A silty-sand aquifer has a hydraulic conductivity of 10-4 cm/s. Two piezometers are located 300 m apart and indicate groundwater elevations of 12m and 10m above a datum. The porosity of the aquifer is 0.30. (a) What is the specific discharge in this aquifer? (b) What is the maximum velocity that a salt tracer would move in this aquifer? (c) Assuming that the aquifer is 8 m in depth, what is the discharge per meter perpendicular to the water flow?

A silty-sand aquifer has a hydraulic conductivity of 10-4 cm/s. Two piezometers are located 300 m apart and indicate groundwater elevations of 12m and 10m above a datum. The porosity of the aquifer is 0.30. (a) What is the specific discharge in this aquifer? (b) What is the maximum velocity that a salt tracer would move in this aquifer? (c) Assuming that the aquifer is 8 m in depth, what is the discharge per meter perpendicular to the water flow?

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.14P

See similar textbooks

Similar questions

Tacarigua aquifer in Trinidad is a medium to coarse grained sand aquifer. It is 12.19 thick and 1.61 km wide. This aquifer is covered by a confining unit of Quaternary clay deposit about 13.72 m thick beginning from the land surface. The difference in the hydraulic head between two observation wells 1.524 m apart is 3.05 m. The hydraulic conductivity of the aquifer is 20.44 m/d. What is the quantity of the ground water passing through a cross-section of this aquifer?
An unconfined aquifer is 100 feet thick was evaluated using a field pumping test. The depth to groundwater is 10 feet. At a distance of 1000 feet, the drawdown was 40 feet, and at a distance of 5000 feet it was 20 feet. Find the permeability of the aquifer assuming that a steady-state of 960 gal/minute during the test in ft/sec.
A pump well is dug through a confined aquifer having a thickness of 32 meters. The piezometric surface of the aquifer is 18 meters measured from the top impermeable layer. The first observation well is 75 feet directly west of the pump well and the second observation well is 75 feet directly north of the first observation well. Determine the hydraulic conductivity of the aquifer if it supplies a discharge of 10 liters per second and the drawdown of the observation wells are 13 feet and 23 feet.
In confined or unconfined aquifers water levels in wells are above the top of the aquifer?
A falling-head permeameter containing a silty, fine sand has a falling-head tube diameter of 4.2 cm, a sample diameter of 10.4 cm, and a length of 15.6 cm. The initial head is 15.5 cm. It falls to 1.4 cm over a period of 468 min. Find the hydraulic conductivity.
A confined aquifer has a thickness of 30m (m) and is fully penetrated by well where the aquifer is pumped at the rate of 500 litres per second. The groundwater thickness (H₁) is 50 m. The drawdown measured in two observation wells located at distance of 10 m and 100 m from the well are 7.5 m and 0.5m respectively. Determine the average hydraulic conductivity of the aquifer. At what distance from the well the drawdown is insignificant i.e. is zero (R).
An aquifer has three different formations. Formation A has a thickness of 30 ft and a hydraulic conductivity of 7.0 ft/day. Formation B has a thickness of 15 ft and a conductivity of 78 ft/day. Formation C has a thickness of 22 ft and a conductivity of 17 ft/day. Assume that each individual formation is isotropic with a longitudinal mixing coefficient, DL= 0.1 cm2/day and homogeneous and hydraulic gradient is 1ft/1000 ft. a. If a conservative contaminant is spilled how far would you expect it to travel in each formation before its concentration is exactly ½ of its concentration?
The discharge from a fully penetrating well operating under steady state in a confinedaquifer of 35 m thickness is 2000 lpm. Values of drawdown at two observation wells 12 and 120 m away from the well are 3.0 and 0.30 m respectively. Determine the permeability of the aquifer.
The hydraulic conductivity of an aquifer is 0.002 cm/sec, the hydraulic gradient is 0.004, and the porosity is 0.3. The aquifer is 5 meters thick (b). What it is its transmissivity (T) in cm2 / sec. ? Enter your answer to the nearest tenth.
An confined aquifer has a thickness of 30m. a fully penetrating 20cm diameter well in this aquifer is pumped at a rate of 35 lit/s. the drawdown measured in two observation well located at distance of 10m and 100m from the well are 7.5m and 0.5m respectively. Determine the average hydraulic conductivity of the aquifer. At what distance from the well the drawdown is insignificant?
A aquifer of an medium to coarse grained sand aquifer. It is 12.19 thick and 1.61 km wide. This aquifer is covered by a confining unit of Quaternary clay deposit about 13.72 m thick beginning from the land surface. The difference in the hydraulic head between two observation wells 1.524 m apart is 3.05 m. The hydraulic conductivity of the aquifer is 20.44 m/d. What is the quantity of the ground water passing through a cross-section of this aquifer?
The bottom of a stream consists of silty clay has a coefficient of permeability of 0.06 m/day has an average depth of 2.0 m. The underlying aquifer of fine sand has an average thickness of 20 m. The coefficient of permeability of fine sand is 3 m/day. Determine the coefficient of leakage. Determine the retardation coefficient. Determine the leakage factor.