a Suppose the transformer of Figure 1 has 500 turns on its primary and 1000 turns on it: secondary. d b O° phase shift (a) Determine its turns ratio. Is it step-up or step-down? (b) If its primary voltage is ep 25 sin wt Volt, what is its secondary voltage?
Q: Please show all work for all parts and circle your answers
A: a) The potential energy stored in the spring equal to initial kinetic energy of the bullet only. The...
Q: The radii of the inner and outer conductors of a coaxial cable of length L are a and b, respectively...
A: The resistance of co-axial cable per unit length R=lnba2πσ Where resistance in length L R=lnba2πσL
Q: A 9 400-N shark is supported by a rope attached to a 4.20-m rod that can pivot at the base. 20.0° 60...
A: Given: Force on shark 9400N Length of rod 4.20m To find: (a) Tension in the cable between the rod an...
Q: 2. A blue cart is initially stationary. A red cart starts out behind the blue cart moving quickly on...
A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...
Q: A pilot performs a vertical maneuver around a circle with a radius R. When the airplane is at the lo...
A: The expression to solve for the net force acting on the plane at the lowest point is as follows: Wap...
Q: Ascorbic acid (vitámin C) is oxidized by iodine according to the equation below: 1 mol ascorbic acid...
A: Given: Iodine solution 10.00 ml Iodine solution of 27.55 ml required to reaction endpoint ascorbic...
Q: Answer parts c-f all one question
A: Newton's Second Law of motion According to tp Newton's Second law of motion, the rate of change of l...
Q: Advanced Physics Question
A: (a) The stiffness constant is k=Fx=15 N1.0×10-2 m=1500 N/m thus, the potential energy stored is, U=1...
Q: What is the uncertainty of an instrument
A: Every measuring instruments contain some uncertainty. this uncertainty is called error. This uncerta...
Q: 1. For a cart rolling down an inclined track, write an expression for the final velocity in terms of...
A: Let height of release is h Since the block is release it's initial velocity u = 0 In rolling motion...
Q: Two long straight wires have currents I0 and I0 as shown. What is the magnitude of the magnetic fiel...
A: Given current in wire at left corner is directed downward below the page and current in wire at righ...
Q: Please solve very soon completely all the parts
A: Given: Newton's Second Law is given as F=ma where F=force,kg m/s2 m=Mass,kg a=acceleration,m/s2 For...
Q: (a) The fishing pole in the figure below makes an angle of 20.0° with the horizontal. What is the to...
A: Given Force = 104 N Length ...
Q: 1)When middle C on a piano (frequency 100 Hz) is struck, it loses half its energy after 2.0 s. a)Wha...
A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...
Q: Please answer in bold
A: Given data: The time period is t=28 h. The radius of the orbit is r=140 km. The width is w=2.0 km. ...
Q: A simple pendulum consists of mass m suspended by a massless string of length f as shown in the figu...
A:
Q: An child jumps on 0.25 m from the edge of the 50.0-kg merry-go-round, which has a 1.50 m radius. a) ...
A: Given: Distance from merry-go-round is d=0.25 m Mass is m=50 kg Radius of merry-go-round is r=1.50m ...
Q: A solenoid inductor is 4.0 cm long and has a cross sectional area of 1.2 cm2. When the current throu...
A: Given: The length of the solenoid L = 4 cm. The cross sectional area of the solenoid A = 1.2 cm2. T...
Q: In an electron microscope, there is an electron gun that contains two charged metallic plates 2.70 c...
A: Given: Distance between two metallic plates is d=2.70cm=0.027m At rest, initial speed is vi=0m/s Fin...
Q: You stand at the top of a deep well. To determine the depth, D, of the well you drop a rock from the...
A: Given:- t = 3.1 sec vs = 336 m/s Distance travelled by sound in upward direction equals the distance...
Q: A uniform solid disk of mass m = 3.07 kg and radius r = 0.200 m rotates about a fixed axis perpendic...
A:
Q: 3- Write the constraint equation in the case of a particle move a long the surface of sphere.
