A refrigerator is rated at 100 and is connected to a 12-V DC source. What is the current in therefrigerator, assuming that the other sources of resistances are negligible?

In this question refrigerator voltage rating and resistance is given...We have to find out current…

Answered: A refrigerator is rated at 100 and is…

A refrigerator is rated at 100 and is connected to a 12-V DC source. What is the current in tE refrigerator, assuming that the other sources of resistances are negligible?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Related questions

Q: Solve the current using superposition theorem and solve for the individual currents of each…

Q: 3. The signal to noise ratio initially measured at the transmitter was 33 dB. The signal power was…

A: We need to find out signal to noise ratio

Q: R V = 12 V, V1 = 6 V Determine the maximum output voltage O 18 V O ov O 6V O 30 V

Q: Describe the result (output waveform) Vp = 12.8 V Vrms = 10 Vdc = 8.149 V

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for…

Q: For the voltage-divider circuit shown, check the appropriate analysis to be used and please solve…

Q: 2. Ap Determine the output x from the NOR gate for the given input waveforms. A B

A: As per our guidelines we are supposed to be answer the first question only. Kindly repost the other…

Q: An open–wire transmission line is made from two wires, each with a diameter of 2 mm, located 20 mm…

A: In this question we will find characteristic impedance of open wire transmission line....

Q: What is the voltage output for each alternation (Vpp)? * R2 A D1 R1 35V V1 ww

A: In this question, Diode circuit is given. Assume diode is ideal. So VD = 0V Find the peak to peak…

Q: 20 Vrms : Si Si 1 ka R Ge Ge Determine the diode current

A: In this question, choose the correct options What is current in the diode

Q: 2. For the given op-amp circuit, determine R4 and R5 such that the gain Av=Vo/Vi is adjustable from…

Q: The devite shoun belou वर् valtagesource. s cam be. modeled by witha resistor in sories ती The table…

Q: What is the conductivity of AWG #32 tungsten wire with a resistance of 0.0172 2/cm? The diameter of…

Q: Ohm's Law states that the electric current flowing though a ________ is directly proportional to the…

Q: Use mesh-current andilysis below. I1 820°v j1Q 4Z0°v 10 I2 I3 Vx 10 2Vx 下-ゴ10 Is

Q: Find I3 if l1=5 mA, I2=7 mA, la=6 mA and Is=8mA. Currerts Node In Is 12 Currents Out I3 I4

A: Given circuit: I1=5 mAI2=7 mAI3=6 mAI5=8 mA

Q: current of 0.25 A exists in a 60-ohm lamp. The applied potential difference is * A. 15 V B. 30 V C.…

A: We need to find potential difference for given current and resistance

Q: Find the work done in moving at point charge Q = 20 μC from the origin to (4,2,0) m in the field…

A: The work done in moving a point charge can be calculated by using the general expression of work.

Q: rectangular form

Q: 6 USE MESH ANALYSIS TO FIND Vo AND I2 12Y 34Kn I2 y 4kn Vo

A: Given: Circuit diagram

Q: In order to get higher speed of Dc motor ..... ..... .. voltage supply most be low O back emf (Eb)…

A: In DC Shunt motor the speed is directly proportional to back EMF. As Back EMF = (PHI* Z*N/60) *…

Q: In a zener regulator circuit, find the voltage regulator percentile factor with the circuit diagram…

Q: show work

Q: Find the voltage drop across 4-ohm resistor and the energy dissipated across 2-ohm resistor after 20…

Q: What is the cutoff frequency of a plasma filled [ = %,E= Eocl-w)gWp= 8TTXO sec ] perfectly…

A: Solution- We know that cut off frequency of rectangular wave guide is- fc =12μεma2+nb2…

Q: A 2400/2200 volt auto transformer delivers a load of 90.5 Kw at a pf of 0.75. Solve for the current…

Q: A 100kW, 230V, shunt generator has an armature resistance and field resistance of 0. and 57.50. If…

A: In this Question, shunt generator is given....We have to find out at what load the generator achieve…

Q: a 30-hp three-phase squirrel-cage induction motor is connected to 240 volts. the motor is to be…

A: The full load current of the motor with the given specifications is determined using Table 430.250.…

Q: 7. If line frequency is 60 Hz, what is the output frequency of a bridge rectifier? 8. If the load…

A: As per the guidelines given to us, we can only provide the solution of first question in multiple…

Q: A 30 TL has the following data: Zu/wire = 15 + j30 Q; shunt capacitive susceptance at the middle of…

Q: Design an active band pass filter with Gain= -20 and cutoff frequencies at 100 Hz and 10 kHz using…

A: The band pass filter will allow only range of frequency and reject the remaining frequency.

Q: 6.34. What is the conductivity of AWG #32 tungsten wire with a resistance of 0.0172 2/cm? The…

Q: The Fourier Series

Q: At extremely high frequency then the imaginary terms in Eq. 4. dominate – i.e. we can neglect the…

A: In this case, the given expression needs to be explained.

