A square plate in balance. A square plate with a mass of 16.4 kg is held in balance in the vertical plane by a hinge attached to its right lower corner and by a rope inclined at 30.4 degrees from horizontal fixed at its upper right corner. What is the modulus of the voltage in the rope?

Q: 1. A. Using the Steam Tables, determine the amount of cooling water needed by a condenser in kg/sec…

A:

Q: 40 mm 40 mm 70 mm Y 0 100 mm 85 mm, 30° 900 N 160° 800 N 25° 1000 N 65° X E (120 mm, -40 mm, 80 mm)

A: Given,

Q: Wall Shear Stress and Pressure: The average blood velocity through an internal carotid artery with a…

A: Given data: D=5 mm u=15 cm/s μ=3.5 cp

Q: As shown in figure, a homogeneous 50-kg rigid block is suspended by the three springs whose lower…

A:

Q: A fluid in an aquifer is 6.5 m above reference datum, and the fluid pressure is 1800 N/m2• If the…

A:

Q: Determine the force P required to maintain the 235-kg engine in the position for which 0 = 26°. The…

A:

Q: d. none of the In an air-standard Diesel cycle, the compression ratio is 16, the cylinder bore is…

A: as per guideline i have to answer only three subpart of your question ,please repost remaining.

Q: The sphere with mass m = 25 kg rolls down the inclined plane of angle = 25° without slipping.…

A:

Q: 1. A block of copper at a temperature of 50 °C is placed in contact with a block of aluminum at a…

A: As per Bartleby code of conduct, it is recommended to answer the first three questions of the…

Q: A cylinder contains 0.5 m3of a gas at 1 × 105 N/m2 and 90°C. The gas is compressed to a volume of…

A:

Q: 8. For the sine wave in Figure 11-77, determine the peak, peak-to-peak, rms, and aver- age values.…

A: A sine wave graph is shown in figure below,

Q: At the instant shown, the uniform slender rod with mass m = 32 kg is pin-supported at point O. It is…

A: To find: The angular acceleration of the rod. Given: The mass of the rod is m=32 kg. The moment…

Q: Compute for the moment of the force in line CD.

A: Given: All the length segments of the pipe are: →L=200 mm=0.20 m Angle made by AB from vertical:…

Q: A person is to be released from rest on a swing pulled away from the vertical by an angle of 20.0°.…

A: Given Data: Angle of swing = 20o Rope length of the swing = L = 2.75 m Maximum Tension Tmax = 355 N…

Q: Which R134a table is referring to? My reference as attached. The answer result should be different?

A: Given:Refrigerant=R134aEvaporator temperature, Te=-10oCCondenser temperature, Tc=36oCMass flow rate…

Q: Pressure of a gas changes from 20 to 120psia according to the relation P = aV + b, where a = 5.2…

A:

Q: B 1 m Ө A

A:

Q: The specific weight of the cone and scoop of ice cream are Ycone 10.0 lb/ft³ and Yice cream= 45.0…

A: Givenγcone=10 lb/ft3γice cream=45 lb/ft3

Q: Using R134a as the working fluid and the operating conditions below. Consider the rig without a…

A: Given data, Working fluid is R-134a refrigerant Turbine inlet temperature, T6 = 170 °C Heat exchange…

Q: Consider a flow of SAE 30W oil at 20°C through a 2.4-cm-diameter smooth pipe at 1 million N/h.…

A:

Q: Use Bernoulli's energy balance equation (E = PV + 0.5*mU2), assume volume flow rate remains constant…

A:

Q: 5) If the length /= 1.6 ft, the angle = 24°, the linear velocity of collar A, VA is 3.4 ft/s, and…

A:

Q: The aluminum fuel tank (α = 23.8 x 10-6 m/moC) on a sailboat measures 40 cm by 50 cm by 75 cm. If it…

A: To find: The fuel leak from the tank due to increase in temperature. Given: The thermal expansion…

Q: M G

A: Given system,

Q: Draw a schematic diagram to describe the technology of Compressed Air Energy Storage (CAES) and…

A: Draw the schematic diagram of compressed air energy storage system (CAES).

