A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4. Find the diameter of the outer conductor in cm. Assume the line is a lossless line

A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.9 Farad/meter, and 8 Henry/m inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4. Find the diameter of the outer conductor in cm. Assume the line is a lossless line

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.14P

See similar textbooks

Related questions

Q: R1 +V1 1 V R2 R3

Q: a 8Ω 5/45° A j10 2 -j6 N Find Thevenin's Voltage across a and b. ww

Q: 27.Transmission protocol serial asynchronous 8 bits ASCII, 1 parity bit, 9600 bps. How long will it ...

Q: Consider closed loop transfer function is, C(s) s+1 R(s) s² +(3+K)s+K Calculate the value of K such ...

A: Closed loop transfer function is given, Ts=s+1s2+3+ks+k The open loop transfer function is given by ...

Q: Find inverse Laplace transform of 10 F(s) = (s + 2)(s² + 6s + 10)

Q: 5) Determine if this transfer function can be approximated by a 2nd Order system 1 G(s) = (s2 + 16s ...

Q: In the circuit of Figure 10-3, assume you found that I, was the same as the current in R3 and R4- (a...

A: Given circuit:

Q: (c) Find the resonance condition of a series RLC circuit. Hence, show that the frequency response at...

A: Here is your answer! I hope this will help you.

Q: A balanced 3 phase star connected load draws power from a 430 V supply. Two wattmeter's indicate 880...

A: Here, we have given some information about the balanced three-phase star-connected load. The load i...

Q: R1= 50 I 12 V= Figure 1 1. In figure 1, find the following: a. Current I b. Power P c. Voltage in R5...

A: "Since, you have asked multiple question, we will solve the first question for you. If you want any ...

Q: Determine IC1, VCE1, and hiej of Q1. Determine Ic2, VcCE2, and, hie2 of Q2. Determine Zin and Zo. De...

A: "According to Company's guidelines we can solve the first three parts of the question". 1st part con...

Q: 6. A generating station has the following daily load cycle : Time (hours) 0-6 6-10 10-12 12-16 16-20...

A: "Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: The subtransient reactance of a generator is typically much larger than the steady-state reactance. ...

A: 1 ) generally the subtrasient response of a generator is larger than the steady state reactance. So...

Q: For the following circuit, find the CMRR the common mode rejection ratio in dB [ 20 Log() ], for Vo ...

A: The common-mode rejection ratio (CMRR) of an op amp is the proportion of common-mode gain to differe...

Q: For the Depletion-type MOSFET n

Q: Design a simple circuit for a ceramic heater that has three settings of Low, Medium, and High heat m...

A: Ceramic heaters are electric heaters that use a ceramic heating element with a positive temperature ...

Q: 5. Refer to Graphic E. What is the voltage across R2? 1.93 V 2.76 V 3.16 V None of the above

Q: 3.46 Consider a system with the following impulse response. h(k) = (–1)*µ(k) (a) Find the transfer f...

A: Given the impulse response as given: h(k)=(-1)ku(k) a) We need to find the transfer function H(z). b...

Q: 3Ω-13 Ω -j2 N j3 2 6 2 22 jó 2 -j15 Q j4 2 -j2 2 ell 50 V/ 60° (~ j3 2 -j9 2 12Ω j9Ω Figure 23-23 ll...

Q: Explain with an example, the compromise between frequency resolution and time resolution in the esti...

A: Bartlett Method- Bartlett method is used for the estimation of power spectra. It gives a way to redu...

Q: Design a CS amplifier using E-MOSFET with voltage gain 20dB , VGS=5V , VDD=12V ( gm=4500μS ).

A: CS amplifiers- Common source amplifiers are not used on their own in electronic circuits nowadays, m...

Q: 12. A power signal x(t) with no signal power outside the frequency range - fe/100 < f < fe/100 is mu...

Q: Problem 1 What elevation or height of a column of mercury will cause a pressure of 667.08 kPag?

Q: Explain how you could use an ohmmeter to identify the cathode of an unmarked diode.

A: Given: Ohmmeter

Q: 3.What is the binary equivalent with sign bit of -5 in 2's complement?

Q: Which of the following integrations finds the flus exiting the closed surface r= 5 for the vector fi...

A: Magnetic flux- It is defined as the number of magnetic line passes through a closed surface.

Q: Explain Transducer classification adding EXAMPLE to each category.

Q: Refer to the Graphic B. What is the current through R1? 5.34 mA O 2.73 mA 6.23 mA 3.90 mA None of th...

A: Option a 5.34 mA Ue basic ohms law Current = voltage / resistance Here current through R1 is the tot...

Q: F. Use this graphic for Question 6. R1 A 2 kQ R2 5 kQ B vs 35 V 34 kQ R3 3 ko

Q: 7-22 Abaschand signal with frequency components from near de to 15 kHz froquency modulales a 200-kHz...

Q: Find the circuit as shown, determine the resistance between terminals a & b.

A: We are authorized to answer one question at a time, since you have not mentioned which question you...

Q: (b) For the BJT circuit shown in Fig. 1(b), calculate the base current, Ig, collector current, Ie an...

A: Given circuit, Where, VCEsat=0.2 VVBEon=0.7 VV1=8 V VCC=5 VRC=440 ΩRB=640 Ω

Q: 2. Two empty capacitors, C1 and C2, are connected in series with R1. The capacitance of C1 is 2F, th...

