A river reach had a flood were passing through it. At a given instant, the storage of water in the reach was estimated as 15.5 Ha-m. What would be the storage in the reach after an interval of 3 hours, if the average inflow and outflow during the time period are 14.2 cubic meter per second and 10.6 cubic meter per second, respectively? (Ans. S = 193,880 cubic meter)

Q: Research on the following: a. What are the basic beam and frame terminologies? b. What is the relati...

A:

Q: Problem 1. A 75-mm diameter orifice discharges 0.023 m3/s of liquid under a head of 2.90 m. The diam...

A: Given data,  Diameter of orifice = 75 mm Discharge = 0.023 m³/s Head = 2.9 m Diameter at vena contra...

Q: A 1800-kg truck travels at 85kph around a banked curve with a radius of 250 m. What should be the su...

A:

Q: rigid pavement has a wheel load capacity of 59.52 kN. The allowable tensile stress of concrete is 1....

A: Given data- Wheel load capacity (W) = 59.52 kN Allowable tensile stress(£) = 1.55 Mpa  

Q: What will happen to the amount of precipitation once the duration is longer than the expected?

A: To answer :- what will happen to the amount of precipitation if duration is longer than expected.

Q: What will be the collapse load of the beam of uniform cross-section as shown in figure? W W/2 Mp Mp ...

A:

Q: WgvFANO PROBLEM 6:A gasoline line is connected to a pressure gage through a double-U manometer, as s...

A:

Q: A steel bar, whose cross section is 0.60 inch by 4.10 inches, was tested in tension. An axial load o...

A: solution cross section dimensions 0.6 inch ×4.1inch deformation of 0.115 inche over length L =2.10bs...

Q: If the point (3, k) lies on the line with slope m = −2 passing through the point (2, 4), find k.

A: Using the concept of line as a figure with constant slope.

Q: A 3.4 m square footing is proposed to be used to support a 353 mm x 630 mm RC column loaded with 634...

A:

Q: PROBLEM 1. A hollow cylindrical steel shaft is 1.5 m long and has inner and outer diameters respecti...

A: Length of shaft,L =1.5mInner diameter of shaft, Di =40mmOuter diameter of shaft, Do =60mmMaximum she...

Q: 7. ERROR OF CLOSURE. Given the following tabulated data fo1 two transit-tape surveys: LATITUDE DEPAR...

A:

Q: (Place the origin at point A.) Let a=3.25 m, b=4.25 m, P3 = 30KN, and Pc = 100KN. Pc Determine the s...

A:

Q: Find the radius of curvature of the following curves at the point indicated. T = tan 6 at e = %3D

A:

Q: n AC and AD if the Tension of Cable AB

A: Given:- Tension of Cable AB is 95 Newton 60m,60m,40m,40m To find:- Tension AC and AD

Q: 90KN/m 75KN В 9m 21 5m 5m A 75KN 3m Analyze the FRAME using Slope Deflection Method Compute for the ...

A: FIXED END MOMENTS: MAB=0MBA=0MBC=-90×9212=-607.5 KN-mMCB=+90×9212=+607.5 KN-mMCD=-75×5×3282=-52.73 K...

Q: My son built a symmetric tent last Christmas season of 2020. The frame for the tent is shown with tw...

A:

Q: a. Determine the largest distributed load value in lb/ft. b. Determine the point of inflection from...

A: Shear force for Uniformly Distributed Load(UDL) is a Uniformly Varying Line(i.e., sloped line)   In ...

Q: QUESTION: Based on the provided differential-type manometer, calculate the difference in the pressur...

A:

Q: A rectangular concrete beam having a width of 250mm and effective depth of 350mm will be designed to...

A:

Q: The volume of ocean water is 1338x10° km³. The runoff from rivers is 44.7 x10³ km³/year and the runo...

A: Hello dear this is the solution of your problem The answer is found to be Residence time =2646 years...

Q: 2.13* On your first day at work, you realize that the total station you have only reads angles in gr...

