• A SIMPLE SATURATED REFRIGERATION CYCLE FOR R 12 SYSTEMS OPERATES AT AN EVAPORATING TEMPERATURE OF -10°C AND A CONDESING TEMPERATURE OF 40°C. SHOW THE EFFECT OF SUBCOOLING THE LIQUID FROM 40°C TO 30°C.

• A SIMPLE SATURATED REFRIGERATION CYCLE FOR R 12 SYSTEMS OPERATES AT AN EVAPORATING TEMPERATURE OF -10°C AND A CONDESING TEMPERATURE OF 40°C. SHOW THE EFFECT OF SUBCOOLING THE LIQUID FROM 40°C TO 30°C.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 4RQ: A typical temperature relationship between a high-efficiency condenser and the ambient temperature...

See similar textbooks

Related questions

Q: A particles position is defined by the equation s = 4t2 + 2t + 6 m where t is in seconds. Find the a...

A: Given Time, t = 5 sec Find Acceleration, a Velocity, v

Q: C. Calculate the final equilibrium

A: To find Final equilibrium temperature .

Q: A fireworks show is choreographed to have two shells cross paths at a height of 117 feet and explode...

A: Given:h=117 ftθ=68o

Q: Problem: Figure shows a frame subjected to a load of 3.4 kN, find the resultant stress at A and B.

Q: At the instant shown, bar AB has a constant counterclockwise angular velocity of 4 rad/s. Determine ...

Q: A. Clockwise moments N.M B. Counterclockwise moments N.M C. Net moments about point ( 0) N.M D Net M...

Q: a. Determine the magnitude of P and F (in N) if the y resultant of the five forces shown is 1000 N d...

Q: determine the temperature distribution along the fin surface. The thermal conductivity of the heat f...

Q: ollowing data: • pressure is 101.325 kPa, • temperature is 16°C, and • volume is 2.83 m³ and these a...

Q: Determine the normal force, shear force, and moment at a section through point C. Take P = 8 kN B 0....

A: Given: force applied at the end of the section→P=8 kN

Q: :Q2/c/ the reaction By is

Q: If the mass flow rate of steam is 11 kg/s in steadystate turbine, find the shaft output (W) in kW P1...

A: Steady state energy equation for open system is used to get the solution.

Q: Q5/A/ A runner in a 1000 m race accelerates uniformly for first 400m and then runs at constant veloc...

Q: 3. The 12 mm-diameter rod CE and the 18 mm-diameter rod DF are attached to the rigid bar ABCD as sho...

Q: VA runner in a 1000 m race accelerates uniformly for first 400m and then runs at constant velocity, ...

A: Given data: The initial velocity of the runner is given as u = 0 m/s. Consider the acceleration of ...

Q: Q2/A/The reaction at A is 40N 200 mm 300 mm 20N 300mm 45°

Q: the pressure difference across an air ?

A: Given: Diameter,d=0.004 mSurface tension,σ=0.074 N/mBubble of diameter is immersed in water having s...

Q: 3. If the temperature of a certain amount of gas is held constant, the absolute pressure of gas vari...

Q: Q4/ For the figure below, all dimensions in inch. A/The total Area : * y 1.5 2.5 2.5 2.5 2.5 3.

Q: A 10.0 m long with a cross sectional area 180 mm? copper rod carries a tensile load of 5 kN at 30°C....

A: Given Data L=10 m=104 mm A=180 mm2 P=5 kN T=30°C To=20°C E=117 GPa a=17*10-6

Q: For the figure below, all dimensions in inch. A/The total Area : y 1.5 2.5 2.5 2.5 2.5 3.

A: the Area of a given shaded region is divided into four-part ,two triangle , one rectangle ,and one ...

Q: Pe т Pe P т FIGURE 5-5. A summary plot correlating free energy-temperature diagrams with pressure-te...

A: In thermodynamics a stage graph is an extremely helpful apparatus to researchers. Utilized in numero...

Q: Two bars are used to support a load P. When unloaded, AB is 5 in. long, AC is 8 in long ond the A ho...

A: Given:Length of AB=5 inchlength of AC=8 inchinitial coordinates=0,0Final coordinates=0.25 in, -0.73 ...

Q: 2. Compute for the reactions at both supports.

Q: 9. A solid circular rod that is 600 mm long and 20 mm in diameter is subjected to an axial force of ...

Q: Nylon strips are fused to glass plates. When moderately heated the nylon will become soft while the ...

A: Answer: The average shear strain in nylon due to load P is 0.1974 rad ( 11.3099°).

Q: 5.73 Assume the liquid film in Example 5.9 is horizontal (i.e., 0 = 0°) and that the flow is driven ...

Q: A particle moves along a straight line with a velocity in millimeters per second given by v = 410 - ...

