A prisoner do on a metal while stayed on the earth. An action happen where 6Amp passees at the ground. The structure if radius of 0.2 m. Assume that the resistance of the body is 2000 ohm and the ground resistance is 100 ohm.m. determine the current (in Ampere) using man.

A prisoner do on a metal while stayed on the earth. An action happen where 6Amp passees at the ground. The structure if radius of 0.2 m. Assume that the resistance of the body is 2000 ohm and the ground resistance is 100 ohm.m. determine the current (in Ampere) using man.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 1PA: You are working as an electrician in a large steel manufacturing plant, and you are in the process...

See similar textbooks

Related questions

Q: In RL series circuit, voltage across resistor is 6V and voltage across inductor is 8V. Power factor…

A: Given data, Voltage across resistor VR=6 V. Voltage across inductor VL=8 V.

Q: d L = 0.1 H. What should the value of C be in order for i(t) to exhibit a critically mped response?…

Q: Design a counter that has an En (Enable) input such that when En is equal to 1 the counter goes…

A: Given, A counter has En(Enable) input. When En=1, the counter sequence is 0,1,2,3,0,1.... When En…

Q: Question 3 Determine Vo during the Negative Half Cycle of the input voltage. 10 V -10 V 10 kQ2 5.3 V…

A: In this question We need to determine the output voltage Vo . Assume forward bias voltage drop of…

Q: Ł i(t) Figure 3

Q: A thin layer of wires forms an infinite sheet of current. There are 15 wires per meter and each wire…

A: Given- Total number of wires = 15 Each wire carries a current, I = 8 A To find- The magnetic flux…

Q: For a magnitude comparator with active-HIGH output functions AEQB, AGTB, and ALTB is it ever…

Q: A transformer with 10: 1 rato and rated at 50 KVA, 2400 7 240 V, 50 Hr is used to step down the…

Q: 1. A 75 KW 2.50 volt compound generator (short-shunt) has a series field in which each coil is!…

A: Given information about a shunt generator is written below. Voltage regulation VR=8%. Rated output…

Q: What major RF band does 108 MHz belong? Answer in acronym.

A: We need to write the major RF band (in acronym form)does 108MHz belong

Q: lov +1 301 w 102 w ≤15-22 201 m US ль (+) rav

A: We need to find the current through 10 ohm resistor i.e 'I'. Using nodal or superposition or source…

Q: Calculate the pulse width, rise time, and fall time of the pulse below. DPS sprayday 88828872220 0 5…

A: Given: To find: Pulse width, rise time, and fall time of the above pulse.

Q: Determine the transfer function for the system shown below whereby Vi(t) and Vo(t) are the input and…

Q: Q/For the following ANN find the output (sigmoid 0.32 0.19 -0.18- 0.45 0.2 -0.46 -0.22 -0.45 -0.4…

Q: What is the name for the circuitry that can be added to a cascaded or ripple adder to allow it to…

A: Each full adder stage's ripple carry adder carry output is passed on to the following full adder and…

Q: A 3-4 transmission line is supported by a 3-unit suspension insulator string. The voltage across the…

A: Given- 3-phase transmission line, 3-unit suspension insulator string, so, no. of units =3, Voltage…

Q: Q2 Find the values of K and a so that the peak Overshoot for a step import is 25% and Peak time is 2…

A: In this question We need to determine the value of k and a of the given system. We know Standard…

Q: Given the truth table of a set of digital circuits with four inputs (a,b,c and d) and three outputs…

A: The truth table is as shown below,

Q: Explain how the tie line power deviation can be incorporated in two area systems block diagram?…

A: Interconnected power system provides economy and continuity of power supply. Consider two areas are…

Q: VG40- VG30- VG20- Vin O VDD ₁₁ PMOS 24 PMOS 23 2₂ NMOS 2₁ NMOS - Vout

Q: In a series parallel circuit, how can you tell which resistances are in series with each other and…

A: To explain: In a series parallel circuit, how can we say which resistances are in series with…

Q: 0,1200 A Α10 j(10+z) Ω 2012 Figure 2 b 32 0 •(68+x}$

Q: 1. Show that the transfer function H(f) for the RL circuit shown below is given by H(f) = 1+1/ where…

Q: Create a circuit design for 2.4V output voltage divider, Create a circuit design for 8V output…

A: here we have to design circuits.

