A saucepan 30 cm in diameter is placed on the stove. The pot is made of stainless plate (k = 15 W / [m ° C]), and contains boiling water at 98 ° C. The bottom of the pot is 0.8 cm thick. The surface temperature in the bottom of the pan in contact with water is 105 ° C. a. If the heat transfer rate through the bottom of the pan is 550 W, determine the temperature of the outside surface of the pan that is exposed to the heating stove. = Answer ° C. b. Find the convective heat transfer coefficient of boiling water = AnswerW / m2 ° C

Q: 5) A gas with a composition of %30 CO(g), %20 CO2(g) and %50 N2(g), is burnt with dry air (stochiome...

A: Given: Feed gas composition: 30% CO(g), 20% CO2(g), and 50% N2(g) Dry air in stoichiometric amount i...

Q: A nearly flat tire becomes noticeable warmer after it has been pumped up. Approximate this process a...

A:

Q: If a first order irreversible reaction A--B is carried out in two parallel CSTRs (two CSTRs are the ...

A: Two CSTRs are connected in series, the overall conversion for the reaction is, XA=1-1(1+kτ)n...........

Q: Air with a mass flow rate of 600 kg/s is compressed at constant temperature with an initial pressure...

A: (a) It is to be proved that the volume added/lost due to the compression process is 6.465 m3.   As t...

Q: 6. The rate constant for the reaction, I+ I+ Ar → I2 +Ar, is 0.59 x 1016 cm mol-2 s' at 293 K. What ...

A:

Q: 6. During Basic Oxygen Process to manufacture low carbon stainless steel, 600 kg of cast iron (6% of...

A:

Q: please be clear

A: Given, mass flow rate, m = 2 kg/s   At nozzle entry point Pressure, P1 = 3000 kPa Temperature, T1 = ...

Q: 1. An ice skate is able to glide over the ice because the skate blade exerts sufficient pressure on ...

A: Write the expression for Clausius Clapeyron as follows: dPdT = hfgVfg1T Integrate on both sides with...

Q: At atmospheric pressure, liquid water expands upon freezing. Explain what this means for the ice-wat...

A: The phase boundary of liquid and solid water is a line that defines the difference in the two states...

Q: What is the molarity of a solution prepared by dissolving 3.02 grams of NaOH (molar mass 40.0 g mol-...

A: Given:  Mass of NaOH = 3.02 grams. Molar mass of NaOH = 40.0 g mol-1 Number of mole of NaOH  = Mass ...

Q: write about consider a adsorption operation in industry and explain in detail the flow diagram and t...

A: Adsorption is a separation operation in which the solute gets attached to the surface of the solid. ...

Q: During absorption of carbon tetrachloride from a mixture of air-CCl4 by anorganic oil, the gas and l...

A: The overall mass transfer coefficients are to be estimated for the liquid phase and gaseous phase.

Q: Water at 20 ºC is to be pumped through shown in the picture.  The inlet pipe to the pump is 0.06 m i...

A: Length of the discharge line, L­DL = 60 m Length of the commercial steel pipe, LP = 8.5 m   The tota...

Q: Explain what is meant by kerogen and describe the various types of kerogen?

A: Kerogen: It is a solid matter that is found in the sedimentary rocks. Its property is that, it is in...

Q: list factors that affect solubility of gas in a liquid

A: The factors that affects the solubility of any gas in a liquid are to be listed.

Q: Draw qualitative engineering stress-engineering strain curves for a ductile polymer, a ductile metal...

A:

Q: 40. The following reaction forms 15.8 g of Ag(s): 4T 2Ag,0 (s) > 4Ag (s) + O2(g)mnoo guiwolfol oda l...

A: Mass of Ag(s) formed = 15.8 g molecular weight of Ag = 108 g/mol Thus, moles of Ag(s) formed = 15.81...

Q: Calculate the change in entropy experienced by 2 moles of an ideal gas on being heated from a pressu...

A: Given data: Number of moles of ideal gas = 2 mol Initial pressure = 5 atm Initial pressure = 50 0C F...

Q: Fraction of water

A: To Answer whether the fraction of water in the underflow stream of thickener is zero

Q: A moon rock collected by a U.S. Apollo mission is estimated to be 3.50 billion years old by uranium/...

A:

Q: Carbon monoxide and 100% excess water are reacted to form hydrogen and carbondioxide. The heat loss ...

A: Basis: 1 gmol of Carbon monoxide (CO) entering the reactor. The reaction is as follows: CO(g) + H2O ...

Q: A binary mixture consisting of benzene and toluene containing 60 mol% of benzene is continuously fed...

