A series circuit consists of a 0.5 µF capacitor, a coil of inductance 0.32 H and resistance inductive resistor. Calculate the value of the resonant frequency of the circuit. When the circuit is connected to a 30 V a.c. supply at this resonant frequency, determine: (a) the voltage across each of the three components; b) the current flowing in the circuit; (c) the active power absorbed by the circuit.

A series circuit consists of a 0.5 µF capacitor, a coil of inductance 0.32 H and resistance inductive resistor. Calculate the value of the resonant frequency of the circuit. When the circuit is connected to a 30 V a.c. supply at this resonant frequency, determine: (a) the voltage across each of the three components; b) the current flowing in the circuit; (c) the active power absorbed by the circuit.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An impedance coil having a resistance of 30 ohms and a 50 cps inductive reactance of 33.3 ohmsis connected to a 125 volt 60 cps source. A series circuit consisting of a 20 ohm resistor and avariable capacitor is then connected in parallel with the coil. (a) for what values of capacitancewill the circuit be in resonance? (b) calculate the two values of line current for the condition ofresonance.
Samlg dbadi If the system gain K>1, this means K shifts the magnitude plot of IGHI by a distance of *20 LogKindB to the right hand side O downwards O upwards O No of the above answer O
A circuit comprises of a coil (resistance of 20W, inductance of 400mH), and a capacitor of 2.0mF connected in series. A supply of 100V at 50 Hz is connected across the circuit. (i) Calculate the circuit: Impedance Phase angle Resonant frequency Q-factor Bandwidth (ii) How do each of the parameters in c., d., e., change if the coil is connected in parallel with the capacitor across the same supply? (iii)Explain what is happening to both parallel and series connections of the above circuit at resonant frequency and critically analyse the effects on circuit currents, voltages and components at resonance.
An impedance coil having a resistance of 25 ohms and an inductance of 20mh is connected in parallel with a variable capacitor. (a) For what value of C will the circuit be resonant if a 90-volt 400-cycle source is applied? (b) What will be the line current under this condition?
A circuit consisting of a coil of resistance 12 ohms and inductance 0.15 H in series with a capacitor of 12 micro Farad is connected to a variable frequency supply which has a constant voltage of 24 Volts. Calculate (a) the resonant frequency (b) the current in the circuit at resonance (c) the voltage across the capacitor and the coil at resonance. draw circuit diagram
A 15.9 uF capacitor and a 15.1 mH inductor are connected in parallel. In series with these units are a variable resistor R and an adjustable reactive device X, joined in series. (a) Determine the kind and size of device X (inductance in Henrys or capacitance in uF) when the circuit is connected to a 50 volt 200 cps source and is adjusted to resonance. (b) For the resonant condition, calculate the value of R if the voltage drop across the paralleled units is to be 100 volts -write legibly and show complete solution
A 15.9 uF capacitor and a 15.1 mH inductor are connected in parallel. In series with these units are a variable resistor R and an adjustable reactive device X, joined in series. (a) Determine the kind and size of device X (inductance in Henrys or capacitance in uF) when the circuit is connected to a 50 volt 200 cps source and is adjusted to resonance. (b) For the resonant condition, calculate the value of R if the voltage drop across the paralleled units is to be 100 volts
3. A series circuit consists of a 30-ohm resistor. a 0.104-henrv inductor, and a 40-microFarad capacitor. If a vanable frequencv I2U-volt source is connected across its terminals, (a) calculate the resonant frequency. fOr the condition of resonance, determine (b) the circuit current and power; (C) the voltage drops across the resistor, the inductor, and the capacitor Prepared bv ENGR. JEFFSON S. BALDEMECA
A circuit comprises of a coil (resistance of 20W, inductance of 400mH), and a capacitor of 2.0mF connected in series. A supply of 100V at 50 Hz is connected across the circuit. (i) Calculate the circuit: Impedance Phase angle Resonant frequency Q-factor Bandwidth (ii) How do each of the parameters in c., d., e., change if the coil is connected in parallel with the capacitor across the same supply?
A 15.9 uF capacitor and a 15.1 mH inductor are connected in parallel. In series with these units are a variable resistor R and an adjustable device X, joined in series. (a) Determine the kind and size of device X (inductance in Henry or capacitance in Farad) when the circuit is connected to a 50 volt 400 cps source and is adjusted to resonance. (b) For the resonant condition, calculate the value of R if the voltage drop across the paralleled units is to be 100 volts.
An impedance coil having a resistance and inductance of 2 ohms and 1.5 mH, respectively, is connected in series with a capacitor. Calculate the value of the capacitance if the circuit will operate at resonance. The voltage source is 220-volts, 4.5 kHz
A coil of resistance 25 Ω and inductance 100 mH is connected in series with acapacitance of 0.12 μF across a 200 V, variable frequency supply. Calculate (a)the resonant frequency, (b) the current at resonance, and (c) the factor bywhich the voltage across the reactance is greater than the supply voltage.