A resistor of 4 ohms and an inductive reactance of 3 ohms are connected in series across a 25 V AC source. Current in the source is
Q: What are the first eight bits of mantissa part and the lecimal value stored in exponent if…
A: Given Data: A decimal number of, (-28.375)10 To Find: When represented by a single-precision IEEE…
Q: 3) For the given circuit; →Setup state the transition table →Sketch state the satate transition…
A:
Q: For the network shown, determine: a) ID b) Vs and Vps S c) VG and VGS d) Vp 12 Vo WWW 680 k VG + Vas…
A:
Q: What is the signal corresponding to the following z-transform? (Where u[n] is the unit- step signal)…
A: It is given that: Xz=6z22z-13z-1,13<z<12
Q: Problem (8): Transformer Q15. If the number of the turns in the primary side of the transformer is…
A: Q15) here we have to find the voltage on the secondary side.Q16) here we have to give the reason for…
Q: Construct the Root Locus of a unity feedback system with G(s) = K(s+1) s(s+2)(s+3) H(s) = 1
A: Given data Gs=Ks+1ss+2s+3 Hs=1 To find out We have to sketch the root locus for the given open-loop…
Q: 602 www RAZ + V4 R5 202 iG₁6 V + V6 + www R6 302 V3 =μV4 - 12 2A
A:
Q: марл Using Karnaugh Map by step. Dengan menggunakan Peta Karnaugh (K-Map) ringkaskan persamaan di…
A:
Q: 2u(t) www 1 + ܝܚ 2 W (2u(t-2)
A:
Q: (b) Perform the convolution integral for the signals shown in Figure 2 and Figure 3. b(t) ✔ y(t) -2…
A:
Q: 2. There is a static machine, built by 2 windings, placed in a magnetic core of S = 15cm2 . N1 = 450…
A:
Q: A 100 kVA,3-phase, 50 Hz, 3,300/400 transformer is A-connected on HV side and Y- connected on LV…
A: It is given that: kVA=100f=50 HzV1=3300 VV2=400 VR1=3.5 Ω per phaseR2=0.02 Ω per…
Q: Q5)A continuous-time system has a state space model given by X=¹₁2x+ut y(0-[10]x(t) 2] x(1) 1- Find…
A:
Q: + X R L For the RL circuit, find the mathematical model (input-output relationship) if the output is…
A: here we have to find the mathematical model of the circuit.
Q: Determine the input resistance (Rin Vin/Iin) of the circuit shown = R₁ + Vin R₂ R₂ Vout
A: The above question is based on the input impedance of an ideal non-inverting opamp circuit. Virtual…
Q: a) i) Sketch the sequence x[n] = cos (n. π/2) plotted against 'n' (the sketch should only go from n…
A: Given Data: A sequence of xn=cos nπ2, -2≤n≤3 The input and impulse sequences of, xn=12n hn=12,…
Q: 1. EC9Q1 Non-identical Light bulbs A and B are connected in series to a 46-Volt energy source. The…
A: In a series circuit, when multiple components are connected one after the other, the total voltage…
Q: 4. For the system in Figure P4, sketch the root locus and find the breakaway and break-in points.…
A: Given Data: An open-loop transfer function of, Gs=Ks-3s-5s+2s+4 And the feedback of, Hs=1 To Find:…
Q: 2. Define system type. Determine the position-velocity-acceleration error coefficients K(s + 1) s…
A: Given: Forward path gain, G's=Ks+1s+0.1, with controller transfer function, Cs=1ss+3, To find: i)…
Q: D3.3. Given the electric flux density, D = 0.3r-a-nC/m-in free space: (a) find E at point P(r= 2,…
A: The electric flux density, D=0.3r2ar
Q: Find (a) i, (b) i₁, and (c) i2 in the circuit in Fig. P2.35. Figure P2.35 12 0 www + 18v( ) 60 ਤ 54…
A:
Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable.
A: The 4 to 16 line decoder needs to be designed by using five numbers of 2 to 4 decoder along with the…
Q: Design an 8-bit magnitude comparator using 4-bit comparators and other gates.
A: Here, We have to design an 8-bit magnitude comparator using 4-bit comparators and other gates.
Q: Consider the given circuit, where is 30 mA The voltage volt) is equal to 1.6 "el microV. What is L…
A:
Q: In each case, multiply out to obtain a sum of products: (Simplify where possible.) (a) (W + X' + Z')…
A: The given boolean function needs to be multiplied out and reduced to get the simplified som of…
Q: a) Determine the frequency spectra (Fourier series) of the periodic even square wave illustrated in…
A:
Q: the wave equation is f(z,t) = 10 cos (30 z - 50 t) in cm Then the wavelength of the wave is Select…
A:
Q: 9. An electric circuit consists of two components as shown in the figure below. ZI www R₁ XL ooooo…
A: here we have to find the total impedance and modulus & argument of the impedance.
Q: III. Draw a seven-segment display, show the number highlighted in figure 1 (d3-d0 are the input, a-g…
A: Introduction of seven segment display : A seven-segment display is a digital display module…
Q: 10. Consider exponential illustrated in Figure 10. Find the Fourier Transform X(w) of x (t) 0 x (t)…
A: here we have to find the fourier transform of the signal x(t).
