A rope is wound around a shaft 10 cm in diameter. If a pull of 500 N is exerted on the rope, what torque is imparted to the shaft? Give the Given, Fbd and Formula and solution.

Q: a torque of 1200 [kgf - cm), calculate the maximum efforts if Sy=900 [kgf/cm2]

A:

Q: Find the Normal Force (in kilo-Newtons) in the rod of the system.

A:

Q: Mohr's Circle At a point, the major principal stress is 80 psi compression and the minor principal…

A: Givenσp1=-80psiσP2=-20psi

Q: Solve for the pressure differential in Pa if the temperature inside a 3.47m vertical wall is…

A: Given that , Length of vertical wall h=3.47mInside temperatureT1=23.51°COutside temperature…

Q: A wave in deepwater has a height of 30 ft and period of 13 s. What is the height of the wave in 100…

A:

Q: When the torque of car wheel is 27186Ncm and it has with the force of 0.91kN applied at the wheel.…

A: Given data, Torque of the car wheel, T = 27186 N-cm T = 271860 N-mm Applied force on the wheel, F =…

Q: Compute the displacement done in object so that work done is said to be 124.55 J If force applied is…

A:

Q: Show the fbd/figure, given and formula used. The engine of a motorboat delivers 40 hp to the…

A: The power is P=40 hp=40×103 W The tension force is FT=Pv=40×10310=4000 N

Q: The effective diameter of the cylinder is 400 mm. the maximum pressure of steam acting on the…

A:

Q: If a force of 3400 pounds is applied to a circular piston 2 inches in diameter, calculate the fluid…

A:

Q: Find the acceleration of the three weights shown in fig. Assume pulleys are frictionless. Also find…

A: Given data

Q: What is the force produced by an actuator to open a valve if its diaphragm has a 4-inch diameter and…

A: Given data:

Q: Engine has a capacity of 20 milliliters per cylinder and the length of the axle arm is 5 cm Find the…

A:

Q: find the fbd solution

A:

Q: Given the internal radius of the pipe is 2 cm, the external radius is 2.4 cm and the length of the…

A:

Q: A petrol engine has a cylinder diameter and stroke of 120mm and 210 mm respectively The clearance…

A:

Q: A jet flights with a speed of 291 m/s . If the jet's engine has a power of 1,462,823 W. what is the…

A:

Q: Solve for the pressure differential in Pa if the temperature inside a 5.14m vertical wall is…

A: Calculate the pressure difference on the bottom of wall at the left and right wall

Q: A petrol engine has a cylinder diameter and stroke of 110mm and 250 mm respectively. The clearance…

A: We are required to find the volume of a petrol engine whose, bore stroke and clearance volume is…

Q: At what depth below the surface of the oil, relative density 0.89 will produce a pressure of 120…

A: The given data are: Here, d denotes the relative density and P denotes the pressure.

Q: When the torque of car wheel is 27212Ncm and it has with the force of 0.31kN applied at the wheel.…

A: support diameter of car wheel is D. so, Torque on wheel is given by T = F× (D/2). here, F = 0.31 KN…

Q: . A hydraulic jack receives a force of 10ON and produces a force of 1kN to lift a certain load. Find…

A:

Q: At what depth below the surface of the oil, relative density 0.89 will produce a pressure of 130…

A:

Q: A steel circular shaft (G= 80 GPa) of constant diameter of 28 mm is subjected to the following…

A:

Q: nger diameter is 7/8 inch and its weight is 1.8 pounds. What is the safe maximum deadweight in kg,…

A: 1 psi = 6894.76 Pa 1 inch = .0254 m 7/8 inch = 0.022225 m 1 pound = 0.453592 kg thus 1.8 pound =…

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A:

Q: In a forklift, cylinder area 512mm^2 and pressure 584 N/mm^2 Calculate the mass( in tonnes)

A: Taking g=10m/s^2.

Q: At what depth below the surface of the oil, relative density 0.83 will produce a pressure of 120…

A: Given data: relative density SG=0.83 Pressure P=120 kN/m2 Need to determine depth of oil in meters…

Q: 1. When Tom is at x =1m, what is the tensile force in the wire in Newton? If the wire can hold only…

A:

Q: Solve for the pressure differential in Pa if the temperature inside a 3.46m vertical wall is…

A: write the pressure at left bottom and right bottom. And take the difference of them.

Q: When the torque of car wheel is 273054Nmm and it  has with the force of 0.81kN applied at the wheel.…

A: Given : Torque (T) = 273054 N mm Force (F) = 0.81 kN   To find : Diameter of the car wheel (D) = ?

Q: open circular cylinder of 20 cm diameter and 100 cm long contain water up to a height of 80 cm. It…

A:

Q: A transmission shaft used to transmit power of 55 kW. During transmission shaft is subjected to a 30…

A: Given data: The power transmitted by the shaft is P = 55 kW. The torque acting on the shaft is T =…

Q: Solve this

A: We have simply supported beam with reaction loads at A and E because of its support hinge at point A…

Q: A bolt is being loosened by a 43 cm wrench by a force of 62N. The force makes an angle of 39° with…

A: Let L = Length of wrench =43cm  P =Applied force =62N θ =39°  Component of P in vertical direction…

Q: At what depth below the surface of the oil, relative density 0.83 will produce a pressure of 100…

A: Fluid Mechanics

Q: Use the formulas for the hydraulic press to find the value. A force of 30 lb is applied to a piston…

A: Given, Diameter of the smaller piston = d1 = 5 in Force at smaller piston = F1 = 30 lb Diameter of…

Q: Find the sum of the opposite forces

A:

Q: A machinist wishes to insert a brass rod with a diameter of 3 mm into a hole with a diameter of…

A:

Q: Thevenin theorem?

A: Thevenin's Theorem states that “Any linear circuit containing several voltages and resistances…

Q: solution! Given: FN = 52 MN = 100 SN = 75

A: As per policy I can answer only first question. Please ask second question as new

Q: .A hydraulic pump delivers 12.5 litres per minute towards pressure of 225 bar Find the following (a)…

A:

Q: The ratio of the diameters of the small piston to the large piston of a hydraulic lift is 1:10. Find…

A:

Q: A body weighing 2,225N is being dragged along a rough horizontal plane by a pull of 445N directed at…

A:

Q: 1.Find the diameter of a pipe of length 3000 m when the rate of flow of water through the pipe is…

A:

Q: nd the weight in newtons of the steel ball if its diameter is 2 in.Use the density of steel as 7850

A: Given Data⇒ Density of steel : ρ=7850 kgm3 Diameter of steel ball(d)=2 in Convert from in to m 1…

Q: Find the measurement that is a) most accurate and b) the most precise. 459 ft; 600 ft; 190 ft

A: GIven data The set of measurements is 459 ft , 600 ft , 190 ft

Q: Find the z-component of F1 in Newtons. If the calculated answer is not whole number, express it in 4…

A: Given data: Force, F1=425 N Let F1X, F1Y, F1Z be the components of force, F1. So, the force F1 and…

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.