A suburb has an area of 2400 square miles and is covered by a cellular system that uses a 12-reuse pattern. Each cell has a radius of 4 miles and the city is allocated 60 MHz of spectrum of full duplex channel bandwidth of 60 kHz. Calculate: The number of cells in the service area. The number of channels per cell.

A suburb has an area of 2400 square miles and is covered by a cellular system that uses a 12-reuse pattern. Each cell has a radius of 4 miles and the city is allocated 60 MHz of spectrum of full duplex channel bandwidth of 60 kHz. Calculate: The number of cells in the service area. The number of channels per cell.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter14: Power Distribution

Section: Chapter Questions

Problem 14.7P

See similar textbooks

Similar questions

Consider a garden house where the radio channel TRT Radyo 4 is constantly open has an installed power of 450 Watt. There will be an average of 10 hours of energy consumption. How many solar panels and batteries are needed?
Band gap between 300-3400 Hertz for voice transmission on telephone lines used in homes and officesis used. ADSL modem devices connected to the telephone line are connected to the 25kHz and 1.1MHz band over this line.data transmission over. For the ADSL device to the telephone device, since it is connected on the same lineThe arrival of meaningful but meaningless signals for the telephone device causes disturbing noises during the conversation.causes to occur.Along with ADSL modems used in homes and workplaces, manufacturers produce a device called Splitter.offers to its users. This device and its circuit diagram are given in Figure 1. device to the home phone line.It is requested that the other end be connected to the telephone device, the ADSL line is directly connected to the telephoneIt is said to be connected to the line as in this example.Figure 1. (a) ADSL Splitter device, (b) A given circuit schematic and connection type for ADSL Splitter.The handset has been measured to have a…
What are the factors that determine which network system to install in a region? Also, what are the factors involved in organizing a network?
9) Why is there a need for matching in telecommunication systems? What is the purpose of matching? (Answer should be brief)
Consider as a simple telephone network consisting of two end workplacesand one intermediate switch with a 1 MHz full duplex trunk between eachend workplace and the intermediate switch. Assume a 4 kHz channel foreach voice call. The telephone is used to make four calls per 8 hour workdayin average, with mean call duration of five minutes. Twelve percent of thecalls are long distance. Analyse and determine the maximum number oftelephones an end workplace can support. Note: Please explain the answer process clearly.
Posted earlier. But, I need immediately help
communication systems and networks...thanks
"A 75-ohm load terminates a 50-ohm transmission line. The point of reflection is at the load. If the measured incident voltage at the point of reflection is 10 Vrms, what is the total voltage at the load? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an integer)."
plz provide answer for this part only describe the distribution system used in the residential sector of Pakistan having at least 5 Km Length and minimum of 300 consumers attached with.
It is not possible to locate electrical equipment in less-hazardous areas, or in nonhazardous locations and thereby reduce the amount of special equipment required. True of false Provide Reference for answer:
Attaching the question image below:Plzz answer.
Please help with the solution to this communication system problem.