A parallel-plate capacitive transducer has a plate area ( I x w) = (80mm x %3D 80mm) and plate spacing (d) = 2.0mm. Measure the device capacitance and the displacement (Ad) that causes the capacitance change by 5pF. Also measure the transducer sensitivity.

A parallel-plate capacitive transducer has a plate area ( I x w) = (80mm x %3D 80mm) and plate spacing (d) = 2.0mm. Measure the device capacitance and the displacement (Ad) that causes the capacitance change by 5pF. Also measure the transducer sensitivity.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Related questions

Q: 4. Determine the effective resistance of a practical 3H inductor that has 6002 of impedance in a…

Q: Electrical Engineering --question 1-- Calculate the theoretical voltages across the resistor and…

Q: A series RLC circuit has a resistance of 20 ohms, a capacitance of 102 Farads, an inductance of 10…

A: In the question, A series RLC circuit, Resistance R= 20 ohm Inductance L= 10H Capacitance C= 10-2 F…

Q: Given a variable capacitor that can be adjusted over the range of 40pf to 365pf we want to tune the…

Q: a) A 20 nH inductor has a seri tance of 15 2. Compute the eq parallel resistance, Rp, at 2 G b)…

Q: An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a…

A: Given: An RC circuit has: EMF, Vs=5 V Resistance, R=10 ohms Capacitance, C=10-2 F The initial charge…

Q: An RC circuit with a capacitance of 5⋅10-2 farad, and a resistance of 4Ω, has an EMF of E(t)=…

Q: Q3) an LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a…

A: For a series LRC circuit with L=15 H, R=1 Ω, C=56 F; the capacitor has an initial charge of q0=2 C…

Q: O What is the minimum distance L that will allow full Leflection of 8 cm at the oscilloscope screen…

A: Given Data is shown below. An acceleration potential is Ea=3000V deflection factor G=600 V/cm full…

Q: Given a series RL circuit that has a resistance of 10Ω and an inductance of 470mH, and has been…

A: Given a series RL circuit that has a resistance of 10Ω and an inductance of 470mH, and has been…

Q: A 5 V battery, a capacitor with a capacity of 15 mkF, and a resistance of 10 kOhm are connected in…

A: Given data, V = 5 volts, Capacitance(C) = 15 micro Farad (since, mk = micro) Resistance(R) = 10 kilo…

Q: Determine vc,iL, and the energy stored in the capacitor and inductor

A: Main concept is capacitor and inductor behaves as steady state for dc

Q: The voltage across 20 micro-farad capacitor varies with time as given by vc = (10.75 - 1.5e -1000t)…

Q: A series RLC circuit is connected to a 230 V, 50 Hz supply. When Lis varied, the maximum current…

A: At maximum current impedance of capacitor is equal to impedance of inductor. And voltage across the…

Q: Given thee capacitors C 20 aF. C15 F, and C30 F. what amangement of paeralel and series connections…

Q: A parallel plate capacitor is required to be designed using polypropylene as the filler between the…

Q: mine the value of the capacitor C to be connected in parallel with the total load to he PF to unity.…

Q: 2- For the below capacitance transducer, a. Calculate the sensitivity in pF/mm transducer.…

Q: c) An ac bridge was made up as follows: arm ab, a capacitor of 5µF in parallel with 20k2 resistance,…

Q: Capacitance= 4uF , Hence time constant is 5.33μs For the capacity value, calculate the estimated…

A: Transient response is the response of a system which is the change in transient(equilibrium) or…

Q: A Si p+-n junction 10^-2 cm^2 in area has Nd =10^15 cm^-3 doping on the n side. Calculate the…

Q: Capacitance’s of 15μF, 12μF, 17μF, and 19μF are connected in parallel to a Direct Voltage Supply of…

A: Capacitance’s of 15μF, 12μF, 17μF, and 19μF are connected in parallel to a Direct Voltage Supply…

Q: The input voltage of the following figure is V,=220 V with load resistance of R=70. The load and…

A: Information about the given circuit are Input voltage Vs=220 Volts. Thyristor operating frequency…

Q: A deemphasis circuit has a capacitor value of 0.02 µF. What value of resistor is needed? Give the…

A: Given: C=0.02 μF

Q: (e) An ideal 1 mF capacitor has a voltage of 10 V across its terminals for time, t 0, what is the…

A: The solution is as follows.

