A PIC18-based system must handle a 64-point LED matrix. Explain what the technique is used to use only 16 output signals and not 64.

Q: Assignment_2: Design a 4-line to 16-line decoder circuit (4x16 decoder) that is constructed of two…

A: A 4:16 decoder can be designed using two 3:8 decoders and a NOT gate, and, two AND gates. Let's…

Q: Give some principles in FDM

A: INTRO principles in FDM and here is the solution in the next step.

Q: A signal with 60 milliwatts power passes through a device with an average noise of 6 microwatts.…

A: The answer is

Q: CMOS operates more reliably than TTL in a high-noise environment because of its(a) lower noise…

A: Lets see the solution.

Q: All three LEDS of a tri-color LED need to be connected to the same TPM of a K25Z. Which TPM is…

A: To Do: To choose the correct option.

Q: Design the following circuits using LASI and validate them with WinSpice. Please submit the required…

A: FOR SOLUTION SEE STEP NO. 2

Q: Q1. For the QPSK demodulator shown in Figure below, determine the I and Q bits for an input signal…

A: ANSWER-- For the binary data input of Q = 0 and I = 0, the two inputs to the I balanced modulator…

Q: Write synthesizable VHDL code for a 5-to-10 decoder with an enable signal, active low, and outputs…

A: kindly check step 2 for code

Q: What is the basic difference between ECL circuitry and TTL circuitry?

A: Here we will discuss the difference between TTL and ECL

Q: In a scheme, all the signal levels are on one side of the time axis, either above or below. Unipolar…

A: Explanation:- In a unipolar scheme, all the signal levels are on one side of the time axis, either…

Q: Write an MBED code to count from 0-15 and display its binary value on the MBED built-in LEDS with a…

A: On the mbed, the four on-board LEDs are digital outputs which have been specially configured to…

Q: Describe how to connect HDL modules together to create a digital system. Answer A bus is a…

A: Describe how to connect HDL modules together to create a digital system.

Q: Explain the relationship between spectrum-efficient and energy-efficient designs.

A: In wireless communication systems, the nonlinear effect and inefficiency of power amplifier (PA)…

Q: Generally, when an output waveform is found to be incorrect, what is the next step to be taken?

A: GIVEN : when an output waveform is found to be incorrect what is the next step to be taken?…

Q: The throughput of a flash ADC is measured in(a) displacement per second (b) distance per second(c)…

A: Given: The throughput of a flash ADC is measured in(a) displacement per second (b) distance per…

Q: RESET ICSP2 ∞ Arduino ZGREP RESET DIGITAL (PWM- EAE AS (UNO) POVER ANALOG IN 22092 JIL fritzing Now…

A: int led_pin = 6; int pot_pin = A0;int output;int led_value;void setup() {  pinMode(led_pin,…

Q: USE QUARTUS TO design a 32 to 1 bit Mux using VHDL show the WAVEFORM AND THE DIAGRAM !!

A: One of the possible methods is demonstrated for 32 to 1 MUX, using two 16 to 1 MUX and OR Gate.

Q: AIM- To study the gain and phase response of LTI system for different frequencies using Bode plot.…

A: Code clc; clear all; close all; syms s; num = poly([-10 -20]);         den = poly([0 0 0 -100…

Q: The percentage resolution of 10 bit DAC is more than 12 bit DAC Select one: True False

A: Refer to step 2 for the answer.

Q: EDIF stands for(a) electronic device interchange format(b) electrical design integrated fixture(c)…

A: EDIF stands for Electronic Design Interchange Format.

Q: Generate PWM codes in C using the ACLK to create a wave form of 150Hz with duty cycle of 20% and…

A: Please check the step 2 for solution of your question.

Q: Design a circuit to detect mobile phones with 4G frequencies

A:

Q: Total fields present in HDLC (High-Level Data Link Control ) frame format are : 7 5 O 4

A: Here in this question we have asked that total fields present in HDLC frame format are..

