A saturated clay layer 4 m thick is located 6 m below GL. The void ratio of the clay is 1.0. When a raft foundation is located at 2 m below GL, the stresses at the top and bottom of the clay layer increased by 150 and 100 kN/m2 respectively. Estimate the consolidation settlement in cm if the coefficient of compressibility 0.002 cm2/N.

A saturated clay layer 4 m thick is located 6 m below GL. The void ratio of the clay is 1.0. When a raft foundation is located at 2 m below GL, the stresses at the top and bottom of the clay layer increased by 150 and 100 kN/m2 respectively. Estimate the consolidation settlement in cm if the coefficient of compressibility 0.002 cm2/N.

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Mat Foundations

Section: Chapter Questions

Problem 10.7P

See similar textbooks

Similar questions

Knowing that the compression index, Cc = 0.333, and the preconsolidation pressure s’c = 140 kPa with an initial void ratio e0 = 0.85 for a H = 3 m thick clay layer which is subjected to a new loading for an embankment resulting in a stress increase to 200 kPa; what is the expected consolidation settlement? Provide answer below in meters (m).
The soil profile at a site consists of 10 m of gravelly sand underlain by a soft clay layer. The water table lies 1 m below the ground level. The moist and saturated unit weights of the gravelly sand are 17.0 kN/m3 and 20.0 kN/m3, respectively. Due to some ongoing construction work, it is proposed to lower the water table to 3 m below the ground level. What will be the change in the effective stress on top of the soft clay layer?
The soil profile at a site consists of 10 m of gravelly sand underlain by a soft clay layer. The water table lies 1 m below the ground level. The moist and saturated unit weights of the gravelly sand are 17.0 kN/m3 and 20.0 kN/m3, respectively. Due to some ongoing construction work, it is proposed to lower the water table to 3 m below the ground level. What will be the change in the effective stress on top of the soft clay layer?
A 5.1 m thick clay soil with a current overburden pressure of 89 kPa is going to experience an additional stress of 89 kPa after a new structure is built. If it was determined that the clay is normally consolidated has an initial void ratio of 1.2, a recompression index of 0.07, and a compression index of 0.47. Determine the total amount of settlement that is expected to occur. Provide your answer in meters to 3 decimal places.
For a normally consolidated clay layer, given:Thickness = 3.7 mVoid ratio = 0.82Liquid limit = 42Average effective stress on the clay layer 5 110 kN/m2 How much consolidation settlement would the clay undergo if the average effective stress on the clay layer is increased to 155 kN/m2 as the result of the construction of a foundation?
2.An oil storage tank 35 m in diameter is located 2 m below the surface of a deposit of clay 32 m thick, the water table being at the surface: the net foundation pressure is 105 kN/m2. A firm stratum underlies the clay. The average value of mv for the clay is 0.14 m^2/MN and that of pore pressure coefficient A is 0.65. The undrained value of Young’s modulus is estimated to be 40 MN/m^2 Determine the total settlement under the centre of the tank.
A stratum of clay is 2m thick and has an initial vertical effective stress of 50 KN/m2. The foundation load caused an increased pressure of 40 KN/m2 at the mid-layer of clay. Consolidation test revealed the following results: overconsolidation ratio (OCR) = 1.5 Compression index = 0.25 Recompression index = 0.05 Secondary compression index = 0.02 Initial void ratio = 0.90 Determine the following a. the primary consolidation settlement of the clay layer (in mm). b. If the primary consolidation settlement took 2 years to achieve in the field, calculate the secondary consolidation settlement after a period of 5 years (in mm). c. the preconsolidation pressure (in KPa. Note: Kindly give all right solutions with clear calculations.
A sediment settling lagoon has a depth of water of 4 m above the clay base. The clay layer is 3 m thick and this overlies 4 m of medium sand, which in turn overlies impermeable rock. Given the unit weight of clay, medium sand and sediment of silty fine sand is 18 kN/m², 20 kN/m³ and 16 kN/m², respectively. Calculate the effective stress at the top of the clay and at the top and bottom of the second layer under the following condition; i) initial, before any sediment is deposited. ii) After a 2m layer of sediment of silty fine sand has been deposited. iii) After draining the lagoon down to base level, with the same thickness (2m) of sediment still in place
A 12 m thick layer of Lynchburg clay is doubly drained. The coefficient of consolidation Cv = 8 x 10-8 m2/s. Find the degree of consolidation for the clay 5 years after loading at depth of 3, 6, 9, and 12 m. For the same soil, if a structure applied an average vertical stress increase of 100 kPa, estimate the excess pore-water pressure remaining in the clay after 5 years at the depths indicated above.
A uniform loading of 150kPa is applied at a 28 m Χ 28 m area. Please calculate the consolidation settlement of the clay layer used the middle of the clay layer to estimate the stress increment with the influence factor method). Cc = 0.4, Cs = 0.04, preconsolidation stress is 150 kPa and unit weight of water is 10 kN/m3. What is the settlement at the corner and center of the loading? What is the differential settlement between the corner and the center?
A 2-meter clay layer (e = 0.88, Gs = 2.67, Cc = 0.305) is overlain with 4-meter-thick sand layer (e = 0.82, G = 2.72). The water table is at the interface of the sand and clay layer. If a 2-meter-thick land fill (γ = 17.97 kN/m3) is placed over the existing ground surface, compute the consolidation settlement (in mm.) of the clay layer. Hint: Use the land fill's resulting pressure on the ground surface as the stress increase. Round off to two decimal places. Selected Answer: 60.25
A 2-meter clay layer (e = 0.88, Gs = 2.67, Cc = 0.305) is overlain with 4-meter-thick sand layer (e = 0.82, G = 2.72). The water table is at the interface of the sand and clay layer. If a 2-meter-thick land fill (γ = 17.97 kN/m3) is placed over the existing ground surface, compute the consolidation settlement (in mm.) of the clay layer. Hint: Use the land fill's resulting pressure on the ground surface as the stress increase. Round off to two decimal places.