A resistor and a capacitor areconnected in series across a supply of250V. When the supply frequency is50HZ, the current in the circuit is 5A.When the supply frequency is 60HZ,the current is 5.5A. Find the value ofthe capacitance.96.436 microfarad43.966 microfarad34.696 microfarad63 943 microfarad69 436 microfarad36.496 microfarad

Given The resistor and capacitor are connected in series Supply voltage V=250 v frequency is 50 Hz…

Answered: A resistor and a capacitor are…

A resistor and a capacitor are connected in series across a supp 250V. When the supply frequency 50HZ, the current in the circuit is 5 When the supply frequency is 60H

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 35RQ: Which of the following is the capacitance of two 20-microfarad running capacitors connected in...

See similar textbooks

Related questions

Q: A vector field eat Find the vector field intensity e point. c,3,5) a. 16.9 b. 14.99 C. 12.49 d. 10.4...

Q: 1) What is meant by measurement? 2) What are the basic requirements of measurement? 3) State the two...

Q: Q1 – For the circuit of Figure below: a) Determine Thevenin equivalent circuit at the output termina...

A: Thevenin's Theorem is a strategy for converting a circuit (usually a complicated one) into a simple ...

Q: When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1.325 A. Wh...

A: The solution is given below

Q: Vector Field C= «ty)ax+ xay +Cy+ZJQz D= (2ty)ax+ Yay t (xtD az A+B = ? a-(2x +ytz Jaxt+ (+2yayt b-(x...

A: The solution is given below

Q: QUESTION 37 For the step down transformer below the turns ratio is 9:1, the primary voltage is 88 V ...

Q: 13) In a PNP circuit, the collector is positive with respect to the emitter. 14) The output is in ph...

A: I am attaching detailed solution image of this question.

Q: 1. A wye connected load has a 5 < 20° ohm impedance per phase and is connected across a 120 V three ...

A: In this question star connected load is given with phase impedance and line voltage....We have to fi...

Q: 1 Ohm 2 Ohms 4 Ohms 4 Ohms ELECTONICS HU acov A07 H Ohms m

Q: 1. The electric field intensity vector of a uniform plane electromagnetic wave is given a E(x,t) =10...

A: Note : We are authorized to answer three subparts at a time, since you have not mentioned which par...

Q: Vector A=3 Gx +4 cy +5ậi BE Sâx - Gây-3ấz find AX B a Jaxt 3tag-3392 c 17axt>tag-56a2

A: In this question we need to find a cross product of two vector field.

Q: The emitter current and the base current of a npn BJT are 1.46 mA and 14.46 µA respectively. Calcula...

A: Given, Emitter current, IE = 1.46 mA Case current, IB = 14.46 μA = 0.01446 mA Saturation current, Is...

Q: A certain series RL ac circuit has an instantaneous power of p(t) = 125 + 250 cos 240xt. Find the po...

Q: Apply Bilinear transformation to H()=8/[(s+3)(s+4)] with T=0.5s. Find H(z). Realize the filter with ...

A: Hs=8s+3s+4Hs=8s2+7s+12 Putting values of s as, s=2TZ-1Z+1 And, T=0.5

Q: Essay 1. Discuss how electric circuits can be understood in relation to water flowing in pipes.

A: The electric circuit can be understood in relation to water flowing in pipes: The pump drives the wa...

Q: 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequenc...

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-cycle source is then...

Q: Most Digital transmission are "self-clocking "in that they derive the bit synchronization fror the s...

A: We know, Most of the digital transmissions are "self-clocking," meaning that the bit synchronization...

Q: A coil has a resistance of 24 Ω at 50°C and 32 Ω at 120°C. Find the resistance at 0°C and the temper...

Q: 57 V 42 V 幸V 25 V幸 70 V

Q: Question 6 Two conducting cylinders at p= 2 cm and p = 8 cm in free space are held at potentials of ...

A: Here, we have given two conducting cylinders, for which the 'ρ' is varying. So, we will perform inte...

Q: 5. Develop an assembly language program that continuously gets 8 bit data from P0 and sends it to P1...

A: Program-

Q: A 100-mH inductor is connected in parallel ta

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 2...

Q: What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10 cos2...

A: It is given that: C=20 μFE=10cos2377tt=1 sec

Q: An impedance coil is connected in series with a fixed resistor, and a 120-V, 50-c Source is then imp...

Q: 1. A wye connected load has a 5 < 20° ohm impedance per phase and is connected across a 120 V three ...

A: There are two ways to link a three-phase load in a three-phase system.1. Wye/Star Connection 2. Conn...

Q: Homework 3 – ECE 403 Problem 1: Solve the DC operating points of the following circuits. • Calculate...

Q: A coaxial cable has a 10-mm diameter inside conductor and a metallic sheath with an inside diameter ...

Q: Each subsatnce absorbs or emit unoque level & quantities of energy/ e.m.r.. True False

A: GIVEN: a statement FIND: TRUE OR FALSE

Q: 7. The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to op...

Q: Determine the maximum number of lighting outlets for 15, 20, 25 and 30 circuit breaker

Q: 1 Ok 2 Oh :4 Oks ELECTONICS Jacov

A: The given circuit diagram is shown below:

Q: Determine the simplified expression for F(A,B,C,D) using K-Map

Q: Vhat happened to 3-phase delta configuration of transformer when any one of the phases s opened due ...