Q: using PIC16F917 and ATmega328.   Design a line follower car using 3 IR sensors located in front of…

A: Answer: I have done code  and also I have attached code as well as code screenshot and output.

Q: Compare the output waveform of Biased diode positive clipper from a Biased diode negative clipper?

A: Compare the output waveform of Biased diode positive clipper from a Biased diode negative clipper?…

Q: onstellation diagram shows us the __________ of a signal element, particularly when we are using two…

A: Required: A constellation diagram shows us the __________ of a signal element, particularly when we…

Q: quadrature

A: Introduction Encoder quadrature is a kind of encoder that is basically been used to increment coder…

Q: The base signal for the information signal is called the modulating signal or modulating frequency.

A: True

Q: regions. Calculate the numerical values of the quantisation limited output SNR for the 4-, 8- and…

A: The SNR can be represented in a chart as follows:

Q: Q: In VHDL, a port is

A: Ports were most commonly used during entities as well as components to declare interface signals of…

Q: Nyquist plot technique is the frequency response method for the analysis and design of control…

A: Nyquist plot of a frequency response is used in control or signal processing. So it helps in design…

Q: ICSP2 Arduino Code SIGITAL (PAR ∞ UNO Arduino ANALOG 22241 22092 JIL fritzing Now let's write a code…

A: According to the information given:- We have to follow the instruction and write a code to change…

Q: What is the total gain?

A: Solution for question number 11. is; As three amplifiers of 2, 5 and 10 gain power are connected in…

Q: Write the expressions of the LED’s of the seven segment display (assuming common anode…

A: The given question has asked to write the expression of the LED’s of the seven-segment display…

Q: Can you help me to solve this problem please Design a low-pass filter with the following…

A: Lowpass filter: The assignment of coming up with and building analog filters are often shifting into…

Q: Explain what the trailing and leading edges are in the nonideal pulse. Do digital waveforms perform…

A: Leading Edge: The edge at the beginning of pulse is known as leading edge. In other word, the…

Q: If you are required to choose a type of digital display for low light conditions, will you select…

A: Two types of 7-segment displays are the LED and LCD.

Q: H.W: control the intensity of the LED by serial. Assumptions: • LED attached to PIN 9. • control the…

A: I have simulated the circuit in TinkerCad. LED is connected to pin 9 of Arduino through a 100ohm…

Q: Make circuit diagram for interfacing and write program for LCD with 8051

A: Circuit explanation:⦁ It is a tedious process to interface LCD module with 8051.⦁ LCD- Liquid…

Q: Why are the enale lines specifically used for connecting two or more IC packages in accordance to…

A: Binary code that is of N digits can be used to store 2N discrete elements of coded data or…

Q: what is the depletion width towards n-Si for a reverse biased diode where V is the reverse bias…

A: Depletion width; It is the physical width of the depletion region in characteristic Si diode. It…

Q: he attenuation in the pass band or stop band is called a. Transition band b. Ripple c. Cutoff…

A: The attenuation in the pass band or stop band is called Transition band

Q: Ramp signal are use in PWM demodulator True False

A: PWM: PWM stands for Pulse Width Modulation. The general purpose of Pulse Width Modulation is to…

Q: Design N – bit add-sub unit using behavioral VHDL model

A: The behavioural model in VHDL describes how the circuit behaves. This behavioural model is the…

Q: Integrated circuits are fabricated from______________ materials that have ptoperties of a conductor…

A: To be determine: Fill the gap

Q: each of the light configurations shown in Figure 1. 000 100 010 110 001 Figure 1. A state diagram…

A: The answer given as below:

Q: A) What does VCO stand four? Show by drawing the relationship between its input and output signals.…

A: VCO stands for Voltage Controlled Oscillator. A Voltage Controlled Oscillator is an oscillating…

Q: Еxperiment: 1- Find and plot the output signal of the following system: 2 1.5 1.5 05 0.5 0.5 -0.5 -1…

A: MATLAB is a proprietary multi-paradigm programming language and  computing environment developed by…