Q: Q2) Modify this boolean expression and draw the ladder diagram? Q = CŌ+A+7D+Ā %3D

Q: Q4. Determine the power delivered by the de battery in the following figure: ............

A: Voltages across the parallel circuits will be same and current will divided based on resistance…

Q: V T -V V = 16 V, V1 = 5 V Determine the maximum output voltage. O ov O 5 V O 21 V O 16 V 19

A: The solution is given below

Q: given the expression below Reqd 1.) grouped k-map in POS 2.) minimum POS expression

Q: A load impedance ZL = 25 – j50 N is connected to a 50 Q transmission line. Insert a shunt capacitor…

A: Transmission Line: A transmission line is a specialised cable or other structure used in electrical…

Q: 5. Which is better network/system a wifi having S/N 40 dB or the network/system with a S/N of 20 dB?…

A: In this question, Choose the which system is better? If SNR ratio of both system are different…

Q: 5) The electric flux density is defined as D = 3x²a, + 2xya, + yza,. Determine the SD. ds, where S…

A: We need to find out integration of electric flux for given surface

Q: The following characteristics have been measured on a lossy transmission line at 100 MHz: Zo = 50 +…

Q: A uniform line charge pe= 2 nC/m lies in the z =0 plane parallel to the x axis at y=3 m. Find the…

A: Potential difference: It is the difference between the two voltages and its unit is also volt.

Q: Find ir in the circuit in (Figure 1). Suppose R = 8 kN. The op amp in the circuit is ideal. Express…

A: In this question, We need to determine the Value of current iL as shown in the circuit. We are…

Q: 3. Draw the AC equivalent circuit of the common collector amplifier below and calculate the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: involves the formation of cross-functional teams in developing product and process designs.…

A: Given: Fill in the blank ________ involves the formation of cross function teams in developing…

Q: R9 R. Vo1, R R Vo2 V1-2V, V2-3V, V3-4v RI-IK R-4.7ΚΩ, R3-1KΩ, R4-2KΩ, RS-10ΚΩ, R6-2KΩ, R7-2K RS-2…

Q: 5. Determine the expression of the output x, then simplify the expression. A В X 6. Write the…

Q: A rectangular flat surface with sides 0.200 m and 0.500 m is under the influence of a uniform…

A: It is given that: Length of sheet=L=0.2 mWidth of sheet=b=0.5 mUniform Electric field=E=85 N/CThe…

Q: sing Given that D = 2pcosp a, az, in cylindrical coordinates, find the flux crossing 2p %3D the…

A: We need to find out flux crossing the given surface

Q: Draw the DC and AC load line for a transistor amplifier circuit shown in Figure, also describe the…

A: For the given circuit diagram-Given,Rc=10kΩ; RL=20kΩ; Vcc=20 V For DC Load Line- 1) Remove all AC…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

A refrigerator is rated at 100 and is connected to a 12-V DC source. What is the current in the
refrigerator, assuming that the other sources of resistances are negligible?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The variable dc current source in the circuit in (Figure 1) is adjusted so that the power developed by the 15 A current source is 4300 W. You want to find the value of idc. Suppose that v = 560 V.
If a circuit has two equal parallel resistances connected to a 150V DC power source , then the P.D. exist between the mid-point of one resistance and a point that is one-third from the other resistance equal to -----
Suppose that the voltage source has an internal series resistance of 50 Ω. How would the outputvoltage be affected (assuming that R1 and R2 are the same as you specified earlier)? Work out your resultsfor both the ideal voltage source and for the voltage source with the internal impedance. R1 and R2 are both 3 Ohms and Vin = 10 V
The diagram shows an ideal (zero internal resistance) DC source connected to three identical resitances and a switch. In the diagram, the switch is open. If initially, the switch is open, what happens to current I1 and I2 after the switch is closed?
Compare the sum of the voltages across (R1, R2, R3) and (R5, R6, R7) and R4 with the 12-V DC supply voltage. What have you observed?
Using Kirchoff's voltage law to determine the unknown voltage V3 for the configuration given in the figure below. Given that: - The source E= 90 V, - V1= 10 VV and V2= 10.3 VV.
In a DC circuit as shown, the high resistance voltmeter gives a reading of +0.435 V. What is the value of resistance R?
A 2 kW DC Motor is connected to a 120V source. If the DC motor is assumed to be resistive, how much current does it draw from the source? How much resistance will you connect in between the supply and motor to limit the power of the motor to 1kW?
Topic: DC CIRCUITS An electric heater connected to a 120-V source consists of two identical 0.4 ohm elements made of Nichrome wire. The elements provide low heat when connected in series and high heat when connected in parallel. Find the power at low and high heat settings. Note: DRAW THE DIAGRAM
Analyze the circuit of the figure shown to determine the voltages at all nodes and the currents through all branches. Where β=30, ?????? =0.2 V, ??? = 0.7 V and assume thetransistor is silicon.
What is the equivalent Effective resistance of the circuit in the figure?
The voltage across the 16-ohm resistor in the circuit is 80 V, positive at the upper terminal.a. Find the power dissipated in each resistorb. Find the power supplied by the 125 V ideal voltage source