A: When a particle moves on a surface of a sphere it constraints to move at a fixed radial distance equ...
Q: A force acting on a particle is conservative if (a) its work equals the change in the kinetic energy...
A:
Q: A carpenter's square has the shape of an L as shown in the figure below. Locate its center of gravit...
A: From figure A we can observe that the L-shape carpenter square is the combination of two rectangles ...
Q: A long coaxial cable carries a uniform (positive) surface charge density o1 = 5 µC/m². On the inner ...
A: a) Let the total surface charge on the inner wire and on the cylindrical shell be denoted by q1 and ...
Q: Tutorial A radio broadcast left Earth in 1923. How far in light years has it traveled? If there is, ...
A: Given: The year in which the radio broadcast left the Earth is 1923. The average number of stars in ...
Q: A ball is thrown straight down at 1.29 m/s and hits the ground 1.07 seconds later. How many meters d...
A: Given Initial velocity u = 1.29 m/s Time of flight t = 1.07 sec Accelerated = g = 9.8 m/s2
Q: A toy spring launcher is used to launch a 10.5 g object into the air. The spring of the launcher is ...
A:
Q: 1. In an elastic head-on collision, a 0.60 kg cart moving at 5.0 m/s [W] collides with a 0.80 kg car...
A:
Q: Two balls moving toward one another collide head-on. Ball 1, with mass 0.250 kg, is initially moving...
A:
Q: where ?∞ = 1.097 × 10^7 m−1is the Rydberg constant and ? is the atomic number (thenumber of protons ...
A: The ground state energy of hydrogen and other elements are related by for a given Z( atomic number) ...
Q: determine the result of the relation
A: Position and momentum operators in terms of ladder operators: x^=ℏ2mωA+A*p^=mℏω2A-A*
Q: A grating with 410 grooves/mm is used with an incandescent light source. Assume the visible spectrum...
A: Given: The number of lines in a grating is N=410 grooves/mm. The wavelength of violet light is λv=4...
Q: 6.7 Force sensor. A force sensor is made of a strip of steel with cross-sectional area of a = 40 mm ...
A: Given: a=40 mm b=10 mm R0=350Ω ab=40×10-6m2 Elasticity=200 Ga Maximum strain= 3%
Q: Calculate the resultant from the forces given A=300N due west, B= 400N due south and C= 500N 53.13 d...
A: Given, Forces are, A=300 N due west B=400 N due south C=500 N 53.13°N of west In coordinate plane ...
Q: 9
A:
Q: Consider a wire bent into an equilateral triangle that has sides of length 3.0 cm. It lies in the fi...
A: Diagram
Q: A 705 N bear is standing on a metal plank supported by the cable shown in the figure. At the end of ...
A: using the equilibrium conditions
Q: 1- Write the moment of inertia in a tensor form for a rigid body rotate about arbitrary axis
A:
Q: A catfish is spotted at the bottom of a creek. The depth of the water is 2 m. A hunter (with no know...
A: Analyze the figure below, From the figure, the angle of incidence (i) will be given as,
Q: The motorcyclé iš trávéling át s= v=2 m/s when it is at A. If the speed is then increased at s=a=0.2...
A: Given: The answers are shown below: s=2ms a=0.2ms2
![Problem 1:
Suppose the transformer of
Figure 1 has 500 turns on its
primary and 1000 turns on it:
secondary.
(a) Determine its turns ratio.
Is it step-up or step-down?
(b) If its primary voltage is ep
25 sin wt Volt, what is its
secondary voltage?
d
O° phase shift
Figure 1
+](/v2/_next/image?url=https%3A%2F%2Fcontent.bartleby.com%2Fqna-images%2Fquestion%2F8226dfea-a886-4e59-9165-9097980b48be%2F94314714-4e3a-4734-9904-9e17d33be843%2F409w8mp_processed.jpeg&w=3840&q=75)
![](/static/compass_v2/shared-icons/check-mark.png)
Step by step
Solved in 2 steps
![Blurred answer](/static/compass_v2/solution-images/blurred-answer.jpg)