A series RLC resonant circuit has an inductance equal to 5 mH, and capacitance equal to 4.7 micoF. Determine the new value of the capacitance needed to double the value of the resonant frequency. (Could you please write out the steps)

A series RLC resonant circuit has an inductance equal to 5 mH, and capacitance equal to 4.7 micoF. Determine the new value of the capacitance needed to double the value of the resonant frequency. (Could you please write out the steps)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 1PA: You are an electrician working in a plant. A series resonant circuit is to be used to produce a high...

See similar textbooks

Related questions

Q: b-Two aluminum and copper wire resistors consume 0.5 W when connected in parallel to 2 V DC supply.…

Q: FE h-off voltage Vpi

A: Given as, VGSoff=-4

Q: es the wattmeter has resistance and resistance halwlate the Percentage error if the Wattmeter is So…

A: When the current coil is connected near to the load then error in power measurement =I2 RC When the…

Q: Write 10 Difference between squirrel cage and slip ring with your own words

A: Squirrel cage and slip ring are the types of induction motor

Q: P 11.9-10 Determine the mesh currents for the circuit shown in Figure P 11.9-10. 100 12 cos 5r V 01…

A: Given, Vs = 12cos5tω = 5 rad/secXL1 =jωL1=j54=j20 ohmXL2 =jωL2 = j56 = j30 ohmXLM=jωM = j53=j15 ohm…

Q: Find the F. T. of the following Signals using differentiation pro. ÎA --- -a a Ans F(W) - 2A b-a…

Q: Consider the amplifier shown. Assume that VdsQ = 2.5V and that the transistor is described as…

Q: semiconductors in electronic circuits

Q: 5V 2 ΚΩ Μ I 7 kΩ Ι', ΚΩ 2 9V

A: Given data : The given circuit is shown below,

Q: Analyse the steady state error of the system ( I correct the question now please solve it )

A: For the given unity negative feedback system we need to calculate steady state error. Note : It is…

Q: AM spectrum consists of a) Carrier frequency b) Upper sideband c) Lower sideband d) Carrier…

Q: In order to show both forms concurrently, both input channels (CH1 and CH2) of the oscilloscope…

A: Oscilloscope is a device which is used to see the different signals like voltage, current etc. In…

Q: A 6 pole generator with wave wound armature has 50 slots each having 20 conductors. The flux per…

A: Given data, A generator has P=6A=2Slots=50Conductors per slot, 20ϕ=0.01 WbE=220 V

Q: Find I1 , I2 , I3 and Ix. show soln. step by step. thank you

A: For the above given question by the help of mesh analysis we need to calculate all the branch…

Q: Discuss the power electronic converters used in wind energy conversion. Also, explain the converter…

A: Basic Components of Wind energy conversion Wind turbine Gear box SCIG / PMSG / WRSG Generator…

Q: By block reduction method, find the transfer function

Q: The resistances of potential transformer winding is minimized by using a thick conductors and small…

A: Answer:a thick conductors and small length of turns

Q: In the circuit shown in Fig. 2, what is R in ohms if X= 40 volts and Y = 30 volts? R 1092 X + 10 V-…

A: Given data, X=40 V, Y=30 V Circuit diagram is given as,

Q: A silicon diode is fabricated by starting with an n-type substrate (Nd = 1016 cm-3), into which…

A: Here,Nd=n= 1016 cm-3Na=p=1018 cm-3Now,np=ni2ni=np=1017 cm-3p=ni eEi-EF/kTEi-EF=kT lnpnikT=26 meV at…

Q: What is the function of mccb and rccb? Disadvantages two required?

A: The main purpose of an MCCB is to provide a way to manually open a circuit or automatically open a…

Q: Draw a qualitative plot of the Voltage Transfer Characteristic of the CMOS inverter. Pleas indicate…

Q: please show the clear equation

A: a)The given transfer function is:Hs=3s+7s2-2s-3therefore,from the above…

Q: In your own words, distinguish between a time invariance system and a time variant system. Determine…

Q: Now, 2 x (+) dt 2 50. d2x(+) dt 2 d2x(1) dt 2 2 is +2 d2x(+) ct 2 +2 = -15(+ + 2) + 25 (1-0) + 15…

A: For the above given expansion in the circle we need to justify how the fourier transform is defined.

Q: b. Analyze how the interpolation process of analog signal to digital signal is done across…

A: We need to analyze how the interpolation process of analog signal to digital signal is done across…

Q: 40V M. 5 R2. 20R3² 12- M 8 R₂ I3

A: Note : In the given question breadboard is practical based which is not possible to implement…

Q: Fill-in Questions: 1. A full-wave rectifier passes both of a sine wave. 2. In terms of polarity, the…

A: Full wave rectification

Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 5gh(3+) - 1+jt ans: F(W) = sw-2πe чпе 6

Q: 4. Find the F. T. of the following Signals using differentiation pro casaw-cosbu W² -b <-2 -a 2 a 2…

Q: A first order system has a delay time of 2.6 sec, find the system time constant. 3.75

A: Given, A first order system has Delay time, td=2.6 s

Q: Two positive point charges, 1 µC and 5 µC are separated by a distance of 3 m. Calculate the…

A: Given data, Q1=1 μCQ2=5 μCr=3 m

Q: Find the F.T. of the fall wing Signals (functions) * (t) = 1 + cos (6πt + T ) ans =F(W) = 25$(w) +T²…

A: Given data : The given function is, Ft=1+cos6πt+π8

Q: Find the E.T. of the following periodic signal. -2 -1 1 2

A: Fourier series is used to analyze the frequency response,Harmonics content and Total Harmonics…

Q: For the circuit shown in Fig. Q3: compute the total impedance in polar form. compute the value of C…

A: It is given that:

Q: 4. Write nodal equations for V1, V2, V3, V4. Do not simplify. 50 Vi ele V3 2H 0. 40 3MCT) 1₂ 0 For…

A: For the above given question we need to write nodal equations for all the nodes.