A: A three phase transformer, also known as a 3 transformer, can be built by connecting three single-ph...

Q: R5 R2 1kn 10KA R. 10 KA R6 U2 1 KA U1 100 A Ci C2 Vi 1 pf 1yf R3 a) find the gain and fol and fom fo...

Q: 1. The armature windings of a dc motor have a resistance of 5.0 Ω. The motor is connected to a 120 V...

Q: Problem 5 C(s) R(s) + -15

Q: A wire carries a current i = 3cos314t A. What is the average current over 6 seconds?

A: Average value of a function f(t) with a period T = 1T∫0Tf(t)dt

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The circu...

A: In this question, Determine the apparent power? We know apparent S= VI* I* is conjugate of the c...

Q: 1.35. Carefully sketch each signal described below. x[n] = {1, -1, 3, -2, 5} a. %3D | T[n] = (0.8)" ...

Q: For the signal, x(t), shown in the figure below 4 x(1) 3 1 | [sec] 2 Find the following at t = 4 sec...

Q: A 1500 W portable heater will use 1.5 kW per hour. In 4 hours, it would use _______ Horsepower

Q: For the circuit below, find

Q: 1. Find voltages Va, Vp, and V. and currents i, i2, iz, i4, and is. Use substitution method. 2.2kN 1...

A: Note : In the given circuit diagram Va, Vb and Vc are not mentioned so considering the bulleted poin...

Q: Find an given A- [2x+y?) art Czy ay-Xaz Czxty )an t 6 Xyzay -x*az a.

A: In this question we need to find a unit vector aA .

Q: Problem 3: For the system with the block diagram shown in Figure 3, assign conditions on control gai...

Q: certain p(t) = 125 + 250 cos 240rt. Find the power factor. A series RL ac circuit has an instantaneo...

A: We need to find out power factor for RL circuit

Q: In a BJT, the value of IC=188mA and IB=0.054mA. Solve for IE in mA.

Q: 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequenc...

A: We have given the resistor and capacitor are connected with supply which is 250 V where in first ca...

Question

A resistor and a capacitor are
connected in series across a supply of
250V. When the supply frequency is
50HZ, the current in the circuit is 5A.
When the supply frequency is 60HZ,
the current is 5.5A. Find the value of
the capacitance.
96.436 microfarad
43.966 microfarad
34.696 microfarad
63 943 microfarad
69 436 microfarad
36.496 microfarad

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RLC series circuit has an impedance of 60 Ω and a power factor of 0.50, with the voltage lagging the current. (a) Should a capacitor or an inductor be placed in series with the elements to raise the power factor of the circuit?(b) What is the value of the capacitance or self-inductance that will raise the power factor to unity?
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit ?Ztot = Determine the numerical value of Ztot = ΩDetermine the numerical value of ?Ztot = degreesDetermine the current through the circuit: I(PEAK) = Amps I(RMS) = Amps Determine the voltage across the inductor: VL(PEAK) = Volts VL(RMS) = Volts Determine the voltage across the capacitor: VC(PEAK) = Volts VC(RMS) = Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor a radio tunera phase…
A series circuit consists of a 20-ohm resistance, a 150 mH inductance and an unknown capacitance. The circuit is supplied with a voltage v = 100 sin 314t. Find the value of capacitance at resonance
An inductive coil of resistance 15 ohms and inductance 0.2 is commented in parallel with a 100 microfarad capacitor to a variable frequency supply.Find the frequency at which the total current taken is in phase with the supply voltage. What is the value of this current if the voltage is 200V.Draw a phasor diagram
A LC circuit in a radio tuned to 1080 kHz has an inductor with an inductance value of 60 μH and a resistance of 0.25 Ω. a. what is the capacitance of the LC circuit? b. sketch the impedance phasor diagram for the radio. Be sure to label important features of the diagram.
An inductive coil of resistance 15 ohms and inductance 0.2H is connected in parallel with a 100 micro farad capacitor to a variable frequency supply. Find the frequency at which the total current taken is in phase with the supply voltage. What is this value of this current if the voltage is 200v. Draw a phase diagram
can you solve this for capacitor 12v thenk you
A capacitance 50microfarad and an inductance of 0.2025 Henry are connected in series. if the resistance of the circuit is negligible find the frequency at which resonance occurs
An inductor L1 is connected in series with a parallel combination of inductor L2 and capacitor C. The impedance of the circuit with ω = 400 rad/s is j100 Ω. The circuit is to yield infinite impedance at ω = 1000 rad/s and zero impedance at ω = 2000 rad/s. Determine the value of capacitance of the capacitor C.4.
You are given the below RLC circuit, answer the following questions and show the steps in details The voltage developed across the inductor (VL) The voltage dropped across the capacitor (VC) The voltage dropped across the resistor (VR) The impedance of the circuit The supply Current (I) The phase angle
In an L-R-C series circuit, the source has a voltage amplitude of 121 V , R = 75.0 Ω , and the reactance of the capacitor is 475 Ω . The voltage amplitude across the capacitor is 358 V A) What is the current amplitude in the circuit? B)What is the impedance? C)What two values can the reactance of the inductor have?