A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage v(t) = 40sinWt, with W= 200 rad/sec. find, (1)    What is impedance of the circuit  (2)    Let the current at any instant in the circuit be I(t) = I0 sin(Фt-F). find I0 (3)    What is the phase Ф

Q: 8) A 230 V fed single quadrant chopper has a 40% duty cycle. A separately excited DC motor is…

A: It is given that: Vs=230 VD=0.4km=0.5 VradsRa=2 ΩN=1400 rpm

Q: Please use laplace/admittance method in solving the problem

A:

Q: Consider the following system, when G(s) = 1 s²+bs+24 R(s) + E(s) O a. 15.1 b. 2.3 c. 99.5 Od. 10.6…

A: Given data : Gs=1s2+bs+24 The settling time ts=1.8sec The overshoot is Mp=37.2%

Q: What is the amount of frequency deviation caused by a limited noise spike that caused an undesired…

A: Given:phase shift : △ϕ=66°modulationg frequency: fi=2.4 KHzCalculation of amount of frequency…

Q: A "T" type thermocouple has linear calibration between 0 "C and 400 °C with voltage at maximum…

A: Given a  "T" type thermocouple has linear calibration between 0 "C and 400 °C with voltage at…

Q: (c) The difference equation describing the input-output relationship of a discrete-time system is =…

A: Given data, Discrete-time system is un+1+3un = 8n,  with uo = 0

Q: Figure 5 shows a self-bias n-channel JFET amplifier construction while Table 1 listed all the…

A: "According to the Company's policy we will solve first three parts of the question". Given the…

Q: find the steady-state response,

A:

Q: 5 Find i for the circuit shown in Fig. 10-19. Ht 0.001 μF 10 cos 10 www 500 Ω Fig. 10-19 See Prob.…

A: Given here a electrical circuit and asked to find the current i in the circuit.

Q: Which component of the HFC is the point of conversion from optical to electrical and vice versa? O…

A: In this questions we need to find at which point in HFC energy convert from optical to electrical.

Q: A circuit has an ac voltage source and a resistor and capacitor connected in series. There is no…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Find out i) Input impedance function and ii) V0(s)/Vin(s) for the network shown in the Fig

A: The input impedance and transfer function of the circuit can be obtained by converting the circuit…

Q: Instruction: Solve the following neatly and completely. 1. Use Nodal analysis to find Vo in the…

A:

Q: 1)Find the skin depth of an electromagnetic wave which is incident from air to a conductor and the…

A: Given data, Electromagnetic wave incident from air to a conductor. f=50 Hzμ=4.55×10-2σ=2.22

Q: ect all that are true    A) A PID controller can always be written as an observer-based controller…

A: PID controller refers to Proportional Integral Controllers. Device used in  in industrial…

Q: What will be the value of after implementing Circular shift right once A1, where A1 is equal 1100…

A: In this questions, we need to provide the circular right shift to the given number A1.

Q: Find the value of the v across 6H 120 cos co V 10 H sm OF -OV

A:

Q: Ifa material is having a band gap of 1.42eV, then this material will produce a photon output at the…

A: Given data : The energy band gap E=1.42eV Velocity of light c=3×108m/sec Planck constant…

Q: Q1:- A 3-phase induction motor has an output a 37KW at this load the stator copper loss and rotor…

A: Output power=37 kW⇒η=outputinput=0.9⇒input=370.9=41.111 kWLosses=input-output=41.111-37=4111 WStator…

Q: 33. For the circuit of Figure 5.72, determine the Thévenin and Norton equivalents that drive the 600…

A: In this question,  We need to determine the Thevenin equivalent and Norton equivalent across the…

Q: The number of turns in the secondary coil of a 22 kVA, 2200V/220V single-phase  transformer is 50.…

A: It is given that:S=22 kVAV1=2200 VV2=220 VN2=50

Q: A core centres = 0.2 m, Height of window = 0.24 m Diameter of circumscribing circle = 0.14 m. The…

A:

Q: Q5:- divide B/A:- • • • A=15m A, B= 800n a A=0.1m A, B= 13n a A=800m A, B= 1000n a • A=13m v , B=…