A: We need to find out voltage and charge across capacitor in given circuit

Q: QUESTION 3 Using Figure 23-24 on page 688 of your textbook, calculate the magnitude of the voltage a...

Q: 2. Design a circuit diagram of an automobile alarm system which is used to detect certain undesirabl...

A: Answer - Given - 1. The headlights are "ON" while the ignition is "OFF" 2. The door is...

Q: v) Convert Decimal to Hexadecimal (a) 974510 (b) 2976.5410

A: As per guidelines we are supposed to answer only 1st question so please upload others separately.

Q: Problem 1 (Problem 2.8-1 from textbook) Given in Fig. P2.8-1 are two digital-filter structures, or r...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: Three vectors A, B and C lie on the 3D RCS. The scalar product of A and B is equal to -2. The scalar...

Q: 100nF Input Voltage AC Voltage 1MO 5 capacitor 5V diode 1N4001 -5 3V At which voltage value will the...

Q: Five dry cells having emfs of 2.30, 2.40, 2.35, 2.60, 2.25 Volts and resistances of 0.40, 0.20, 0.35...

A: It is given that: E.M.F of five dry cells: 2.30 V, 2.40 V, 2.35 V, 2.60 V, 2.25 V. Resistances of fi...

Q: 100 Vi = 1.025/0° V3 = 1.03/1.36851° 300 1 Z13 90.51 Slack 136.93 Z12 Z23 2 V2 = 1.001243L-2.1° 400 ...

Q: A team of electrical engineers wants a new smart phone’s battery to last for 12 hours. If the smart ...

Q: 1. Identify the different symbols seen in the schematic diagram. Write it in a piece of paper and ca...

A: The given circuit is as shown below, We need to identify the symbols in the circuit and make a bloc...

Q: 0, t < t2, 2t - 8, 0st 2st x(t) = %3D 0, 4 st "hat is the energy of the given signal? D13 O 17

A: Given signal x(t)=0t<0t20≤t<22t-82≤t<404≤t

Q: What is meant by FACTS in power systems? Discuss about UPFC type FACTS device

A: Power system- Power system is basically the interconnection of several components right from the gen...

Q: (a) What will happen if the primary of a transformer is supplied with a DC supply? Show that emf per...

Q: Design, a digital logic circuit in tinkercad that accepts inputs A, B and C from plane A, B and C. A...

A: The logic circuit for the given condition can be obtained by using the truth table and the simplifie...

Q: 2µF 2HF 12v 2HF JAHF

Q: 55. A motor is rated to deliver 2 hp. a. If it runs on 120 V and is 90% efficient, how many watts do...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Compute the charge stored on a 4-pF capacitor with a 24V across it.

A: The charge stored in a capacitor, Q in coulomb as the product of the capacitance C (in Farads) of th...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.4F/m, and 7.5 H inductance per meter. The diameter of the inner conductor as 0.8m,and the dielectric constant of the insulation as 4.97. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.4 F/m, and 7.5 H inductance per meter. The diameter of the inner conductor as 0.8m, and the dielectric constant of the insulation as 4.97. Find the diameter of the outer conductor in cm. Assume the line is a lossless line?
It is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the dielectric medium. Assuming negligible losses, find the inner radius of the outer conductor (in mm) for a 76 Ω coaxial line, where the radius of the center conductor is 0.6 (mm).
1. What is the necessary condition for matching transmission lines? In addition, what is a micro strip line? 2. For a distortion less line α = 0.02dB/m, Z0 (R0) = 60Ω and C = 0.2nF/m. Find the resistance and velocity of wave propagation. [Do not forget the units.] 3. For a finite lossless transmission line with open-circuit termination, sketch Xio vs l. Indicate where the sketch is inductive and capacitive.
A coaxial, air-gapped transmission line consists ofa solid inner conductor of radius a and a thin outerconductor of inner radius b. Determine theinductance of the line per unit length?
A lossless coaxial cable transmission line has L = 200 uH/ft and C = 100 nF/ft. The inner diameter of the outer conductor is 3 cm and the diameter of the inner conductor is 1 cm. What is the dielectric constant of the insulator?
An air co-axial transmission line has a solid inner conductor of radius ‘a’ and very thin outer conductor of inner radius ‘b’. Determine inductance per unit length of the line.
Topic: Electromagnetic Waves. Please help with this question. The observed standing wave ratio on a 100 Ω lossless line is 8. If the first voltage maximum occurs at 0.3λ from the load, calculate ZL and voltage reflection coefficient at the load.
A 55 -km long, 50 Hz, single-phase, 2-wire, transmission line is composed of 26 -mm diameter solid conductors. If the separation between conductors is 2.8 m., What is the inductance per conductor per unit length in (mH/km)?
A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100 MHz. At an electrical length of 0.8 wavelengths, what is input admittance?
A lossless coaxial cable transmission line has L = 200 uH/ft and C = 100 nF/ft. The inner diameter of the outer conductor is 3cm and the diameter of the inner conductor is 1cm. What is the dielectric constant of the insulator?
With a neat diagram show the reflections occurring in a transmission line. Hence explain thec conceptsof Reflection co-efficient and VSWR associated with it.