A:

Q: Two steel plate tension members have been connected using 0.72” diameter bolts arranged in an equall...

A:

Q: A rectangular beam has the following properties. Assume 12 mm stirrups. Assume a single layer of rei...

A: width of beam = 450mm depth of beam = 600mm

Q: 4. A one - way slab having a simple span of 4m is 150mm thick. The slab is reinforced with 12mm tens...

A:

Q: 9 kips/ft 5 kips/ft В E hinge D 20 kips 8 6'

A:

Q: What happens to the draft of a ferry that crosses from saltwater to freshwater

A: To comment on the change in draft of ferry on crossing from saltwater and freshwater.   The draft of...

Q: A man bought a lot worth P2.1M if paid in cash. On the installment basis, he paid a down payment of ...

A:

Q: Hill B (elev. = 2338.253 m) is in between hill A (elev. = 2336.264 m) and hill C elev. = 2352.428 m)...

A: This question belongs to subject surveying. In this question find out height of tower at various poi...

Q: Design a rectangular beam for the load and p shown. Beam weights are not included in the loads shown...

A:

Q: From the given differential leveling notes, compute the: a.) Elevation at each turning points. b.) E...

A:

Q: What is newton's 3rd law?

A: This question is related to Engineering Mechanics.  In this question we answered about newton law wh...

Q: The steel beam has the cross section shown. The beam length is L = 30 ft, and the cross-sectional di...

A:

Q: The water table is at a depth of 2.5 m below the base of a square footing used to support a column, ...

A: Please refer the attached image for complete solution. THANK YOU !

Q: Determine the maximum bending moment for the beam shown below. Use a = 7 ft, b = 11 ft, c = 5 ft, a...

A:

Q: . The lateral area of a regular pyramid with a square base is 1120 cm2 and altitude of 20 cm. Comput...

A:

Q: Determine the volume of solid obtained by rotating the region bounded by y = x^2 - 2x and y = x abou...

A: Step: 1 Curve: - It is a continuous line which gradually deviates without any sharp turns. For exam...

Q: gression and how is it

A: The process done to analyse the aproximate solution of overdetermined systems by reducing the sum of...

Q: The aluminum rod AB (Gaj = 27 GPa) is bonded to the brass rod BD (Gpr = 39 GPa). The portion CD of t...

A:

Q: Describe the variation of the velocity, pressure, and elevation heads as the fluid flows through the...

A:

Q: C to D has a measured distance of 0.318 km. The tape used that has been standardized at a tension of...

A:

Q: A pump with a capacity of 100 gpm is needed to transport water to an elevated tank. Tank is designed...

A: To determine the volume of the elevated tank.   Given, Inflow rate from the pump to the tank (Qin) =...

Q: A small amount of resin weighing 4.56g occupies a height of a 10-ml graduated cylinder equivalent to...

A:

Q: (Place the origin at point A.) Let a=3.25 m, b=4.25 m, Pg = 30KN, and Pc = 100KN. b. Determine the b...

A:

Q: For the four piles of a pile group having arc tan value of 18.3, the efficiency as per Converse Leba...

A: Given data, The four piles of a pile group having arc tan value of  18.3 To find the efficiency as p...

Q: 2. A reservoir of water is connected to 8-inch-diameter pipe 50 feet long and discharging freely. Th...

A: Given:- The diameter of the pipe connecting reservoir = 8 inch The length of the pipe = 50 ft The el...

Q: The following  simply  supported  beam  is  made  of  normal  weight  plain concrete  (f’c  =  3,000...

A: The values and diagram given in the question are as follows f'c=3000 psi Width of beam(b)=30 in dept...

Q: For the simply supported beam subjected to the loading shown, derive equations for the shear force V...

A:

Q: Find the water content, void ratio, porosity, degree of saturation, and wet and dry unit weights

A:

Q: 1. There exists a void area in the rectangle as shown, a) Find the location of the centroid, i.e., Y...

A: