A simply supported non-prismatic beam has a total length of 8m. The 4m long middle section of the beam has a flexural rigidity twice the flexural rigidity of the section beside the supports. The beam is acted upon, by a downward concentrated load acting at midspan equal to 20kN. Which of the following gives the slope at a point 2m. to the right of the left support (at the change in cross-section) 20kN 15 18.13 A C EI EI 30 36.56 2m 4m 2m В D EI EI

A simply supported non-prismatic beam has a total length of 8m. The 4m long middle section of the beam has a flexural rigidity twice the flexural rigidity of the section beside the supports. The beam is acted upon, by a downward concentrated load acting at midspan equal to 20kN. Which of the following gives the slope at a point 2m. to the right of the left support (at the change in cross-section) 20kN 15 18.13 A C EI EI 30 36.56 2m 4m 2m В D EI EI

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Define the forces affecting to beam CDB when P = 600 N
If P = 20.3 and M = 6.83, Determine the Shear Force at point B of the Beam shown.
For Beam 3, what is the vertical reaction at B?
A non-prismatic simply supported beam has a total span of 8 meters. The 4-m long middle section of the beam has a moment of inertia twice the moment of inertia of the sections besides the supports. The beam is acted upon by a downward vertical concentrated load at the midspan equal to 10 kN. Neglect the beam wt. Which of the ff. most nearly gives the slope at point 2 meters to the right of the left support.
Two forces act on the screw eye. If F1 = 400 N andF2 = 600 N, determine the angle θ (0° ≤ θ ≤ 180°) betweenthem, so that the resultant force has a magnitude ofFR = 800 N.
what of the 3kn force at the right
For the simply supported beam carrying the concentrated load P = 268 N at its midspan, determine the magnitude of the maximum slope angle of the beam (in degrees) if d = 1.6 m, E = 11.62 GPa , and I =1694446mm4.
For Beam 4, what is the vertical reaction at A?
A uniformly distributed load on beam ABC in Figure P6.9 causes it to sag. To counteract this sag, a cable and post are added beneath the beam. The cable is ten- sioned until the force in the post causes a moment equal in magnitude, but opposite in direction, to the moment in the beam. Determine the forces in the cable and the post, and determine the reactions at A and C.
Determine the magnitude of F so that the resultant couple moment acting on the beam is 1.5 kN.m clockwise ?
Draw the shear and moment curves for each mem- ber of the beam in Figure P5.30. Sketch the deflected shape. The shear connection at B acts as a hinge.
The vertical force F acts downward at A on the twomemberedframe. Determine the magnitudes of the twocomponents of F directed along the axes of AB and AC.Set F = 500 N.