A: GIVEN:                 A=15mA, B=800nAA=0.1mA, B=13nAA=800mA, B=1000nAA=1mV, B=7000μV FIND: divide…

Q: 24 Lov 22 W Ejzn 1.97 21, tılım m 42

A:

Q: 6.) Find the a.) Find the modulation index of of a system with a 350-MHz carrier that is devi- ated…

A: FM refers to frequency modulation method used for encoding the an information or a data over the…

Q: EXAMPLE To illustrate calculations with the unit impulse function, consider evaluation of the…

A: As per the guidelines of bartleyby I need to answer first three questions only so kindly repost…

Q: Describe the effect of resistive load on sending and receiving end voltages, Power transferred and…

A: Effect of resistive load on sending and receiving end voltages, power transferred and Power factor.…

Q: 16.0V 12 ** 10.0 0.592 7.82 1.5 2 4.0 V 0.22 어디스 2 3 92

A:

Q: Fill-In Questions: 1. A forward-biased 2. A reversed-biased diode has_ diode has resistance.…

A:

Q: Ex. 3) a 3-phase, 50Hz generator running at 1500 rpm, the stator inside diameter is (0.5m) and its…

A: Given data, Frequency (f)=50Hz N=1500rpm D=0.5m L=1.2m Bm=0.62T

Q: 2. A three-phase balanced load has a 10-ohm resistance in each of its phases. The load is supplied…

A:

Q: What is the value of this resistance in ohms of a 4-band resistor with color combinations of…

A:

Q: QUESTION 2 Q2: Find the equivalent resistance of the given network between terminals A and B. All…

A: Given circuit,

Q: Consider an FM signal given by the expression f(t) = cos[2лft + ß₁ sin(2πf₁t) + ß₂ sin(2Ã₂t)]. Find…

A:

Q: 5. Find the current through the diode in the following circuit. Assume the diode to be ideal 10V 50Ω…

A: Given figure,

Q: eln (V -9 ЛИЛ -0.3 -0.2 -0.1 О 0.1 0.2 0.3 0.4 0.5 r(s)

A:

Q: basic D’ Arsonval movement with a full-scale deflection of 66 uA and internal resistance of 480Ω is…

A: In this question , basic Darsonval movement DC voltmeter is given...We have to find out multiplier…

Q: circuit the diodes

A:

Q: Implement the Widrow-hoff learning rule for the set of input training vectors

A: The Given is set of input training vectors is X1=020-1; X2=00.5-0.51;W1=-1-0.500.5 The Constant…

Q: The message signal m(t) as shown in the figure is applied to a phase modulator (with kp as the phase…

A: Given similar carrier frequency is used in both FM and PM modulation   Instantaneous phase in PM…

Q: For the system shown in Figure 1 find the range of values of k for which the system is stable by…

A:

Q: Q2/The positive-sequence reactances for the power system shown in Figure are in per unit on a common…

A: Given: The positive-sequence reactances for the power system shown in the figure are in per unit on…

Q: 1. A three-phase, three-wire CBA system with an effective line voltage of 106.1 V, has a balanced…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: Determine the effective value for the waveform shown

A:

Q: The advantage of the pressure filter is that it can operated continuously. a.True b.False

A: Types of pressure  Horizontal plate filter  Candle filter Nutshell filter  Vertical leaf filter…

Q: If P₁ and P2 be the iron and copper, losses of a transformer on full-load, what is the ratio of P₁…

A: Given, Iron loss, P1 Copper loss, P2 Maximum efficiency occurs at 75% of full load.

Q: Consider the circuit below with i(t) = 2-2 e^(-6t) A [e is the exponential] for t> 0 and i(t) = 0…

A:

Q: Find the total charge of 1 gram of proton

A:

Q: Calculate the full scale deflection current of the meter movement with sensitivity of 4k ohms/ volts…

A:

Q: 16. You have a tuned circuit with a resonant frequency of 3.7 MHz and a quality factor (Q) of 250.…

A: Given: In a tuned circuit, Resonant frequency, fr=3.7 MHz Quality factor, Q=250