Q: A fifth-order LP Chebyshev filter function has a loss of 72 dB at 4000 Hz. Find the approximate…

A: According to the question, for a fifth-order LP Chebyshev filter function has a loss of 72 dB at…

Q: A voltage (t) = 100 cos(60t+20°) V is applied to a parallel combination of a 28-k resistor and a 44-…

Q: A 132 kV transmission line has impedance of 500. The line is protected by distance relay, and it is…

A: Given: A 132 kV transmission line protected by distance relay having, Impedance of transmission line…

Q: Q. Consider the following non-matched CMOS inverter shown in the figure with Vtn=-Vtp=0.4 V, and…

A: Given: In this question, the given details are, Consider the following non-matched CMOS inverter are…

Q: A4-pole series motor has 944 wave-connected armature conductors. the flux per pole is 34.6 m Wb and…

Q: 1. Determine the equivalent impedance across 'a' and 'b'. j12Ω 5Ω CD W 4Ω j9n αδ by W 4Ω j13Ω j112,…

Q: A three-phase (+) abc-sequence Y-connected source supplies 14 kVA with a power factor of 0.75…

Q: Determine the equivalent impedance across 'a' and 'b'. j120 5.2 W 4.2 j9n be ww 4.0 j130 j112 j20Ω…

A: Given impedance network as follows.

Q: PROBLEM 3: Consider the following circuit operating at steady state in which Vs(t) = 12V Is(t) =…

Q: 1.Determine if the system is time (shift) invariant and linear. x[n] N y[n]

Q: Describe the Transient stability analysis for SVC

A: Static VAR Compensator The SVC produces reactive power when the system voltage is low (SVC…

Q: Determine V and I of a short transmission line, if Z is... a) 600+ j2002 and 200 + j300 are in…

A: Given statement is converted into electrical circuit as follows.

Q: Norton equivalent FR₁ d 1022² 2A R₂=4-₁2 -ЛАМА- Ra 952 R4 42 RN || >

A: In this question We need to determine the Norton equivalent circuit. We are solving this problem…

Q: Solve the sub-part (C) only, no handwritten, only typing

A: R=20ΩL=80mHVs=200 V(rms)f=50 Hz

Q: A 4 pole DC shunt generator with 800 duplex wave connected armature conductors supplies a load of…

Q: CALCULATE THE TOTAL RESISTANCE FOR THE SERIES CIRCUIT WHICH CONNECTED TO 24V BATTERY ACROSS 4 Ω AND…

A: CALCULATE THE TOTAL RESISTANCE FOR THE SERIES CIRCUIT WHICH CONNECTED TO A 24V BATTERY ACROSS 4 Ω…

Q: Calculate the complex power S for all the six circuit elements. Hint: use mesh-current method. 304 v…

Q: In a series parallel circuit with 12 resistances, if there are three in one parallel bank, these…

Q: d 12 using mesh analysis. Blank 1A 60 V 752 h 12 f h 60 ly 12 F

Q: Q1. Rank the below events in ascending order of generated frequencies (from the slowest to the…

A: A power system's frequency is a dynamic variable that changes in real-time and represents the…

Q: 6. Problem 4 using mesh current method: In the circuit below, vs(t) = 40 cos(200t +30°) V. Use the…

Q: Question 1-) For the circuit given below, use superposition to find current i. 120 V + 4 ΚΩ m 2.50 +…

Q: 8.6 Given that B = 6xa, - 9ya, + 3za. Wb/m², find the total force experienced by the rec- tangular…

A: Given: B=6xax-9yay+3zaz Wb/m2

Q: An AC voltage v(t) = 248 sin 314 is applied to an SCR half-wave rectifier if the SCR has a forward…