Q: The following are the impulse responses of LTI systems. Which system is stable? Oh[n] (1.1)" un +1]…
A:
Q: Determine the Fourier Series corresponding to the following periodic function, and then determine…
A: To determine the Fourier series corresponding to the following periodic function, and then determine…
Q: 2. Considering the circuit in Figure 2 a) Find the generalised impedance of the circuit Z b)…
A: We need to calculate a) the generalized impedance of circuit Z b) transfer function H(s)=…
Q: A three phase salient pole, 440 volts, wye connected synchronousgenerator operates at a power angle…
A: a three phase salient pole synchronous generator has voltage Vt = 440 V (phase / line voltage)…
Q: Reduce the block diagram given below to a single block representing the transfer function T(s) =…
A: here we have to reduce the block diagram to find the tranfer function
Q: 2. Find R₁ and R if l = 0.4mA, Vô=0.5V. Assume_V₁h = 0.7V, µn Cox L=1μm, W=32 μm. VDD= ID ID = +2.5…
A:
Q: In a transformer that has 10 times more turns on the secondary side (side 2) than on the primary…
A: The above question is based on the EMF equation of a transformer.
Q: For the circuit of Figure 1. Vt=0.7 V, Kn = 125µA/V. Find V1, V2, V3 for the following cases. (a)…
A:
Q: The junction temperature in a BJT is 45° Celsius, the ambient temperature or surrounding temperature…
A: To calculate the thermal resistance of the BJT, we need to use the formula: Thermal Resistance (θ)…
Q: Flux (T m^2) 1 -1 current (A) 2- 0 -2. ХХХХХХХХ хххх ххх X ХХХХХХХХ ХХХХ хххх хххх хххх Х Х Х Х Х Х…
A: Given: Graph of magnetic flux and current through the loop at t=10s Graph of magnetic flux and…
Q: 5. A three-phase rectification system has a voltage ripple of 14%. If the output kVp is 150, what is…
A: Given data, Output voltage VO=150 V. Ripple voltage Vr=14 %.
Q: c) If in figure 2.1 the Q-point is given, VGs = -2 V, IG= 0 mA, VDs = 10 V, IDs = (4.XY) mA, then…
A: DC analysis of the amplifier will here XY=54,VGS=-2V,IG=0mA,VDS=10V,IDS=4.XY mA…
Q: Problem 2. Determine Voi and Vo2 for the networks of Fig. 2. +12 Vo Si (a) 4.7 ΚΩ GaAs -10 Vo Ge Si…
A:
Q: An FM transmitter has a 220 MHz carrier frequency. Its modulation index is 3 with a 5 kHz modulating…
A:
Q: Q5/ A 3-phase, 415V, 4-pole, 50Hz star connected S.M has a synchronous impedance of 0.72+j6/phase.…
A: For a 3-phase star connected synchronous motor,Voltage, V=415 V.Pole, P=4.Frequency, f=50…
Q: Consider the decaying exponential function x (t) illustrated in Figure 10. Find the Fourier…
A:
Q: The total area under the function a (t) = 10 sinc (+4) is 7
A: It is given that: xt=10sinct+47
Q: Consider the following step response of a system. We want to find a model that represents this…
A: In this question we need to find the following the following Transfer function of the given system…
Q: Make the Routh table for the system and tell how many roots of the following polynomial are in the…
A: For the given characteristics equation the routh table needs to be formed and the number of poles…
Q: Illustrate the basic concept of standard amplitude modulation
A: Amplitude modulation is the technique of modulation where the amplitude of the carrier signal…
Step by step
Solved in 4 steps
- An R-L series circuit contains two resistors and two inductors. The resistors are 86 k and 68 k . The inductors have inductive reactances of 24 k and 56 k . The total voltage is 480 volts. Find the voltage drop across the 56-k inductor.An R-L series circuit contains two resistors and two inductors. The resistors are 68 and 124 . The inductors have inductive reactances of 44 and 225 . The total voltage is 240 volts. Find the voltage drop across the 124- resistor.What is the power factor of the circuit in Question 6?
- In the circuit in the figure, indicate what is the value of the Thevenin equivalent generator between points A-B to the left (only the ideal voltage generator).A 50 microfarad is connected in series with a coil having 50 ohms’ resistance and 150 mHinductance. The source voltage is 100 sin(wt-30 degrees) V. What is the maximum power?A 25 Ω resistor connected in series with a coil of 50 Ω resistance and 150 mH inductance. What is the power factor of the circuit?
- Answer in polar form. The node a and f has the value of 5 ohmsA resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected in series with a capacitive reactance of 5 ohms. If the entire combination is connected across a 100 V, 60 Hz ac source, find the voltage across the resistor.Three loads, each of resistance of 40 N and inductance of 158.4 mH are connected in star with a 3-phase supply. Frequency is 50 Hz. Find the inductive reactance (XL) of the each phase.
- SEARCH ASK CHAT MATH SOLVER Question A load is composed of a 4 ohm resistance connected in series with a 3 ohm inductive resistance. The load is connected across a 120 source. Compute: (a) current (b) voltage across the resistance (c) voltage across the inductor Recheck voltages using Vt=120 VAn electric circuit contains an 8 ohm resistor in series with an inductor of 0.50 henries and a battery of E volts. At t=0 the current is zero. Find the current at any time t > 0 and the maximum current if (a) E=64, (b) E=8te-16t, (c) E=32e-8t, (d) E = 64sin8tA certain load takes 10 kw at 75% pf. In the power contract, the pf penalty is applied only to power factors below 85%. What size of capacitor must be used in order to avoid the penalty? The voltage is 55 kv, 60 hz.