A resistor of 4 ohms and an inductive reactance of 3 ohms are connected in series across a 25 V AC source. Current in the source is

Q: What are the first eight bits of mantissa part and the lecimal value stored in exponent if…

A: Given Data:  A decimal number of, (-28.375)10 To Find: When represented by a single-precision IEEE…

Q: 3) For the given circuit; →Setup state the transition table →Sketch state the satate transition…

A:

Q: For the network shown, determine: a) ID b) Vs and Vps S c) VG and VGS d) Vp 12 Vo WWW 680 k VG + Vas…

A:

Q: What is the signal corresponding to the following z-transform? (Where u[n] is the unit- step signal)…

A: It is given that: Xz=6z22z-13z-1,13<z<12

Q: Problem (8): Transformer Q15. If the number of the turns in the primary side of the transformer is…

A: Q15) here we have to find the voltage on the secondary side.Q16) here we have to give the reason for…

Q: Construct the Root Locus of a unity feedback system with G(s) = K(s+1) s(s+2)(s+3) H(s) = 1

A: Given data Gs=Ks+1ss+2s+3 Hs=1 To find out We have to sketch the root locus for the given open-loop…

Q: 602 www RAZ + V4 R5 202 iG₁6 V + V6 + www R6 302 V3 =μV4 - 12 2A

A:

Q: марл Using Karnaugh Map by step. Dengan menggunakan Peta Karnaugh (K-Map) ringkaskan persamaan di…

A:

Q: 2u(t) www 1 + ܝܚ 2 W (2u(t-2)

A:

Q: (b) Perform the convolution integral for the signals shown in Figure 2 and Figure 3. b(t) ✔ y(t) -2…

A:

Q: 2. There is a static machine, built by 2 windings, placed in a magnetic core of S = 15cm2 . N1 = 450…

A:

Q: A 100 kVA,3-phase, 50 Hz, 3,300/400 transformer is A-connected on HV side and Y- connected on LV…

A: It is given that: kVA=100f=50 HzV1=3300 VV2=400 VR1=3.5 Ω per phaseR2=0.02 Ω per…

Q: Q5)A continuous-time system has a state space model given by X=¹₁2x+ut y(0-[10]x(t) 2] x(1) 1- Find…

A:

Q: + X R L For the RL circuit, find the mathematical model (input-output relationship) if the output is…

A: here we have to find the mathematical model of the circuit.

Q: Determine the input resistance (Rin Vin/Iin) of the circuit shown = R₁ + Vin R₂ R₂ Vout

A: The above question is based on the input impedance of an ideal non-inverting opamp circuit. Virtual…

Q: a) i) Sketch the sequence x[n] = cos (n. π/2) plotted against 'n' (the sketch should only go from n…

A: Given Data: A sequence of xn=cos nπ2, -2≤n≤3 The input and impulse sequences of, xn=12n hn=12,…

Q: 1. EC9Q1 Non-identical Light bulbs A and B are connected in series to a 46-Volt energy source. The…

A: In a series circuit, when multiple components are connected one after the other, the total voltage…

Q: 4. For the system in Figure P4, sketch the root locus and find the breakaway and break-in points.…

A: Given Data: An open-loop transfer function of, Gs=Ks-3s-5s+2s+4 And the feedback of, Hs=1 To Find:…

Q: 2. Define system type. Determine the position-velocity-acceleration error coefficients K(s + 1) s…

A: Given: Forward path gain, G's=Ks+1s+0.1, with controller transfer function, Cs=1ss+3, To find: i)…

Q: D3.3. Given the electric flux density, D = 0.3r-a-nC/m-in free space: (a) find E at point P(r= 2,…

A: The electric flux density, D=0.3r2ar

Q: Find (a) i, (b) i₁, and (c) i2 in the circuit in Fig. P2.35. Figure P2.35 12 0 www + 18v( ) 60 ਤ 54…

A:

Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable.

A: The 4 to 16 line decoder needs to be designed by using five numbers of 2 to 4 decoder along with the…

Q: Design an 8-bit magnitude comparator using 4-bit comparators and other gates.

A: Here, We have to design an 8-bit magnitude comparator using 4-bit comparators and other gates.

