A single mode fibre is to be dimensioned. The normalised frequency is 80 % of the maximum allowed for single mode condition. The relative refractive index difference is 0.005 and the refractive index of the core is 1.5. The wavelength is 1.5 µm. A. Determine the radius of the core. B. If the number of modes supported by this fiber is 5. Determine the radius of the core.

A single mode fibre is to be dimensioned. The normalised frequency is 80 % of the maximum allowed for single mode condition. The relative refractive index difference is 0.005 and the refractive index of the core is 1.5. The wavelength is 1.5 µm. A. Determine the radius of the core. B. If the number of modes supported by this fiber is 5. Determine the radius of the core.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

We have such fiber with length of 4 km and couple light from a single mode laser with center wavelength of 1337.4 nm with FWHM linewidth of 8.7 nm. Please calculate the pulse broadening (in ps) due to material dispersion!
9 What is field pattern in m.)TE mode in rectangular waveguide?n.)TM mode in rectangular waveguide?
QUESTION 3: i. In an optical fiber laboratory experiment the following measurements were observed, the numerical aperture of 0.20 and a cladding refractive index of 1.59. Determine: a. The acceptance angle for the fiber in water. b. The critical angle at the core-cladding interface. Comment on any assumptions made about the fiber ii. Define the normalized frequency for optical fiber and explain its use in the determination of the number of guided modes propagating within a step-index fiber. iii. A step-index fiber in the air has a numerical aperture of 0.16, a core refractive index of1.45, and a core diameter of 60 µm. Determine: a. The number of guided modes propagating in the fiber when the light at a wavelength of 0.9 μm is transmitted.
calculate the ratio of the cross section of a circular waveguide to that of the rectangular waveguide if each is to have the same cut off wavelength for its dominant mode. Note that for standard rectangular waveguide b=a/2
Electrical Engineering 1a.) What electric and magnetic fields correspond to the TM modes of a 1D ideal metallic waveguide? 1b.) What wave equation or wave equations apply to the TM modes? 1c.) How do you describe a TM plane wave bouncing between the two infinite metallic sheets? 1d.) What wave equation are you solving for the TM modes?
What are reflection and transmission coefficients? Derive the formula for the same. When an EM wave travels from a dielectric (medium-1) to the conductor,then what will be the value of these parameters?
Find the velocity of a plane wave in a lossless medium with relative permeability of 5 and relative permittivity of 15.
3. Describe the composite TV signal. 4. Explain the benefit(s) of polarization of the EM wave. Note: Please do not handwritten. Also, answer the two questions.
Using ray theory determine the Maximum acceptance angles ofmeridional and skew rays of an optical fiber cable
Describe the impact of the photoelectric effect on fiber-optic cable transmission.
What are the different factors responsible for the attenuation in optical fibers? What is intermodal and intramodal pulse dispersion?
Show that in a transmission line terminated with a pure positive reactive charge, the magnitude of the reflection coefficient is always one.