Q: Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure next. The…

A: Given L1=10 cm C1=8 pF When inner cylinder moves by distance 'X' new capacitance is C2= 5pF New…

Q: Question4: A pn junction is biased with a reverse voltage (VR) and is doped with NA = 2x1016 /cm and…

Q: of capacitance C = 2πT A series LCR circuit consists of an inductor of self inductance L=H, a…

Q: (a) Derive a formula for the total capacitance in an n-bit weighted-capacitor DAC. (b) In an n-bit…

A: Concept: A passive two-terminal electrical component used to store energy electrostatically in an…

Q: Ina series RLC circuit, the supply voltage is 120 volts 60-cyle, the resistance of resistoris 10…

Q: pure capacitance of C =38 µF capacitor is connected to a V = 116 V, 50 Hz supply. The current taken…

Q: 4) b) The circuit of figure given below shows a capacitor, two ideal batteries, two resistors, and a…

A: It is given that: C=10 μFε1=1 Vε2=2.2 VR1=0.2 ΩR2=0.4 Ω

Q: A fuel gauge uses a capacitor to determine the height of the fuel in a tank. The effective…

A: (a) The given arrangement forms two capacitors. One capacitor with gasoline (C1) and other with air…

Q: Circuit diagram of HWR (without Capacitor): MA

Q: A constant voltage at a frequency of 1 MHz is applied to an inductor in series with a variable 0…

Q: draw a qpsk demodulation circuit using circuit components for instance resistors, capacitors,…

A: According to the question,

Q: Obtain the energy stored in each capacitor in the figure below under DC conditions. 2kn 3ka

Q: A 10 Q resistor is placed in series with a coil of self resistance RL Ans: and inductance L and a…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: the decrease of voltage gain with frequency 2. the capacitance which effectively appears from input…

A: In this we will write about decrease in voltage gain with frequency...

Q: Explain the simple RL circuits (Section 32.2, structure/decay of current through an inductor)?

Q: 1. A cardiac defibrillator is used to shock a heart that is beating erratically. The capacitor is…

Q: A series circuit has a capacitor of 0.25 x 10-0 F, a resistor of 5x 10' 2, and an inductor of 1 H.…

Q: 5. An RC (DC) circuit consists of a Resistor with a resistance of 25000 2 and Capacitor in series…

Q: There is a cylindrical capacitor that is constructed from inner and outer copper shells and a tough…

A: Voltage rating of Capacitor A maximum operating voltage or working voltage. The capacitor is meant…

Q: Draw and explain the structural overview of MOSFET Capacitances

A: Let the structural overview of MOSFET Capacitance in the Figure below. Ideally, the drain and source…

Q: an LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a capacitance…

Q: A capacitor has a capacitance of 10 µF and a phase difference of 10°. It is inserted in series with…

A: Given,Capacitance (C)=10 μF=10×10-6 FPhase difference =10°Voltage =200 VFrequency = 50 HzR=100 Ω

Q: The input voltage of the following figure is Vs=200 V with load resistance of R=50. The load and…

Q: 2F 6F 60 V 4 F 7 F 3F 5F

A: Capacitor is a passive element that store energy in electric field. The voltage across capacitor…

Question

neeed asap

A parallel-plate capacitive transducer has a plate area (I x w) = (80mm x
80mm) and plate spacing (d) = 2.0mm. Measure the device capacitance
and the displacement (Ad) that causes the capacitance change by 5pF.
Also measure the transducer sensitivity.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Design a charge amplifier for a piezoelectric sensor that has a capacitance of 500 pF. It must pass frequencies from 0.05 to 100 Hz so that it can detect carotid pulses and it must not fall into saturation.
A TRF receiver is to be tuned over the range 550 to 1550 kHz with a 25-uH inductor. Calculate the required capacitance range. Determine the tuned circuit’s necessary Q if a 10-kHz bandwidth is desired at 1000 kHz. Calculate the receiver’s selectivity at 550 and 1550 kHz.
Draw a clearly labelled equivalent circuit showing the straycapacitors.
Determine vc,iL, and the energy stored in the capacitor and inductor
Show your COMPLETE SOLUTION. Roundyour final answer to the nearest hundredths. A 500-uF capacitor provides a load current of 200 mA at 8% ripple. Calculate the peak rectified voltage obtained from the 60-Hz supply and the dc voltage across the filter capacitor
A series L–R–C circuit has a supply input of 5 volts. Given that inductance, L = 5 mH, resistance, R = 75ohms and capacitance, C = 0.2µF, determine A) the value of the maximum voltage across the capacitor. B) A capacitor having a Q-factor of 250 is connected in series with a coil which has a Q-factor of 80. Calculate the overall Q-factor of the circuit.
the square plates of a 5000pF capacitor measures 50 mm by 50 mm and are separated by a dielectric which is 0.23m thick. the voltage rating of the capacitor is 400 V. the maximum energy that can be stored in the capacitor, in mJ, is ?
Bipolar junction transistors are the dominant device technology in modern integrated circuits due to the high speed performance. True False The transconductance of a bipolar junction transistor in the reverse-active region is always proportional to the collector current. True False The internal capacitance of the transistor causes the amplification gain to be relatively larger at higher frequency input. True False Applying a sinusoidal waveform to a circuit consisting of a capacitor in series with a diode will not have any ripple effect in DC. True False MOSFETs can be used to design an amplifier when the Q-point is properly set in the triode region. True False
Solve for the (and refer to the image): - individual voltages - individual charges wherein Equivalent capacitance of the capacitor is 0.76 F Charge stored in the circuit is 45.50 C. And V= 60V
A Si p+-n junction 10^-2 cm^2 in area has Nd =10^15 cm^-3 doping on the n side. Calculate the junction capacitance with a reverse bias of 10V.