A parrallel resonant R= 5Kr, L=8mH, C=60UF Determine: The resonant Feeguency The band wid th Circuit has The quality factorr

Q: A fixed bias n-channel JFET with Vdd= 12V, Rd= 1.2k ohms. Idss=12mA and Vp=-4V. Determine Id. O a. a...

A: By mentioning the fixed bias circuit of JFET   

Q: The primary difference between BJT and FET types of transistor is; a.FET is voltage controlled and B...

A: BJT and FET both are controlled devices and their state is controlled by applied gate pulse . 

Q: The ______ terminal of the JFET is the equivalent of the Emitter terminal of a BJT. a.None of these ...

A: Like a BJT , JFET  ia also a three terminal device. BJT has Emitter Collector Base   JFET has Sou...

Q: RI 2Ω R2 {12 N |

A:

Q: In circuit analysis, expound separately the meaning of getting negative values for the current & vol...

A:

Q: Which of the following is true about acceptable Percent Errors?

A: The solution is given below 

Q: Determine É at (2,0,2)m due to three standard charge distribution as follows: a uniform sheet at x =...

A: It is given that: 1. Uniform sheet at:x=0 mρs1=13π nC/m22. Uniform sheet at:x=4 mρs2=-13π nC/m23.Uni...

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply, c...

A:

Q: R1 V1 10Ω L1 3PH 10mH 120V 60HZ C1 1mF Figure 4.1

A:

Q: The ______ terminal of the JFET is the equivalent of the base terminal of a BJT. a.Gate b.Source c.D...

A: In this question, We need to choose the correct option   The ______ terminal of the JFET is the equi...

Q: R1 a Req R2 R3 d

A:

Q: LA closed magnetic circuit of cast steel contains a 6 cm long path of cross-sectional area 1 cm² and...

A:

Q: C2 C1 4 uF 1 uF C3 3 uF C4 2 uF C5 2 uF

A:

Q: H.W. Find V, in Fig. below using (a) nodal analysis and (b) mesh analysis. 24/0 v j4n 3 30 j2n 40 10...

A: In this question,  We need to find the voltage Vx using the nodal analysis and mesh analysis.  Here ...

Q: Hole diffusion Electron diffusion Hole diffusion current Electron diffusion current Hole drift Elect...

A:

Q: Rc 100 ) RB Vcc 10 V 10k. 5 V

A:

Q: The charge on one plate of a 3 µF capacj- tor is 0.12 uC. The energy stored in the capacitor is (i) ...

A: Given, Charge, Q = 0.12 μC Capacitance, C = 3 μF

Q: Three single phase ideal transformers, each of rating 5kVA, 200V/400V, 50 Hz are available. The LV s...

A: Delta connection: If three- single-phase winding is connected in such a way that one’s tale winding ...

Q: spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A and ...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A an...

A: In this question,  A spherical conductor radius R= 10cm Charge Q= 20uC at the sphereical conductor. ...

Q: Find the transfer function relating the 0,(s) to T(s) for the rotational mechanical network shown. E...

A:

Q: A string of four diodes is used to provide constant voltage of 3.0 V. (a) Calculate the percentage c...

A: Answer - a)

Q: Find IB, IC, IE, VBE, VCE, and VCB in this circuit. The transistor has BDC = 150

A:

Q: Determine the n-type doping concentration to meet the following specifications for a Si p-n junction...

A:

Q: Problem: Given the following electrical circuit. Please develop the state-space representation with ...

A:

Q: Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply, c...

A:

Q: Find IB, IE, VBE, VCE, and VCB in this circuit. The transistor has

A:  

Q: Is there any “current law” for meshes? If so, what is it

A: Kirchoff's voltage law is used for calculating the current in the meshes and the loop. Thus the mesh...

Q: Three capacitors are connected in parallel and have the following voltage ratings: C1 = 32 uF with 8...

A:

Q: A point charge of 52 pC is at (3, -4, -1), find the electric flux density D

A:

Q: for a cathode 7 segment display create a truth table and kmap for a function that is BCD to 7 segmen...

A: Seven segment display is an electronic circuit consisting of 10 pins. out of 10 pins, 8 are LED pins...

Q: A closed loop feedback system has the following response specifications: a) Mp s 16% b) Settling tim...

A:

Q: coaxial cable has inner radius of 1.2cm and outer radius of 1.8cm and has a length of 35m with an in...

A:

Q: 1.31 A 3-phase 220 V, 50 Hz, six pole induction motor has the following parameters: =0.252 X; = 0.42...

A:

Q: A total charge of 100. coulombs flows past a fixed point in a circuit every 500 seconds. What is the...

A:

Q: 15 kn V = 9 V, R = 0 R. 30 V

A: Given: Circuit diagram

Q: A capacitor consists of two similar square aluminum plates, each 10 cm x 10 cm mounted parallel and ...

A:

Q: The voltage across a 5 uF capacitor is v(t) = 10 cos 6000 t V The current through the capacitor is (...

A:

Q: A round conductor has a radius and a total charge of 0.1 m and 20uC. If points A and B are 15 cm and...

A: In this question, A spherical conductor radius 10cm  and a total charge Q=20uC. If points A and B ar...

Q: Find the charge enclosed by the entire universe given P, e-2r r2

A: Given, The volume charge density Pv = e-2r/(r2)  

Q: In circuit analysis, explain the meaning of getting negative values for the current & voltages, in t...

A:

Q: 7 and Fourier coefficients 3.10. Let x[n] be a real and odd periodic signal with period N ak. Given ...

A:

Q: Problem 1: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If ...

A: Since you have asked multiple questions in a single request, we will be answering only the 1st quest...

Q: What resistance would produce a current of 200 amps with a voltage of 2,000 V?

A:

Q: Why the power flow analysis involves with non-linear equations?

A:

Q: Find the state-equation and output equation of the given RLC electrical network with the output equa...

A:

Q: 8. Calculate the magnetizing force and flux density at a distance of 5 cm from a long straight circu...

A: In this question we will find magnetization force and flux density at a distance from a long straigh...

Q: The gate of a J-FET must always be ---

A:

Q: Problem 3 (3 points): Given the unity feedback control systems of Figure 3 where G(s): K find K and ...

A:

Q: 3.6. Consider three continuous-time periodic signals whose Fourier series repres= tions are as follo...

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.