A quaternary PCM system works for sinusoidal modulation signa of 40 dB, ne desired SNR if 50 dB, find the new levels of quantization that must be added to make the system works under targeted SNR for sinusoidal modulation signal and the bits added M = 179 levels; N=4 bits M = 180 levels; N=5 bits M = 177 levels; N=2 bits M = 178 levels; N=3 bits

A quaternary PCM system works for sinusoidal modulation signa of 40 dB, ne desired SNR if 50 dB, find the new levels of quantization that must be added to make the system works under targeted SNR for sinusoidal modulation signal and the bits added M = 179 levels; N=4 bits M = 180 levels; N=5 bits M = 177 levels; N=2 bits M = 178 levels; N=3 bits

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a binary pulse code modulation system, if the frequency of the baseband signal is 12.5 kHz, then what will be the minimum transmission bandwidth of the PCM waveform if a uniform quantizer having 32 levels is used.
To create a Pseudo Noise code of length 15 bits, how many shift registers are required? Techniques used in Wideband Modulation are: 1. Direct Sequence Spread Spectrum 2. Orthogonal frequency Division Multiplexing 3. 1 & 2 4. Frequency Hopping 5. 1, 2, &3
A quaternary PCM system worksfor sinusoidal modulation signa of40 dB, the desired SNR if 50 dB,find the new levels of quantizationthat must be added to make thesystem works under targeted SNRfor sinusoidal modulation signal.and the bits added
- An AM signal has a carrier of 10MHz and modulating signal of 10kHz. It has a modulation index of 0.7. Write its expression an calculate power efficiency?
Q24)This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer. The choice of the number of bits per PCM word depends on the a. SNR b. Bandwidth c. None of the mentioned d. SNR and bandwidth
Assume that a voice channel occupies a bandwidth of 4 kHz. We need to combine three voice channels into a link with a bandwidth of 12 kHz, from 20 to 32 kHz. Show the configuration, using the frequency domain. Assume there are no guard bands in computer communication and network?
Explain why we can still receive monophonic FM signal with our stereophonic FM receiver by showing its block diagram and discussing it
q16)This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer. A baseband system has a signal-to-noise ratio of 23 dB and a bandwidth to bit rate ratio of 0.4 .The average bit energy to noise spectral density of this system is equal to------- a)none of the mentioned b)125 c)250 d)80
Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher than the Nyquist rate. The maximum quantization error of the sample amplitude is 0.5% of the peak amplitude? . Assume binary encoding. Calculate the minimum bandwidth ? of the channel to transmit the encoded binary signal.
We need to send data 15bits at a time at a bit rate of 9Mbps. The carrier frequency is 18MHz.Calculate the number of levels (different frequencies), the baud rate, and the bandwidth.
A PCM binary stream is produced using an 8,000 samples/s rate and 7-bit encoding. 32 synchronization bits are inserted into the binary stream for every 224 data bits. The resulting binary stream is then transmitted in two-level pulses over a baseband channel, with r = 0.2. This is followed by digital band-pass modulation before the transmission. a. What is the bandwidth of the baseband transmission? b. Determine the bandwidth of the pass-band transmission under the following digital modulation schemes: c. BPSK. d. QPSK. e. BASK.
A. If the probability of error of BPSK is 0.85 then Pe of BFSK is? B. What happens to the radio wave propagation when the rouefractive index of ionospheric layer becomes low or high? C. If the number of quantization levels are multiplied by four time them how many numbers of bits are added to the actual number? D. What is the disadvantage of wave tilt? E. What is a bipolar line coding technique with phase encoding, and explain why it is named as phase encoding method? F. What is oblique communication circuit? G. What are the differences between DPCM and Delta Modulation? H. What is the change in bandwidth when channel capacity is doubled and two number of bits are increased?