Q: An ideal vapor-compression refrigeration cycle operates at steady state with Refrigerant 134a as the…

A: given : 134a p₁ = 1 bar (saturated vapour) p₂ = 4 bar (saturated liquid) m = 8.5 kg/min = 8.5/60…

Q: Determine the maximum stress in the beam's cross section. Suppose that M = 90 N·m (Figure 1) Express…

A: Write the given data. M=90 Nmθ=30°

Q: ▶2/211 Abatter hits the baseball A with an initial velocity of vo = 30 m/s directly toward fielder B…

A:

Q: 7 αA A 1B B D -1'p'

A: Given system,

Q: en truss, find the force of m = 60 kN olve this using two methods: (a) Metho

A: Given-Information:- Load 1 = 30 kNLoad 2= 60 kN To-Determine:- Force of member BH As given above…

Q: In a divergent nozzle the flow conditions are subsonic. As the flow progresses the velocity of flow:…

A:

Q: In verse Find Graphical Kinematics method, of the Robot using

A:

Q: R

A: Given system,  R=0.42 m and l = 0.18 m

Q: Is it possible for an item to fail yield but not fail fatek

A: Given question : Is it possible for an item to fail by yielding but not fail by fatigue.   .

Q: 2. A spring with spring constant 90N/m is attached to a 10kg mass with negligible friction.…

A: Given data k=90 N/mm=10 kg Here, k is the spring constant and m is the mass of the block.  Now we…

Q: 15 m -5 m pump 50 m 100 m 4-in. pipe 3. Water at 20°C is pumped from a tank to an elevated tank at…

A:

Q: Consider an ideal refrigeration cycle which use R-134 a as the working fluid. The temperature of the…

A:

Q: fill this table

A: The Failure Modes and Effect analysis i.e. FMEA is the efficient evaluation technique to identify…

Q: Q7. Which statement is TRUE for Figure Q7? A. B. C. D. I. Brittle fracture II. Ductile fracture III.…

A: Given: Which statement is true about given figure.

Q: The plate shown moves in the xy plane. Knowing that ( 165 mm/s, (a), 180 mm/s, and (c)y-55 mm/s,…

A: As per Bartleby code of conduct it is advised to provide solution to first three sub-parts if there…

Q: Why do we require Latitudes and Longitudes? What are the major latitudinal belts? 2. What are Time…

A: Answer 1:- Lines of latitude and longitude are measured in degrees. Longitude lines travel…

Q: Which term(s) in this equation is/are eliminated if Point A is stationary? Which term(s) in this…

A: Given: To find: Terms eliminated if A is stationary Terms eliminated if A rotates with constant…

Q: after the decimal point. Take g = 9.81 m/s². r 0 F

A: Given,

Q: Determine the moment of inertia of the composite section with respect to the Centroidal Axis for the…

A:

Q: Describe in detail elevator hoistways, also list and describe some of the design requirements for…

A: A hoist way is an area enclosed that is used to cover the elevator when it travels from lowest floor…

Q: A. ↑ - LBS %0.08. 60.00 C 37.20⁰ 90.00 || 2.80 0 F MEMBER AB AC BC BD BF CF FD FH DH DE HE HI E EG…

A: Given: The load acting on the truss. Formula used: Summation of forces along x and y direction…

Q: rowing up on a citrus farm in Mpumalanga, Yoliswa always wanted to escape to the city. In her little…

A: Purchasing departments are important to effective supply chain management. In general, procurement…

Q: The 220-N force acting in a vertical plane parallel to the yz-plane is applied to the 110-mm-long…

A:

Q: The Three Gorges Dam in China is the largest hydroelectric power plant in the world. The dam is of…

A: Solution: Given Data: L=2309 mH=186 mh=175 mC=39. km3   To Find:

Q: B 45% 2 m A No slipping α

A: Given system,