Q: Draw the equivalent circuit diagram of self-excited DC shunt generator and explain the following:…

Q: GIVEN Fino y(t) к се ш -505 Low pass FILTER у () if 10 = A cлort +всюют , уо

Question

A prisoner do on a metal while
stayed on the earth. An action
happen where 6Amp passees at
the ground. The structure if radius
of 0.2 m. Assume that the
resistance of the body is 2000
ohm and the ground resistance is
100 ohm.m. determine the current
(in Ampere) using man.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are working as an electrician in a large steel manufacturing plant, and you are in the process of doing preventive maintenance on a large DC generator. You have megged both the series and shunt field windings and found that each has over 10 M to ground. Your ohmmeter, however, indicates a resistance of 1.5 across terminals S1andS2. The ohmmeter indicates a resistance of 225 between terminals F1andF2. Are these readings normal for this type machine, or is there a likely problem? Explain your answer.
A 30-volt electromotive force is applied to an ??-series circuit in which the inductance is 0.1 henry and the resistance is 50 ohms. Find the current ?(?) if ?(0) = 0. Determine the current as ? → ∞.
An electric wire having a mass of 0.5 kg/m along the horizontal is suspended between supports of the same elevation which is 50m apart. If the maximum tension in the wire is 800N, find a. the minimum tension b. the sag c. the length cable
Compute for the resistance of (i) silver, (ii) copper, and (iii) aluminum wire using these Equations in the given. For the three wires, the length is 2 meters, the diameter is 1 millimeter, and the temperature is at 27◦C.
The wires of our appliances are insulated with a material mixed with rubber, which has a very high resistivity. If a certain wire has a length of 2.5 m and the outer diameter is 5mm and its inner diameter is 0.5mm, what is its resistance? Note that the inner diameter is present to leave a hallow place where conducting wire ( usually copper) is present. Follow the format: Given: Required: Equation: Solution: Answer:
For an electrical component, the formulas for charge and voltage are given below. A is 9 coulombs, B is 12 seconds, C is 3 volts, and D is 24 seconds. Give the current of this component at t1 = 8 sec. You must round your answer to the nearest thousandth and give your answer as an integer followed by the appropriate metric prefix and the letter that represents the units of current.
Estimate the AEP for a 3-MW wind turbine in a wind regime that has a CF= 30%. For this turbine explain why the increase of wind speed to levels greater than 25 m/s generates less electrical power compared to wind speeds around 11 m/s
Current is the flow of charges in a directed path. When we connect yourmobile phone charger to the sockets in your various homes, charges startflowing through. Describe into details where these charges are generatedfrom and the processes involved.
When electricity is transported from a power station to a city, the line voltage (relative to ground) is usually on the order of several hundred thousand volts. A power line cable has a radius of a = 2.0 cm, is made of aluminum with a resistivity of ρ = 2.7×10−8 Ω ⋅ m, and spans a distance of l = 100 km from a power station to a city. The city consumes 100 MW of power (so I2RL =100MW). (a) Find the resistance of the power cable between the station and the city(i.e.,between points A and B). (b) Suppose that the line voltage ∆VBC = 120 V. i. How much current is required to flow through the power line to deliver 100MW of power to the city? ii. How much energy is lost as heat between points A and B? (c) Suppose that the line voltage ∆VBC = 300 kV. i. How much current is required to flow through the power line to deliver 100MW of power to the city? ii. How much energy is lost as heat between points A and B?
In a design task, a wire of 2000 m requires to exhibit a voltage drop of 2.5 Vwhen 3.2 A of current passes though it. Based on the Table Q1 (b) below, inyour opinion, which of the wire is the most suitable for aviation when the fuelsaving is another factor to be considered as well.
An engineering student from TCC purchased a wire at IC marketing that has resistance of 960 ohms, 29.335 yards in long with cross sectional area of 66 CM. Determine what kind of material does the engineering had purchased. Assumed (T= 20°C)?
Write the application of super tension that have rating upto 33KV and what used for?