A: Given: xF = 60 mol% of benzene Actual number of plates = 9  xD = 98 mol% of benzene  xW = 2 mol% of ...

Q: Write generally about Air quality inside a room?

A: Air quality index inside the room is the measure of how polluted the air inside the room is. The hig...

Q: Pin fins are provided to increase the heat transfer rate from a hot surface. Two arrangements are av...

A: Hi and thanks for the question. Since you have not mentioned whether the pin fin is insulted or conv...

Q: Poorly treated municipal wastewater is discharged directly into a lake. The discharge from the waste...

A: Write the mass balance equation for pollutant at steady state as follows: rate of mass in =rate of  ...

Q: Define (a) fiber, (b) staple , (c) denier, and (d) tenacity

A: (a) Fiber is a carbohydrate which is available in vegetables and food grains. Other name for fiber i...

Q: The first synthesis of chlorine gas was achieved in 1774 by oxidizing NaCl(aq) and H2SO4(aq) with so...

A: Given that  mass of MnO2=0.5 Kg molecular mass of MnO2=87 Kg calculate the moles of MnO2 as follow m...

Q: Ammonia diffuses through Nitrogen gas under equimolal counter diffusion at a total pressure of 1.013...

A: Given data: Total pressure=1.013×105Pa Temperature =298K Diffusion path=0.15m Diffusivity=2.3×10-5m2...

Q: Q1) A single effect evaporator is feed with 50000 kg/h of the dilute liquor containing 25 % NaOH by ...

A: here V is mass flow rate of water vapour and P is mass flow rate of concentrated liquid

Q: Vapor pressure for n-hexane (C6 H14) and n-pentane (C7 H16) may be calculated from the Antoine’s equ...

A:

Q: Flow diagram for absorption

A: Absorption is a separation operation in which the solute from gas mixture is absorbed with the help ...

Q: You want to prepare 1.00 L of a buffer solution with a pH of 3.5.  You are given an 0.45 M solution ...

A:

Q: If a gas sample has a volume of 2.20 L at a pressure of 700 torr, its volume at 800 torr would be __...

A: The volume of the gas sample  at 800 torrs is to be calculated.

Q: The reaction rate equation of A was found as "–rA = 0.005 CA2 [mol / cm3 min]". According to this,a)...

A: Given that, Reaction rate equation of A: -rA = 0.005 CA2 Units of reaction rate = molcm3min

Q: Which function(s) listed are reasonably likely for a protein if it is globular and dissolved in the ...

A: Role of Globular Protein in Blood System in human body..

Q: Combining aqueous solutions of BaI2 and Na2SO4 affords a precipitate of BaSO4. Which ions are specta...

A:

Q: A food ingredient is prepared using a mix of cacao and sugar in a mug of water.  Direct steam inject...

A: Given, mass of the mixture is, m = 200 g specific heat of mixture is, Cp = 3.8 kJ/kg °C Initial temp...

Q: A slurry containing 25% by weight of solids is fed into a filter. The filter cake contains 90% soli...

A: Given data: Slurry contains 25% by weight of solids. The filter cake contains 90% solids and filtrat...

Q: A voltaic cell is made by placing a zinc electrode in a compartment in which the Zn2+  concentration...

A: Given data: Zn2+ concentration=2×10-5MH+ concentration=3.4MPH2=1 atmZn2+/Zn half cell reduction pote...

Q: which one of the following multiple choice is correct? Consider the following electrochemical cell a...

A: Nernst equation is the most important relationship in electrochemistry, it is written as Ecell=Ecell...

Q: 3.30 mol of an ideal gas with CV,m=3R/2 is compressed adiabatically and reversibly from the initial ...

A:

Q: "A mixture of liquid and gaseous air is not a pure substance" Why?

A: A mixture components are said to pure substances if the following conditions are satisfied. 1) Homog...

Q: A method which is used to prepare pure water is A)distillation B)filtration C)deionization D)chlori...

A: The method used to prepare pure water is to be identified.

Q: A 1.30−g sample of water is injected into an evacuated 3.00−L flask at 65.0 °C. What percentage of w...

A: Given data: Mass of water sample=1.3g volume of water vapor=3L Volume of liquid water is negligible....

Q: Give common name for the following compounds

A:

Q: A 0.2-m3 rigid tank equipped with a pressure regulator contains steam at 2  MPa and 300 °C, the stea...

A: Given that  volume of the tank[v1 ]=0.2 m3 initial condition of air pressure[p]=2 Mpa temperature[T]...

Units and Dimensions

Dimensions are the basic concepts of the measurement of quantities. Units are the means of expressing the dimensions. For instance, an area has a dimension of L2 and a unit of m2.