Q: Consider the given circuit, where is 30 mA The voltage volt) is equal to 1.6 "el microV. What is L…

A:

Q: In each case, multiply out to obtain a sum of products: (Simplify where possible.) (a) (W + X' + Z')…

A: The given boolean function needs to be multiplied out and reduced to get the simplified som of…

Q: a) Determine the frequency spectra (Fourier series) of the periodic even square wave illustrated in…

A:

Q: the wave equation is f(z,t) = 10 cos (30 z - 50 t) in cm Then the wavelength of the wave is Select…

A:

Q: 9. An electric circuit consists of two components as shown in the figure below. ZI www R₁ XL ooooo…

A: here we have to find the total impedance and modulus & argument of the impedance.

Q: III. Draw a seven-segment display, show the number highlighted in figure 1 (d3-d0 are the input, a-g…

A: Introduction of seven segment display : A seven-segment display is a digital display module…

Q: 10. Consider exponential illustrated in Figure 10. Find the Fourier Transform X(w) of x (t) 0 x (t)…

A: here we have to find the fourier transform of the signal x(t).

Q: The following are the impulse responses of LTI systems. Which system is stable? Oh[n] (1.1)" un +1]…

A:

Q: Determine the Fourier Series corresponding to the following periodic function, and then determine…

A: To determine the Fourier series corresponding to the following periodic function, and then determine…

Q: 2. Considering the circuit in Figure 2 a) Find the generalised impedance of the circuit Z b)…

A: We need to calculate a) the generalized impedance of circuit  Z b) transfer function H(s)=…

Q: A three phase salient pole, 440 volts, wye connected synchronousgenerator operates at a power angle…

A: a  three phase salient pole synchronous generator has  voltage Vt = 440 V (phase / line voltage)…

Q: Reduce the block diagram given below to a single block representing the transfer function T(s) =…

A: here we have to reduce the block diagram to find the tranfer function

Q: 2. Find R₁ and R if l = 0.4mA, Vô=0.5V. Assume_V₁h = 0.7V, µn Cox L=1μm, W=32 μm. VDD= ID ID = +2.5…

A:

Q: In a transformer that has 10 times more turns on the secondary side (side 2) than on the primary…

A: The above question is based on the EMF equation of a transformer.

Q: For the circuit of Figure 1. Vt=0.7 V, Kn = 125µA/V. Find V1, V2, V3 for the following cases. (a)…

A:

Q: The junction temperature in a BJT is 45° Celsius, the ambient temperature or surrounding temperature…

A: To calculate the thermal resistance of the BJT, we need to use the formula: Thermal Resistance (θ)…

Q: Flux (T m^2) 1 -1 current (A) 2- 0 -2. ХХХХХХХХ хххх ххх X ХХХХХХХХ ХХХХ хххх хххх хххх Х Х Х Х Х Х…

A: Given: Graph of magnetic flux and current through the loop at t=10s   Graph of magnetic flux and…

Q: 5. A three-phase rectification system has a voltage ripple of 14%. If the output kVp is 150, what is…

A: Given data, Output voltage VO=150 V. Ripple voltage Vr=14 %.

Q: c) If in figure 2.1 the Q-point is given, VGs = -2 V, IG= 0 mA, VDs = 10 V, IDs = (4.XY) mA, then…

A: DC analysis of the amplifier will here XY=54,VGS=-2V,IG=0mA,VDS=10V,IDS=4.XY mA…

Q: Problem 2. Determine Voi and Vo2 for the networks of Fig. 2. +12 Vo Si (a) 4.7 ΚΩ GaAs -10 Vo Ge Si…

A:

Q: An FM transmitter has a 220 MHz carrier frequency. Its modulation index is 3 with a 5 kHz modulating…

A:

Q: Q5/ A 3-phase, 415V, 4-pole, 50Hz star connected S.M has a synchronous impedance of 0.72+j6/phase.…

A: For a 3-phase star connected synchronous motor,Voltage, V=415 V.Pole, P=4.Frequency, f=50…

Q: Consider the decaying exponential function x (t) illustrated in Figure 10. Find the Fourier…

A:

Q: The total area under the function a (t) = 10 sinc (+4) is 7

A: It is given that: xt=10sinct+47

Q: Consider the following step response of a system. We want to find a model that represents this…

A: In this question we need to find the following the following Transfer function of the given system…

Q: Make the Routh table for the system and tell how many roots of the following polynomial are in the…

A: For the given characteristics equation the routh table needs to be formed and the number of poles…

Q: Illustrate the basic concept of standard amplitude modulation

A: Amplitude modulation is the technique of modulation where the amplitude of the carrier signal…