Q: 5. An iron core 0.4m long and 5 cm2. In cross section, is wound with 300 turns. When current of 0.5…

A: We need to find out inductance of given coil

Concept explainers

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.

Question

fast

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
An AC electric motor is connected to a 240-V, 60-Hz source. A clamp-on ammeter with a peak hold function reveals that the motor has an inrush current of 34 A when the motor is first started. Your job is to reduce the inrush current to a value of 20 A by connecting a resistor in series with the motor. The resistor will be shunted out of the circuit after the motor is started. Using an ohmmeter, you find that the motor has a wire resistance of 3 . How much resistance should be connected in series with the motor to reduce the starting current to 20 A?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
S1 switch in the circuit has been closed for a long time and it is opened at t=0s. Then, S2 switch changes its position from “a” to “b” at t=10 ms. Find the current flows through the inductor for t≥ 10 ms. Please in clean handwriting
In the circuit shown below, after the switch is held in position a for a long time, it turns to b at t = 0 and stays there. Find the variation of the voltage at the ends of the coil over time.
A coil with a resistance of 10 Ω and an inductance of 10 H is connected in series to a 100 V DC voltage source.a) Find the value of the current t = 0.1 s after the switch is closed.b) Calculate the value of the current when t = ∞.
S1 switch in the circuit has been closed for a long time and it is opened at t=0s. Then, S2 switch changes its position from “a” to “b” at t=10 ms. Find the current flows through the inductor for t≥ 10 ms Please only clean handwriting please ASAP
The R-L Circuit: An inductor with an inductance of 2.50 H and a resistance of 7.00 n is connected to the terminals ofa battery with an emf of 6.00 V and an internal resistance of 1.00 n. What is the rate ofincrease of current at the instant when the current is 0.500 A? A) 0.8 A/s B) 0.6 A/s C) 0.4 A/s D) zero E) None of the above.
An electric circuit contains an 8 ohm resistor in series with an inductor of 0.50 henries and a battery of E volts. At t=0 the current is zero. Find the current at any time t > 0 and the maximum current if E = 64sin8t
The switch in the circuit hasbeen open a long time before closing at t=0. At the time the switchcloses, the capacitor has no stored energy. Find vo for t≥0
The problem says to find I_1 I_2 and I_3 when †=0 and for when †= ∞ when the switch is closed and do the same when the switch opens. It gives the values of R=10 E=50 c=10 uF