Q: A series RLC circuit is connected to a 400-hZ line with an applied voltage of 35.678 V. The resistor…

A: An RLC circuit consists of a resistor R, an inductor L, and a capacitor C connected either in series…

Q: Loads, Service, and Overcurrent Protection 12.a. A one-family dwelling has one dryer with a…

A: Given data, 12.a) The nameplate rating is 5500 VA 12.b) The dimension is 25'*70'

Q: 7.35 Find the solution to the differential equation 2dy (1)/dt+ 3y(t) = x(t) if (a) x(t) = 2te, with…

A: Given data : The differential equation is, 2dytdt+3yt=xt, if (a). xt=2te-t with initial condition…

Q: Quiz Determine the value of ix and V. 20/30° V 60Hz 10 (2 ww 14 ΤΗ 0.1 F 0.5 H

A: Given data, Circuit diagram is given as,

Q: Find the transfer function model G(s) = Vo(s) / Vi(s) of a circuit if an input voltage vi(t) is…

A: We need to find out transfer function for given circuit

Q: Question 5 a) Determine the overall operator H of a system whose output signal y[n] is given by…

A: Given data, a). y[n]=20[ x(n+1)+x(n)+x(n-1)] b). x(t) = cosπ3t+cosπ6t+cosπ9t

Q: A negative-sequence Δ-connected three-phase generator feeds a Δ-balanced load. If the load impedance…

A: Given: Ia=(18.43+j12.91) A=(22.5∠35.01°)AZ=(18+j12)Ω In delta connection, line current is 3 times of…

Q: Solve for question iv) and v)

Q: 包 2. Find, graphically, the convolution between xit) and hit) -_-_X(t) = sint tho -, h(t) = S(t) _ S…

Q: What is the inductance that will resonate at a frequency of 20 MHz with a 6.0 pF capacitor? A) 3.8…

A: We need to find out the value of inductance for given frequency

Q: 2 a A LII system has H(W) = 4+jw find the D.E. 6 +5jw-w² -relating the input Xit) and the output…

A: Given a L.T.I system of H(Jw)=4+jw/(6+5jw-w^2) To find the D.E relating input and output, and the…

Q: 7. Space diversity s also known as

A: The solution is provided in the following section.

Q: 2) A solid spherical insulator of the radius of R with positive charge density of pis located at…

A: The given Solid spherical insulator of the radius of R. The Positive charge density of ρ=arcm3 The…

Q: Explain the concept of spread spectrum modulation.

A: We need to explain the concept of sprede spectrum modulation.

Q: If two capacitors having capacitance of 5 µF and 10 µF respectively are connected in series across a…

A: Given, Two capacitors of 5 μF and 10 μF are connected in series across supply voltage 200 V. C1=5…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277 V is connected to the circuit. What is the total circuit current at the resonant frequency?
A series resonant circuit has a resonant frequency of 6.3662 Hz and a bandwidth of 10 rad/sec. If you were the designer, what should be the value of the inductance?
A series RLC circuit consists of a resistance of 430 ohm, inductance of 42 mH and a capacitance of 15.5 micro F. Find: (i) the resonance frequency (ii) Q factor of the circuit at resonance
What is the value of quality factor of a series RLC circuit having capacitance of 0.01 mF, inductance of 1 mH and resistance of 75 ohms ?
A 500 µH inductor, 80/π^2 pF capacitor and a 628 ohm resistor are connected to form a series RLC circuit. Calculate the resonant frequency and Q-factor of this circuit at resonance ? Please answer ASAP
A series circuit consists of a resistance of 4Ω, an inductance of 500mH and a variable capacitance connected across a 100V, 50Hz supply. Calculate the capacitance require to produce a series resonance condition, and the voltages generated across both the inductor and the capacitor at the point of resonance
A capacitance 50microfarad and an inductance of 0.2025 Henry are connected in series. if the resistance of the circuit is negligible find the frequency at which resonance occurs
For each of the driven RLC circuits specified below, do the following:i. Determine resonance properties ω0 , ωL, ωH, B, and Q (ωL and ωH are the low and high half-power frequencies).ii. Determine element values.iii. Produce a frequency responseplot for the impedance magnitude
A series circuit consists of a 120V, 50Hz source, a 30Ω resistor, a 20mH inductance, and a variable capacitance. Find the capacitance required to create a series resonance condition at this frequency.
A circuit consisting of a coil with inductance 10 mH and resistance 20 Ω is connected in series with a capacitor and a generator with an rms voltage of 120 V. Find: (a) the value of the capacitance that will cause the circuit to be in resonance at 15 kHz (b) the current through the coil at resonance (c) the Q of the circuit
A circuit consists of an inductor which has a resistance of 10 Ω and an inductance of 0.3 H, in serieswith a capacitor of 30 μF capacitance. Calculate(a) the impedance of the circuit to currents of 40 Hz (b) the resonant frequency (c) the peakvalue of stored energy in joules when the applied voltage is 200 V at the resonant frequency.Answer: [58.31 Ω; 53 Hz; 120 J]
A coil with resistance of 10 ohms and an inductance of 15 mH is connected in series to the parallel combination of a 20 ohms resistor and a 100 uF capacitor. The circuit is energized by a 120 Vac, variable frequency supply. Derive the formula for resonant frequency and use it to find the resonant frequency.