Q: Q3/A For the figure below, the * :.resultant is 20 N 75 N 450 50 N 150 N 259 80 N

Q: 200 mm В

Q: For the figure below, all dimensions in inch. A/[the value of X-bar is

Q: 3 4 6 1 2 4 3 1 5 A= 2 1 -6 4 9 1 -11 -10 15 13 -2 -4 -6 8 11 15 B=-12 3 10 1 4 5 -8 7 3

Q: * :Q4/B/ the value of X-bar is 0.987 1.5 2.5 2.5 O 2.5 0.398 O 2.5 2.5 0.857 0.55 0.254 0.5 0.487 1....

Q: critical damping of the system ?

A: Given: A vibratory system consists of a mass,m=13.5 kgSpring stiffness,k=1355 N/mdamping coefficient...

Q: Q2/A/The reaction at A is * 40N 200 mm B T 300 mm | 20N 300mm A 45° 11.56 N 18.98 N 22.24 N 10.5 N 2...

Q: natural frequency of the system.

A: Given: A mass of 1 kg, m=1 kgAttached to two identical springs each of stiffness; k=25 kN/mUnder fr...

Q: What is the column (small, intermediate or long) if the radius of gyration is greater than the allow...

A: A column is a vertical member which is subjected to axial compressive load and failure of the column...

Q: Find water flow rate at steady state condition in the above pipe for V = 3 m/s, S = 100 cm2, and α ...

Q: A man with a mass of 71.6 kg stands on one foot. His femur has a cross-sectional area of 8.00 cm and...

Q: displacement of the rigid bar. e displacement of the horizontal rigid bar is 0.071 mm downwards, wha...

Q: What would be the analysis of the given table or graph

A: Given Data We have to analyze the graph and data table

Q: . What is the longitudinal stress developed in

A: To find Longitudinal stress

Q: 12. Show that in an isentropic process involving flow in a horizontal flow path, vdP + VdV = 0.

Q: The velocity of a particle moving in the x-y plane is given by (6.00i + 4.94j) m/s at time t = 5.61 ...

Q: 9. A 100-kg wooden box, starting from rest, is pulled across a floor with a constant horizontal forc...

Q: JA/The reaction at A is * 40N 200 mm 300 mm 20N 300mm 45°

Q: this question, assume the "additional displacement" is in the positive u direction. mass weighing 16...

Q: A 60 mm diameter pipe has a discharge of 450 litre/min. At a section the pipe has a sudden expansion...

Q: Magnetic tape is being transferred from reel A to reel B and passes around idler pulleys C and D. At...

Q: 3. Bars AB, CD, and EF each have a cross-sectional area of 25 mm and modulus of elasticity E= 200 GP...

Question

Please solve. Thank you

• A SIMPLE SATURATED REFRIGERATION CYCLE FOR R 12 SYSTEMS
OPERATES AT AN EVAPORATING TEMPERATURE OF -10°C AND A
CONDESING TEMPERATURE OF 40°C. SHOW THE EFFECT OF
SUBCOOLING THE LIQUID FROM 40°C TO 30°C.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Four methods for controlling head pressure in an air-cooled condenser are ______, ______, _______, and
The subcooling temperature in a condenser can be measured by taking the difference between the A. suction pressure converted to temperature and the boiling refrigerant. B. boiling temperature and the condensing temperature. C. condensing temperature and the leaving-refrigerant temperature. D). condensing temperature and the entering-refrigerant temperature.
Define temperature glide, and give examples of where it occurs in a refrigeration system.
Define flash gas, and explain how it applies to the net refrigeration effect of the refrigeration cycle.
Why is two-stage compression popular for extra-low-temperature refrigeration systems?
What are the approximate temperature ranges tor low-, medium-, and high-temperature refrigeration applications?
A typical temperature relationship between a high-efficiency condenser and the ambient temperature is A. 10F. B. 20F. C. 30F. D. 40F.
If 14 gpm of water is flowing through an open-loop heat pump with a temperature difference of 7F, how much heat in Btu/h is being absorbed or rejected in the heat pump? Show all work and units.
Refrigerators currently being manufactured in the United States are using______as their refrigerant.
The condensing pressure is 260 psig and the condenser outlet temperature is 108F for R-22. By how many degrees is the liquid subcooled in the condenser? A. 12F B. 42F C. 7F D. 14F
When a standard-efficiency air-cooled condenser is used, the condensing refrigerant will normally be higher in temperature than the entering air temperature.
A simple saturated refrigerating cycle for R-12 system operates at an evaporating temperature of -5 ⁰C and a condensing temperature of 40⁰C. Show the effects of superheating the suction vapor from -5⁰C to 15⁰C.