A productive well pump water from a confined aquifer at a constant rate of 25.0 liters/second. The drawdown in two piezometers located 30.0m and 40.0m apart from the well are 4.0m and 2.0m respectively. Assuming the aquifer to be 35.0m thick. Calculate the transmissivity of the aquifer in m³/hr and m³/day.

A productive well pump water from a confined aquifer at a constant rate of 25.0 liters/second. The drawdown in two piezometers located 30.0m and 40.0m apart from the well are 4.0m and 2.0m respectively. Assuming the aquifer to be 35.0m thick. Calculate the transmissivity of the aquifer in m³/hr and m³/day.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.4P

See similar textbooks

Similar questions

A confined aquifer has a thickness of 85 ft. An 86-in diameter well drilled to the bottom of the aquifer, as shown in fig 3-10, if the hydraulic conductivity of the aquifer is 10 ft / day, and if water is originally 170 ft deep in the well, calculate approximately the maximum rate of flow that can be pumped from the well without dewatering any part of the aquifer. Assume 1000 ft reasonable value for the radius of influence. What will be the average velocity ( Darcy velocity ) of flow in the aquifer at a distance 20 ft from the center of the well?
A well pumps at a steady rate of 600m3/day in a confined aquifer. It is installed with a gravel pack in a hole that is 30 cm in diameter. The head in the pumping well is 427.9 m. The head in an observation well located 8 m away is 430.2 m. Calculate the transmissivity of the aquifer, assuming steady, radial flow.
A 300-mm diameter test well penetrates 27m below the static water table. Water is pumped at the rate of 69 liters per second for 24 hours. The water levels at two observation wells 35m and 95 m from the well were lowered by 1.10m and 0.50m, respectively. Which of the following most nearly gives the transmissivity of the aquifer?
A well with a 0.25-m diameter fully penetrates an unconfined aquifer that is 20 m thick. The well has a discharge of 0.015 m ・ s−1 and a drawdown of 8 m. If the flow is steady and the hydraulic conductivity is 1.5 × 10−4 m ・ s−1, what is the height of the piezometric surface above the confining layer at a site 80 inches from the well?
In an artesian aquifer of 8m thickness , a 10cm diameter well is pumped at a constant rate of 100 liter/minute . The steady state drawdown observed in two wells located at 10m and 50m distances from the center of the well are 3m and 0.05m respectively , compute the (Kb) and hydraulic conductivity of the aquifer ?
A confined aquifer has a source of recharge as shown in the figure. The hydraulic conductivity of theaquifer is 40m per day and its porosity is 0.25. The piezo metric head in the two wells with 13.25 mapart are 65m and 60m respectively from a common data. The average thickness of the aquifer is25m and the average width is 4km.a. Compute the rate of flow through the aquifer in cu.m per day.b. Compute the seepage velocityc. Compute the time of travel from the head of the aquifer to a point 4 km downstream in days.
A 30 cm diameter well penetrates vertically through an aquifer to an impermeable stratum which is located 18.0m below the static water table. After a long period of pumping at rate of 1.0m^3/min, the drawdown in test holes 14m and 40m from the pumped well is found to be 2.62m and 1.50m respectively. What is the coefficient of permeability of the aquifer? Express in meters per day. What is its transmissibility? Express in cubic meters per day per meter. What is the drawdown in the pumped well?
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic metres per minute is pumped out of the aquifer through a tubewell till the water level in the tubewell becomes steady. Two observation wells at distances of 15 m and 70 m from the tubewell show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability in mm/s of the aquifer. a.3.28 x 10^-1 b.4.68 x 10^-1 c.2.58 x 10^-1 d.1.18 x 10^-1
b) A 30-cm well fully penetrates an unconfined aquifer of saturated depth 25 m. When a discharge of 2100 lpm was being pumped for a long time, observation wells at radial distances of 30 m and 90 m indicated drawdown of 5 and 4 m respectively. Estimate the coefficient of permeability and transmissibility of the aquifer. What is the drawdown at the pumping well?
a 30 cm well penetrates an unconfined aquifer of saturated depth 25m. When a discharged of 2100 lpm was being pumped for a long time, observation wells at radial distances of 30 and 90 m indicated drawdown of 5 and 4 m respectively. estimate the coefficient of permeability of the aquifer and the drawdown at drawdown at pumping well.
A confined aquifer has thickness of 33km and 7km wide. Two observation wells are located 1.2km apart in the direction flow. The head in well one is 97.5m and well two is 89m. i) What is the total daily flow through the aquifer? (Hydraulic conductivity of the aquifer is 1.2m/day) ii) What is the elevation of the potentiometric surface at a point located 0.3 from well one and 0.9 from well two?
An unconfined aquifer is known to be 32 m thick below the water table. A constant discharge of 2 cubic meters per minute is pumped out of the aquifer through a tube well till the water level in the tube well becomes steady. Two observation wells at distances of 15 m and 70 m from the tube well show falls of 3 m and 0.7 m respectively from their static water levels. Find the permeability of the aquifer (mm/s).